Locate the centroid of the section shown, which was cut from an elliptical cylinder by an oblique plane.

Q: 6,2 and cœntroid of the following Afanes Cross-sectons 2"

A:

Q: The bent rod shown below consists of two straight parts along x and y- axes and a half-circle in…

A: Given diagram:-

Q: Select the sectional view that will be produced by the cutting plane. Р L A A A A q S A 1 t

A:

Q: For the trapezoidal region: a. Find y bar b. Find ixx c. Construct the centroidal axis x’ and then…

A:

Q: Consider the rod shown. Suppose that hℎ = 170 mm, r = 290 mm. Determine the location (x,y)  of the…

A: The Centroid is the center of mass of the section of beam. It is considered as the center point of…

Q: I cut into 3 segment. Area: 4*1= 4 in^2, 4*1= 4 in^2, 10*1= 10 in^2

A: Determine the moment of inertia of the "Z" section with respect to the x and y centroidal axes. Ix =…

Q: A concrete gravity retaining wall has the section shown below: 0.3 m nie p 2.1 m 1.2 m It retains…

A:

Q: 5. Determine the force in each member of the truss by substituting member AB with one placed between…

A:

Q: Determine the location z̅ of the centroid for the tetrahedron.                    Suggestion: Use a…

A: Consider the figure,

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.