Let xp (t) = 8 cos(2πt) + 6 cos(8át) + 4 cos(22πt) + 6 sin (32πt) + cos(58πt) + sin(66лt) If x₂(t) is sampled at S= 10Hz, discuss about the reconstructed signal of x₂(t)

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(21t) + 3 cos(84πt). Select one: O a. 21 O b. 84 O…

A: Given signal: xt=4sin21πt+3cos84πt

Q: If the fundamental time period of the signal, x(t), given below is 100ms, its first harmonic…

A: nth  harmonic component of frequency is nfo. fo = 1/To  To = fundamental time period of the signal…

Q: le 3/4 (t)= -25 Consider the signal with the following spectrum 1.5e-j/3 -15-10 0 2 j 1.5e3/3 10 15…

A: Given:

Q: D) E) F) Which of the following is g lineHurwiar approximation for cos(x)? 1-x O 1+x X+2 1 Which of…

A:

Q: Q1) for the signal that is shown in the figure below A) plot the amplitude spectrum X(t) 2 A + 2 3

A:

Q: Determine the input of ACS when the sinusoidal output is 1.62 sin (t - 3°) and the closed loop…

A:

Q: The sequence x(n) = 3sin(0.5an) was created by sampling a continuous sinusoid at a sampling rate of…

A:

Q: Required information Consider the signal x(f) where the harmonic function is based on T= To, which…

A: Given:  Brief description: In the given question we have a continuous time domain signal called…

Q: Consider the two signals c₁(t) = 4 cos(50000πt) and c₂(t) = 4 sin(50000πt). The real and the…

A: Given:Real and imaginary parts of the spectrums of the two signals m1(t) and m2(t),Carrier signals…

Q: Determine the Nyquist rate of a

A:

Q: g(t) 200(cos (2t) + sin (3xt) + cos (5xt – *)) Find the fundamental period and fundamental frequency…

A: In this question we will find fundamental time period and fundamental frequency...

Q: Q2: Plot the amplitude and phase spectrum of the following signal: f(t) = e-(4t-2)u(t – 0.5)

A:

Q: Consider the circuit given below.

A: Consider the circuit given belowIf R = 9.00 Ω, determine the frequency at which it has maximum…

Q: Consider the following signal: VIN (t) = 1V+(2V) sin (2лft), for a frequency of f = 10kHz. Describe…

A: Given data Input signal, VINt=1V+2Vsin2πft Frequency, f=10 kHz We need to describe the magnitude…

Q: Consider the following continuous signal x(t). Using a definition of periodicity, determine whether…

A:

Q: If a sinusoidal signal is given as: F(t) = sinat sinbt, where a = 5 Hz and b = 0.9 a Hz. What should…

A: Given a sinusoidal signal f (t) which is given by

Q: Frequency Domain A 5[8(f – 200) + 8(f + 200)] В (5/2) rect(f/2)e-j4nf C 180 sinc(20 f)e¬j8nf D -84…

A:

Q: What is the value of d[0], such that d[n] is the unit impulse function? 0.5 02 the fourier transform…

A:

Q: Q2: Answer three of the following branches: 1. Add (01110101)2 with (00110011)2 in Decimal, Binary…

A:

Q: Question 10: Let r(t) be a periodic signal with fundamental period To. Determine the fundamental…

A:

Q: Which one of the following figures represents the positive frequency spectrum of x.(t)? Note in this…

A:

Q: Given F(s) = (49384)/(( S-89)2 + 24674)), the f(t) would be:

A:

Q: A signal x(t) is differentiated with respect to time to produce a new signal h(t)=dat). If we know…

A:

Q: Consider the signal: x (t) = F {8, 1 Sinc (f 8, 1) · 9, 0 · Sinc (f 9,0)}. Calculate x (0).

A:

Q: i. ii. iii. iv. Suppose that a periodic signal is defined as 2 q(t) = cos(3mt) [ k=-2 j5 k+ Prove…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: The single-sided power spectral density function of the signal: x(t) = 10cos (40nt +) +20sin (70nt…

A: A continuous-time signal is given as:We need to determine its single-sided power spectral density…

Q: = 1+ 2 cos(3t + 1) + b) Draw line spectrum (magnitude and phase of complex exponentials hidden in…

A:

Q: 3. Determine the instantaneous frequency (expressed both in rps and cycles/sec) of the signal x(t)…

A:

Q: obtained from two representations. f(t) = 1+ 5cos2000nt

A:

Q: Determine the discrete time signal in time-domain by using the magnitude and phase responses -10 4…

A:

Q: Determine the fundamental frequency of the given continous-time signal, x(t) in Hz, and then express…

A:

Q: Using MatLab, plot the signal x(t) = 10*cos(800*pi*t + pi/4). Use 5 samples per period and plot 3…

A: According to the question, we need to plot signal x(t) =   by using MatLab.

Q: Find the Nyquist rate and Nyquist interval for the following signals: 1. m(t) = 1…

A: We need to find Nyquist rate for given signal

Q: he amplitude plot rises as the frequency increases from 100 Hz until he is reached O input frequency…

A:

Q: (a) (b) (c) What is the period of the signal cos (t-T/8)? What is the period of the signal sin (t +…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: Given signal a(t) = 8e-0.4t cos(10nt)u(t-2), what is the instantaneous signal power at t = 3? 0.032…

A: We need to find out the instantaneous value of the given signal and we need to find out the energy…

Q: The FT of the signal below is X( t) 1 -1.5 |-2 -0.5 0.5 2 1.5 X((w) = 2jsinc (E) sin(w) B. X(jw) =…

A:

Q: Determine the period of the following DT signal x[n]=cos(πn/6 +10) + sin(πn/8)

A: In this question we need to find a fundamental time period of the given signal.

Q: Find the TF of the next response due to a unit step input.

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: 1.26. Determine whether or not each of the following discrete-time signals is periodic. If the…

A: To determine whether the given discrete-time signal is periodic, we need to check if there exists a…

Q: Determine the Nyquist Sampling Frequency for i. 9,(t) i. 92(t) |G,(f) G(f) ii. gỉ(t) -5000 |0 5000…

A:

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.