Lead in dry river sediment was extracted with 25 wt% HNO3 at incubation temperatures for 1 hr. Then 1 mL of filtered extract was combined with other reagents to a total of 4.60 mL. Pb+2 was measured by an electrochemical method by spiking with 2.50 ppm Pb2+. added vol. of 2.50ppm Pb2 signal 0 mL 1.10 0.025 mL 1.66 .050 mL 2.20 .075 mL 2.81 what is Sx based on Sy

Q: 4. A total of 200 mol/s of a liquid mixture with 40 mol% benzene and 60mol % toluene is fed to a…

A:

Q: Coal fired in a furnace analyzes 16.6% VCM, 16% ash, 61.4% FC, 6% M. 1.2%N and 1.8% S with a…

A:

Q: Methane diffuses from a gas phase onto a catalytic surface where it undergoes the following reaction…

A:

Q: In a coffee cup calorimeter, a student places 0.390 g of calcium, followed by addition of 50.0 mL of…

A: Given that: Mass of calcium, Ca= 0.390 g Molar mass of Ca= 40 g/mol Hence, Moles of Ca= massmolar…

Q: A continuous single-effect evaporator concentrates 9072 kg/h of a 1.0 wt% salt solution entering at…

A: Introduction:- The heat exchanger for boiling the solution and the specific features for separating…

Q: Example 4.2. HNO, and 8 wt% water, by mixing You are asked to make 1,000 kg of the mixed acid…

A:

Q: Calculate the volume of aqueous solution (density = 980 g/L) produced after treating 100 moles of…

A:

Q: An evaporation-crystallization process (as shown below) is used to obtain solid potassium sulfate…

A: Given: Required to find: The production rate of the crystal

Q: Note that if the % carbon and net hydrogen lost in the refuse is around 7%, a. Determine the orsat…

A: The moles of components are calculated by assuming a basis. The loss percent is considered and the…

Q: Solid lead nitrate is slowly added to 75.0 mL of a 0.0624 M ammonium carbonate solution. The…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A liquid mixture of benzene-toluene is to be distilled in a fractionating tower. The feed containing…

A: Introduction:- Distillation is the process of turning a liquid into a vapor, which is then condensed…

Q: Rate constant for the degradation of lycopene pigment in tomato puree heated at 80°C was found as…

A: Hello!! Thank you for asking the questions. You have asked  mixed up questions. The First question…

Q: 1. A 100 kg of 20% aqueous solution of was fed in a diluting stream of pure water to produce a 8%…

A:

Q: Solute S has a distribution constant of 4.1 between water (phase 1) and hexane (phase 2). A 82.0 ml…

A: Given: Between water and hexane solute has Distribution constant k=4.1 Volume of water phase V1= 82…

Q: You have a 1 g sample of an alloy containing Al and Mg dissolved and treated to prevent…

A: Given: Weight of Alloy = 1 g Weight of all precipitates = Al(C9H6NO)3(g)+ Mg(C9H6NO)2(g) = 7.98 g…

Q: Design a countercurrent liquid-liquid extractor to separate acetone from methyl isobutyl ketone…

A: To find:Design a countercurrent liquid-liquid extractor to separate acetone (solute) from methyl…

Q: gas mixture containing 47 mole% A and 53 mole % inert is fed to an absorption tower where it is…

A:

Q: 1. An absorption tower is used to recover benzene from air. The rate of the feed gas is 100kmols/hr.…

A: Rate of inlet feed gas at the bottom, V­b = 100 kmol/h Mole fraction of benzene in unlet gas, yb =…

Q: Hydrogen Sulfide has to be removed from a light refinery hydrocarbon stream before the gas is…

A: Given :The feed gas contains 4.0 mole% H2S.y

Q: A total of 6,000 lb/h of a liquid solution of 40 wt% benzene in naphthalene at 50oC is cooled to…

A: The total flow rate of the liquid solution, ṁF = 6000 lb/h The weight percentage of benzene (C6H6)…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: A substance molecule's retainment onto a solid's surface or liquid's surface is an adsorption…

Q: Coal fired in a furnace analyzes 16.6% CM,16% ash, 61.4% 6% M, 1.2%N and 1.8%S with a calorific…

A: The coal's combustion gives residue and stack gas. The combustion occurs due to air. The combustion…

Q: A continuous fractionation column is to be designed to separate 20000 kg / hr of a mixture of 40%…

A: Continuous fractionation column  Given Data : Feed rate (F) = 20000 Kg/hr Composition of benzene in…

Q: Biochar is believed to be a good absorbent for various contaminants. In an isotherm experiment, a…

A: The Freundlich Adsorption isotherm is given as:  KF is adsorption capacity or constant and n is…

Q: A 0.5 g sub-sample of lake sediment was digested in 10 mL of nitric acid, and then diluted by a…

A: Given data :   Weight of sediment sample = 0.5 gm The volume of HNO₃ used for digestion of sample =…

Q: Given the set of information above, determine the following: A) Number of ideal stages and the…

A: Given Data :   Feed :   F=10000 kg/h,    xF =0.4,   xD=0.97,   xW=0.03 ,   R=3q    feed at bubble…

Q: A stock solution of 70% v/v ethanol was diluted with distilled water to prepare 1L of 21% v/v…

A: Initial concentration=70%v/v Density of ethanol=0.789h.mL Molecular weight of ethanol=46g/mol TO…

Q: 3 days ition in 23.22 The following dissolved-oxygen values were 310-mL BOD bottles: 7.7, 7.9, and…

A: BOD- BOD is a measurement of the quantity of oxygen needed for aerobic bacteria (those bacteria that…

Q: A solvent is evaporating into stagnant air with a constant molar flux of 0.05 mol/m2-s, and at a…

A: (a) 0.01sm​ (b) 0sm​ (c) vair,ave​=0m/s∣vsolvent,ave​=infinityExplanation:Step 1: The molar velocity…

Q: In a paint manufacturing process, two different colored paints are being mixed in an infinitely…

A: Concentration of Paint A = 30%Volumetric flow rate of paint A = 10 Liters/MinuteConcentration of…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A:

Q: An oil sample had its iodine number determined using the pyridinium tribromide method. The sample…

A: Given data: volume of oil sample = 0.21 mL Density of oil sample= 0.927 g/mL Mass of pyridine…

Q: 100. mol/hr of a mixture of hexane (60.0 % by mol) and acetone are fed into a flash drum and…

A: The objective of the question is to determine the total flow rates of both streams exiting the flash…

Q: Design the Absorption system to absorb (HCI + Cl2) gas mixture. Feed Gas: 800 kg/hr of HCI & 900…

A: Absorption system Feed-HCl+Cl2+air Solvent-pure water HCl=800 kg/hr Cl2=900 kg/hr Air=300 kg/hr…

Q: 1.2048 g of impure Na₂CO3 is dissolved and allowed to react with a solution of CaCh. The resulting…

A:

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the…

A: Here it is given that feed having 15 %wt solid and 85  % wt water residue has 13 water by mass

Q: 4. A gas mixture containing 27 mole% A and 73 mole % inert is fed to an absorption tower where it is…

A:

Q: A 0.3600 g rock sample containing an unknown amount of Ca was dissolved in HCI and diluted to 100.0…

A:

Q: ,crystallizer unit ls fed a saturated s0luti0n 0f ir0n sulfate (FeSO4) at 30°C... The unit c00ls the…

A:

Q: The analysis of coal fired in a boiler showed 57.04% C, 30.5% VCM, 1.2% N, 9.7% ash, and 6.3% S. The…

A: Basis feed = 100 kg Coal composition is:        C =  57.04 % = 57.04 kg VCM = 30.5 % = 30.5 kg…

Q: Q6) Aluminum salt is used for chemical precipitation of phosphate from industrial wastewater. The…

A: The amount of alum required to remove phosphorus from the wastewater is calculated as…

Q: 1.62% CO and 0.81% H2. Air is supplied at 27°C, 765 mmHg with 80% RH. Calculate: (a) % VCM lost in…

A:

Q: mixing process

A:

Q: Calculate (a) the rate of evaporation, or the rate of water evaporated at the evaporator, and (b)…

A: The potassium chromate in feed is obtained in kilograms. The water in feed and cake is obtained. The…