Liquefied natural gas, LNG, is to be shipped from the Alaskan Kenai Peninsula by an ocean carrier to processing plant on Yaquina Bay, Oregon. The molar composition of the commercial LNG is LNG composition mol % Mw (g/mol) Methane, CH4 93.5 Ethane, C2H6 4.6 Propane, CSH8 1.2 44 Carbon dioxide, CO2 0.7 44 Determine a) The weight fraction of ethane b) The average molecular weight of the LNG mixture c) The density of the gas mixture when heated to 207 K and at 1.4 x105 Pa

Q: QI/ Ammonia gas (A) is diffusing through stagnant N2 (B) under steady-state conditions. The total…

A: Total pressureP=1.013×10 Pa Temperature T = 298 K  Concentration of ammonia at point 1 = Y1 mole…

Q: A 6.75 g sample of roronite oxide (MM = 115.75 g/mol) was burned in excess oxygen in a…

A:

Q: Calculate of the intensive/extensive fluid properties in the relevant fluid system with clear basis…

A: Basis:- 126.143 Kghr of feed flow Assumptions:  Let Heat of condensation of vapor is equal to…

Q: Q.2: During the ORSAT analysis of the combustion products of an engine running on a diesel cycle…

A:

Q: A chemical engineer is studying the following reaction: H,(9)+Cl,(9) - 2 HCI(9) At the temperature…

A:

Q: A stream that is 40 mole % benzene and the balance toluene is fed to a separator where it is split…

A: A binary mixture is fed to a separator and splits into two streams

Q: the necessary chemical equations for the flash smelting problem

A: The Flash smelting process is an autogenous process. This process involves the melting of material…

Q: Question No. 1: A constant-volume batch reactor is used to get the following data on the…

A: the performance equation for ideal batch reactor is                                         t = Na…

Q: An enrichment distillation tower, its fed with 45 mol% benzene (A) at 101.32 kPa absolute pressure…

A: (a) Flow rate of feed be, F = 100 kmol/hr   Write the overall balance as follows: F = D+W…

Q: Saturated steam-water mixture is split in a knockout drum at a rate of 3040 kg/h. The incoming steam…

A: Saturated steam is splitted in a knockout drum into pure steam and water.

Q: The formula for calculating the experimentally derived specific internal energy at 1 atm for…

A:

Q: 6. (a) Nitrogen gasis made from sodium azide by the following reaction. If 3 mols ofsodium azide is…

A: Given: Nitrogen gas is made from sodium azide by the reaction given below: 2NaN3(s) → 2Na(s) +…

Q: A furnance burns a coal at a rate of 1 kg coal/min with the following composition, (C = 76 wt%, H =…

A: Step 1: Step 2:

Q: Conditions for the bottoms at 229°F and 282 psia from a depro- panizer distillation unit in a…

A: Given in the problem are temperature , pressure , component flow rates Where we have assumed that…

Q: Air is sent to a tank of liquid pentane at a rate of 1 kg/min. The gas stream leaving the tank…

A: Given data: Flow rate of air = 1 kg/min. Composition of pentane gas at exit = 20 wt% or 0.2.…

Q: n-Hexane vapor at 558 °C and pressurel atm is cooled and converted to liquid at 25 °C in a…

A: Given data: Temperature of n-hexane vapor = 558 0C Temperature of liquid n-hexane = 25 0C Pressure =…

Q: During a wintertime inversion, the mixing height of an urban area is 0.143 km and winds are calm.…

A: Given data: Number of vehicles = 8000 Maximum height of urban area = 0.143 km

Q: For example, dilution of caustic lye using water (caustic lye 45% NaOH solution). pure solvent phase…

A: Given that:  Rate ,n = 100 kmol/hT1 = 303 kT2 = 373 kCp = 25.5909 -5.1414 x 10-3 T +11.1829 x 10-6…

Q: 2) Benzene-Toluene Separations. We wish to separate benzene from toluene in a sieve-plate…

A: "Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: QI: The operation of ethyl alcohol (E1OH) distillation is shown in figure below. Calculate the…

A:

Q: Liquefied petroleum gas (LPG) is a mixture of 40% butane (C4H10) and 60% propane (C3H8). During…

A: Given that, The mass of fuel (LPG) gas mf = 1 kg = 1000 g Gas mixture composition is generally…

Q: a) Calculate the energy required to dissociate a kilogram of sodium bicarbonate at 25oC. 2 NaHCO3…

A: To calculate energy required to dissociate a kilogram of sodium bicarbonate at 25o C

Q: A crystallizer is to produce 500 lbs/h of copperas (FESO4 · 7 H20, 277.85) crystals by cooling a…

A: Given, Mass of product formed, P = 500 lbs/hr The molar mass of the product formed is 277.85…

Q: Silicon tetrachloride (SiCI4 ) can be prepared by heating Si in chlorine gas: Si(s) + 2C12(g) ->…

A: Given that  Si  + 2Cl2   → SiCl4mole of  SiCl4  =0.507 mole

Q: In an alcohol production facility, 12000 liters of 95% (v/v) pure ethanol is produced per day. The…

A:

Q: It takes 15 kWh (kilowatt-hours) of electrical energy to produce 1.0 kg aluminum metal from aluminum…

A: NOTE : 1 Watt = 1 J/s and not 51 J/s  And 1 KWh = 3600 KJ

Q: A pipeline is carrying natural gas that contains 85 mol % methane, 10 mol% ethane and 5 mol %…

A: Given data: Temperature = 12 0C Pressure = 10 MPa Volumetric flow rate of natural gas = 0.534 m3/s

Q: 3. Two mixtures are mixed in a mixing unit. First mixture containing 50 wt% benzene and 50 wt%…

A: ⇒first mixture v1=? specific gravity=0.914m1=?xb1=0.5xt1=0.5⇒second mixture,…

Q: Incomplete combustion of hydrocarbons leads to the generation of carbon monoxide rather than carbon…

A: Given Incomplete combustion of hydrocarbons produces toxic carbon monoxide and hence can poison…

Q: A light hydrocarbon gas mixture is stored in a tank at 25C and 9.5 MPa. The gas mixture contains…

A: A mixture of hydrocarbon is given.

Q: One method to remove NOx from diesel exhaust is adding urea (CO(NH2)2) and running the exhaust…

A: To calculate the amount of urea needed to meet the regulatory standard for NOx emissions, we can use…

Q: A sealed cylinder holds 2.4 grams of nitrogen (N2) gas. The temperature is initially -97°C and the…

A: Considered a sealed cylinder holds 2.4 gram of nitrogen gas and heat this gas from RMS speed.…

Q: E P = 51.7kPa T= 81.85°C Steam 110°C condensate Feed (NaOH solution) Thick Liquor, L 44536 kg/hr XL…

A: Where,   F = Feed Flow Rate in kg/hr  L = Flow rate of Liquid in kg/hr  V = Flow rate of Vapour in…

Q: When a hydrocarbon fuel is burned, almost all of the carbon in the fuel burns completely to form CO2…

A: Given, mCO2=0.59 kg/kWh N= 50,000 Power=700kWh/houses/year

Q: Suppose that a tank with a capacity of 24 gallons initially contains 16 gallons of pure water. A…

A: Given data:The amount of water in the tank after t min is : So, the tank will be full when :

Q: How do you calculate the energy absorbed by the bomb calorimeter (qcal)

A: Given: m = 0.9975, M.W = 797.24 g/mol, ∆T = 3.609 0C or K and Cp = 10.31 KJ/K

Q: The reservoir gas has a mixture composition at 200 °F and 2500 psia as tabulated in table 2 below.…

A:

Q: Homework #1 1.18 Nitrogen gas can be injected into oil wells to increase the recovery of crude oil…

A: Part (a)Note: As the table 1.2 and 1.3 was not provided with the question so, conventional symbols…

Q: Determine the emission rate (lb/hr) of HCI (MW= 36.45 g/mol) resulting from the incineration of 760…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Argon (Ar molecular weight is 34.94 g/mole), at 300 K, 1 bar with a mass flow rate of 1 kg/s enters…

A:

Q: NASA has designed a standard rocket engine to use on their new Mars lunar rover. The engine burns…

A:

Q: Fifty moles per second of gas mixture analyzing 0.80 methane, 0.15 ethane, and 0.05 propane enters a…

A: A mixture of hydrocarbon gases is fed to a burner. The exhust gases from the burner are fed to a…

Q: A gas mixture containing 45 percent Argon and 55 percent Hydrogen by volume is delivered at a…

A: Given: Volumetric flow rate of the gas mixture V = 300 m3/h T = 241 K Partial pressure of argon PA =…

Q: 1. A liquid mixture that contains 55 kmol% acetone (CH3COCH3), 23 kmol% acetic acid (CH;COOH), and…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Consider the combination of Fuel Source A and Fuel Source B: 200 kg Fuel Source A (50% S, 3% C, 12%…

A: Two different fuel are given.