Know the load, warping and frictional stresses on a cement concrete pavement slab as 220 N/mm², 300 N/mm² and 10 N/mm² respectively, the critical combination of stresses during summer season is:

Q: What is DALR line?

A: Lapse rate: The rate at which an atmospheric variable that shows the variation of moist adiabatic…

Q: given triangle ABC find side c

A:

Q: D. SKETCH: (Draw the resulting figure based on the data given on a graphing paper. Vertical axis or…

A: Station BS HI FS IFS Elevation (m) BM -1 1.515 101.515     100 0+000       1.520 99.995…

Q: Define density as a material property

A: in this question definition of density  is being asked

Q: The elevation of a point is the vertical distance a. distance from level line b. measured from the…

A: Option C is correct  Mean sea level or any selected datum

Q: Give other methods of determining the horizontal distance between two points.

A:

Q: -3 R3 - 10 10 Find the coordinates of the centroid 3.

A: To determine the coordinates of the centroid of the given object.   The geometry of the given object…

Q: Define earth work

A: The engineering work that is created by moving and/or processing unformed rock or large amounts of…

Q: Write the units used by English systems to specify small areas?

A: Solution: In the English system, areas are basically given in square feet or square yards. For…

Q: Give a brief description: a. Measurement of Horizontal Distances b. Omitted Measurements c.…

A: Any plane which contains horizontal line and perpendicular  to the vertical direction is called as…

Q: Figure 8 60 KN 2.6m 30 KM 40 KN 30 KN

A:

Q: What is PD 1594. Explain

A: Introduction:- PD 1594 (PRESIDENTIAL DECREE No. 1594) Prescribing polices, Guidelines, Rules and…

Q: Q1. Draw the plan and components of the given line diagram. Assume necessary any suitable data. W,…

A:

Q: Consider the commercial steel pipe shown in (Figure 1). Determine the flow of methane at T = 68°F in…

A: Pressure Drop (ΔP) = 5 * 10^(-3) psiLength of the pipe (L) = 2600 ftDiameter of the pipe (D) = 1…

Q: geomorfologie

A: Note: As nothing is mentioned in this problem so, we are assuming that we have to only define this…

Q: Give the coordinates for the following autocad drawing

A: The points are named as below

Q: Determine y for the area shown y 1" 1" in .5" 1" 2" 2" X

A:

Q: What is Finitely loaded area ?

A: Brief concept- The concept of finitely loaded area is related with the stress distribution in the…

Q: midpoint approximation

A: Midpoint Approximation: The midpoint approximation or the midpoint rule is used for calculating the…

Q: Describe about the Taylor Charts.

A: Taylor's stability chart are used for determining the stability of slope of cohesive homogeneous…

Q: 610 mm 813 mm y 1220 mm 660 mm

A: Given Data  volume is given cuboid and right angle triangular prism with x=1220 mm y=813 mm z=660 mm…

Q: Where is the southwest corner of Section 32, T1N, R1E, Humboldt Meridian located? O About 2 miles…

A: The Humboldt meridian in California longitude 124° 07' 10" west from Greenwich, common points the…

Q: why divide x' in 2 in above method?

A: ##Calculation of location of x at such that due to given loading a  Maximum BM occurs ### As ask…

Q: 14.The polar coordinate of a point is (10, 60degrees). Convert to Cartesian coordinates.

A:

Q: How many divisions are on the vernier scale?

A: A vernier scale is a visual representation that uses mechanical approximations to obtain an exact…

Q: Define SLS requirement

A: Solution: A Service level specification basically forms a part of the service level agreement in…

Q: Given the 10m-grid elevations, find the volume, using Grid Method, Simpson 1/3 rules 2n4 Degree) and…

A: The grid corners are plotted on the ground and spot levels are identified by level. Normally the…

Q: Define island bar.

A: Island bar:

Q: نقطتان )2( Shows polygon with the followng :Find the area (x,y) 2 1.8 1.6- 1.4- 1.2 0.8 0.6- 0.4…

A: answer is option a.)   Matlab command window picture is attached below

Q: ex (x+1)² +c

A: Write all numerators above the common denominatorUse  to expand the expression.

Q: If the elevation of BM-A is 975.00', what is the elevation of TBM-1? ENATAL 7.45 BS FS 5.12 6.77 BS…

A:

Q: classification of rivers

A: Classification of Rivers

Q: 2 1 Matrix -1 + 2 Matrix 1 3 -2 4 A. Matrix 2 2 B. Matrix 1 1 C. Matrix -1 D. Matrix 1 5 2.

A: Given:- Two matrices are given:- A = 21-13 B = -1211 To determine:- The value of Matrix 21-13 +…

Q: Convert 36° 19' to decimal degree form.

A: Given data: θ=36∘19'

Q: Describe the structure of the surveyor’s compass.

A: The large surface when undulated the process used for surveying is known as surveyor's compass.

Q: Q1: a-How to draw a perpendicular from point outside of straight line. • b-Complete in all respects…

A: (a) How to draw a perpendicular from straight line: Cross staff is used for setting out the…

Q: Determine centroidal coordinates of the volume. 610 mm 813 mm 1220 mm wu 099

A: Consider the figure,

Q: Define Alidade.

A: Draw the figure.

Q: Earth Crust Definition

A: Earth's crust is the outermost layer on the earth. The volume of the earth's crust is around 1% of…

Q: ISO 55000 is an international standard that provides governance for asset management. True False

A: Answer: True

Crack Detection

Concrete materials are meant for supporting structures, building foundations and they act as several load-bearing structures. Over time, due to environmental conditions, and based on the constituent materials used, concrete materials are subjected to a great degree of distress. Corrosion of the reinforcement bars due to chemical influences, uneven base, earthquake, drying shrinkages, and alkali-aggregate reactions are some of the reasons for concrete distress.