kт B A 2

Q: If a force of P=25N is applied to the handle of the mechanism, determine the  force the screw exerts…

A:

Q: The shear leg derrick is used to haul the 200-kg net of fish to the dock. Determine the compressive…

A: Solution.jpg

Q: A block placed under the head of the claw hammer as shown greatly facilitates the extraction of the…

A: According to the given dataPulling load =60 lbWe need to findReaction at A

Q: A 300kg counterweight with center of mass at G is mounted on the AB crank rod of the oil pump unit.…

A: Given Data Torque supplied by motor is : M=250 Nm  Mass of the counter weight mounted on crank AB…

Q: The piston C moves vertically between the two smooth walls. If the spring has a stiffness of k = 12…

A: The spring constant, k = 12 lb/inThe spring unstretched when θ = 0°The final angle is: θ = 20°

Q: Problem Statement Based on Problem 6-11 from the textbook. The spring has an unstretched length of…

A:

Q: The 19-lb weight is supported by the cord AC and roller and by a spring. If the spring has an…

A:

Q: 1. the cable is wrapped around the pulley and attached vertically at A. The bearing B only allows…

A: According to the question F=10i-30j-10k N We need to find The tension in the rope

Q: The mass center Gof the 1400-kg rear-engine car is located as shown in the figure. Determine the…

A:

Q: 4/36 Determine the force in member BE of the loaded truss.

A: Here we will use the method of section to calculate the load in member BE

Q: Problem Statement Based on Problem 5-74 from the textbook. The bend rod is supported at A, B, and C…

A:

Q: Consider the following system in static equilibrium. Force vector Facts at a distance" from the pin…

A: (a) Draw the free-body diagram of bar.

Q: Based on Problem 5-87 from the textbook. Both pulleys are fixed to the shaft and as the shaft turns…

A:

Q: 1- Determine the angle 8 for equilibrium and investigate the stability of the mechanism in this…

A: given :spring is unstretched,when mass of block A= m= 40 kgspring stiffness= k= 1.5 kN/m

Q: The ramp is used as passengers board a small commuter airplane. The total mass of the ramp and six…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.