line was measured by a 100m tape and found out to be 400m long. It was found out that the first pin was displaced 20cm to the left of the line, the second pin was displaced 40 cm to the right, and the third pin was stuck 30cm to the left of the line. Determine the error in the measurement in cm.

line was measured by a 100m tape and found out to be 400m long. It was found out that the first pin was displaced 20cm to the left of the line, the second pin was displaced 40 cm to the right, and the third pin was stuck 30cm to the left of the line. Determine the error in the measurement in cm.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A line was determined to be 2,682.13 meters when measured with a 20 m. steel tape supported throughout its length under a pull of 4 kg. at a mean temperature of 39 °C. Tape used is of standard length of 19 °C under a pull of 5 kg. Cross- sectional area of the tape is 4.796 mm^2. Determine the TOTAL ERROR of the LINE due to TEMPERATURE in meters. Round off to three decimal places. Input the magnitude only.
Calculate the error (mm) in the linear measurement of offset, if the length of the offset is 80 m, then the accuracy in the measurement of the length is 1 cm in 60 m.
can u help Write a brief conclusion on the answer that you obtain from the above question. Is it liable and okay to obtain this amount of error? Explain your point of view.
FOUR DECIMALS PLACES: PLEASE 100%
A steel tape standardized at 20degree celcius and supported through out under tension of 90N Was found to be 30.377m long. The tape had a cross sectional area of 55mm^2 and a weight of 73g/m. This tape was used supported at the ends only with a constant tension of 78N to measure a line from A to B in nine segments. The data given in the following table were recorded. Apply correction for tape, length,temperature,pull,sag and tape not horizontal to determine the correct length of the line Difference in Elevation Cm) 0-392 Section Meacured Recarded Distance) Tempergrare A-1 15 1- 2 30 15 0.301 2-3 30 16 O.191 3-4 16 0-255 4-5 30 16 0-38 5-6 30 8.636 6-7 0.782 7-6 30 0-825 8-8 25.348 18 0.578 Sum = 265-348 m
Subject: Surveying 1.3 Please show your correct/detailed solution.
Help
The calibrated length of a particular line is 199.998 m. A length of 199.996 m is obtained using an EDM. What is the error in the observation? Identify/Type the formula and then provide the answer result.
2. The surveying professor require his student to measure line CD by pacing. In order for the student to provide an accurate length of line CD, he must know his pace factor. The student measured line AB , 45 meters long and walked through for several trials. The following numbers of steps or paces on line AB and CD are tabulated below. On line AB Trial Counted paces 1 72.50 2 72 71 4 72 71.5 On line CD Trial Counted paces 1 285 2 283 284.5 4 282 283.5 Determine the paced distance of line CD b. Determine the Relative Precision of а. measurement if the taped distance of line CD is 178.05 m. LO