L-117.5 EWR Ch-10 Q-11 Instructions In the following scenario, circle whether each hallway is required or not required to have a receptacle installed. Use the diagram shown in figure 10-4 of the EWR book to determine your answers. L 117-EWR-CH 10 Q-11 A Scale: 1/4 in 1 ft B Scale: 1/4 in 1 ft © Scale: 3/8 in. -1 ft B Scale: 1/8 in. - 1 ft Scale: 1/2 in 1 ft Student Name Receptacles Required Required Required Required Required Not required Not required Not required Not required Not required

Q: What color fluorescent lamps recommended for residential installation

A: White color fluorescent lamps recommended for residential installation .

Q: Q3. i) Identify the type of the fault can happen for the situation below. "when a mechanical…

A: Part (i):- When a mechanical excavator cuts quickly through a whole 3- phase overhead line the type…

Q: When installing grounding electrode conductor at services, it's common to use a single large common…

A: Here we discuss about grounding/earthing related concept.

Q: Give the raceway size required for each of the following conductor combinations: 1. Five, 10 AWG,…

A: The raceway size  required for each of the following conductor combination is given as per the…

Q: How does IoT fit into the concept of the "smart grid" in energy distribution

A: We need to explain How  IoT fit into the concept of the smart grid in energy distribution.

Q: Shown below is a DC circuit that contains a number of switches. The resistance of each switch is…

A: We have to rank as per ammeter reading from highest to lowest.     Let we consider,  R= 1 ohm and…

Q: What is the purpose of the NEC®?

A: NEC stands for National Electrical Code. It was developed in 1897.

Q: b. Ground-fault protection c. Service-entrance conductors d. Branch circuits

A: Given: The answer is shown below:

Q: What assumptions can you make regarding the following receptacle wiring? Check all that apply.

A: A split pair is a wiring fault in which two twisted pair wires are linked instead with two wires…

Q: (15) Electrical fires are rated as Class __________ fires. Select one: A. D B. B C. C D. A

A: A fire-class is a system of categorizing fire with regards to the type of material and fuel for…

Q: ladder diagram for three circuits, circuit A is one lampholder and one duplex receptacle controlled…

A: According to the question, we need to design a ladder diagram for three circuits, circuit A is one…

Q: 7- What is the uses of circuit breaker?

A: Step-1-> A circuit breaker is an electrical safety device designed to protect an electrical…

Q: Grounding lighting fixtures. Threre are specific requirements for grounding lighting fixtures. How…

A: The light fixtures may have an external chassis made out of metal. In that case, run a green wire…

Q: What are three variables that must be considered before installing a circuit breaker?

A: To explain: Three variables that must be considered before installing a circuit breaker.

Q: The nec requires that the disconnecting means for central heating equipment other than Fixed…

A: Article 422 of National electric code (NEC) have rules and regulation of using central heating…

Q: Two 36 cell PV modules are connected in series. One is shaded and the other is fully illuminated,…

A:

Thermocouple

A thermocouple is a temperature measurement device. It includes diverse metal wires which are joined collectively to form a joint. At the same time as the junction is hot or cold, a small voltage is generated inside the measuring thermocouple electrical circuit, which corresponds to the temperature.