K(s+2) s(s+3)(s+4) Draw the root locus for the system shown below with G(S) = Show all the steps and label the root locus completely. R(s) + E(s) C(s) G(s)

Q: The switch in figure below is in zero state when the step function input is applied. R=152k, L=0.5H,…

A: Ohm's law: This law states that the current is directly proportional to the voltage and inversely…

Q: Determine K, a, and b so that the system with open loop transfer function has a closed loop pole at…

A:

Q: Y(s) a) U(s) 2s+3 s²+5s+4 b) G(s) = 2s+1 s2+7s+9 c) G(s) 5s+10 s++2s³+s²+5s+10

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: 5) Plot the root loci for the system with K G(s) = s(s-0.5) (s²+0.8+10)' H(s) = 1

A: given that open-loop transfer function is    feedback path gain is H(s) = 1 (unity feedback system)…

Q: 1) A truncation error was introduced into the numerical solution because the difference equation…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: find out the stability of the system

A:

Q: Icany, 1). t = 0 4Ω ic E24 V 2 F 2 H

A:

Q: Q.5 A hydraulic actuator block diagram is shown in Figure Q.5a. The system uses a linear variable…

A:

Q: In the following block diagram find the following four transfer functions. C₁(s) R₁(S) R₂ (s)-0 R₁…

A: Given the block Diagram is  where two input  R1 and R2 and two output response is C1 and C2  and…

Q: The block diagram shown is simplified to a nity feedback system whose forward gain is (s). R(s)…

A: Please refer the attached images for the complete answer

Q: (2) Draw a block diagram for the following dyamic model, with X(s) as the output and F(s) and G(s)…

A: To solve above problem, one should know about transfer function of a system. Transfer function of a…

Q: Consider the series RC circuit. The output y(t) is the current through the circuit. "S + R Find the…

A: The given circuit isR=1 Ω.C1=1 F.C2=2 F.Initial capacitor voltages are⇒VC1(0)=2 V.⇒VC2(0)=21 V.y(t)…

Q: find out the stability of the system using pole-zero plot analysis

A:

Q: Q3 Betermine the values of K and a such that the damping factor is 0-6 and a settling time of 1-675…

A:

Q: Convert this to the form convenient for constructing Bode plots. That is, place the denominator…

A:

Q: H-w/ find the transfer function when G₁=5+3 5+9 G₂ = 7, G3 = 2 5² +8 5+25+3 H₁ = 105 + 2 5² +22…

A:

Q: Consider the block diagram with R(s) an unit step input. The response of the output will look like…

A: Given : A closed loop system with open loop transfer function 1/sT And unit step input is applied…

Q: 1. For the given first order system compute a) The time constant T and the system gain k b) The…

A:

Q: The overall transfer function for the system below is

A:

Q: loop transfer function T(s) = C(s) State the nature of the unit step response of the system. R(s) 3…

A:

Q: Draw the state diagram model for the system has the transfer function 16 s4 – 0.3 s³ – 5 s² + 9 s +…

A: Write the expression for the given transfer function and rearrange it.…

Q: Determine whether the system defined by the following transfer functions are stable or not. Use each…

A:

Q: Determine the transfer function C) R(s) R(s) X(s) M1 M2 EXIT Entry R(s) R(s)

A:

Q: Don't use matlab please answer in typing format

A: To sketch the root locus plot for the given open-loop transfer functions, we need to follow these…

Q: 1. GIVEN THE FollONING CLOSED LOOP SYSTEMS REDUCE THE BIOCK DIAGRAN TO A SINGIE TRANS FER FUNCTION…

A: As per guidelines i have answered only one . please ask remaining againthankyou.

Q: Question : Get the transfer function from U(s) to Y(s). Simplify the expression of the transfer…

A: The given block diagram can be reduced by considering the parallel connected block and then the…

Q: Determine the range of gain K for stability (theoretically) R(s) C(s) s +1 K s+5 ² (s + 2)

A:

Q: b) What is a transfer function? c) Consider the closed loop system shown in Figure Q2. Determine the…

A: Solution: b. Transfer function    Transfer function is a mathematical function that theoretically…

Q: b) ) The switch in the circuit has been opened for a long time before closing at t 0. Find, vc(t)…

A: At t=0-,i.e., the steady state before the switch is closed : Here, the current flowing through all…

Q: 3. Simplify the following block diagrams and find equivalent transfer function. R(s) G₁ G₂ S G₁ C(s)

A: Given: The block diagram is,

Q: Plot the step response of the following system Overdamped

A: The given system is shown below:

Q: Draw root-locus for the following system:- K (s+7) KG(s)H(S) = (s+5)(s+2)

A:

Q: 17. The step response of v,(t) of an RC circuit in the Figure 16 below, given that v = 12V, R, = 60,…

A:

Q: Determine whether the system defined by the following transfer functions are stable or not. Use…

A: given It is close loop transfer function (by default)

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: As per Bartleby Policy we can answer only one question at a time. As you have not mentioned so I am…

Q: Which of the following input signal raises as the square of the time from t>2 0? R(s) = 1/s3 R(s) =…

A:

Q: 2 s? + 8s +15 G(s) = 3 S s'+ 7s² +14s + 8 onvert the TF to state equations 1 y = [15 8 1] x, 1 X, +|…

A: In this question we have to make SD for below function as example given above...

Q: 1. For the system in figure below, N(s) G(s) Y(s). R(s) E(s) G2(s) G(s) H(s) Find R(sN=0 Y(s)…

A:

Q: Find the transfer function X(s)/F(s). F(s) + 1 S s²+ 18s +80 1 s² + 12 1 s²-18s +80 1 s²+12s-8 1 s²…

A: In this question we need to find the transfer function of the given block diagram.

Q: Consider the blog diagram in the figure below and find the range of K to keep the system stable. 1…

A: Given data:

Q: transfer function of this diagram? Thank you!

A: In this question,  We need to determine the transfer function of the given system.  We are solving…