KINDLY OBTAIN THE RIGHT ANSWER AND EXPLAIN Refer to Figure. Given that B =1 m, L = 3 m, and Q = 110 kN, the soil characteristics given in the figure are Cs = 1/5 Cc, Ꝺ’c= 40 kN/m2. Field monitoring indicated that the foundation settlement was 19 mm during the first 12 months. Estimate the average stress increase in the clay layer due to the applied load. Estimate the primary consolidation settlement. What is the degree of consolidation after 12 months? Estimate the coefficient of consolidation for the pressure range. Estimate the settlement in 24 months.

Q: A plan of a foundation 1 m x 2 m is shown in Figure 4-2. a. Estimate the consolidation settlement of…

A: Given DataFoundation dimensions: 1 m×2 m Net stress increase, q0 = 170 kN/m2 Sand layers:Upper sand:…

Q: ». Consolidated undrained triaxial tests are perform remoulded clay with pore pressure measurements.…

A: Compression testing is the standard consolidated undrained test, in which soil specimens are first…

Q: A normally consolidated clay layer 3.38 m. thick has a void ratio of 1.07. Liquid limit is equal to…

A:

Q: A normally consolidated clay layer 5.18 m. thick has a void ratio of 1.08. Liquid limit is equal to…

A: Given data in question  Void ratio Depth Liquid limit Average stress Increase in stress To find out…

Q: Results of a laboratory consolidation test on a 10 meter thick clay indicates t 50 = 12.5 minutes…

A: given data:- thickness of lab sample=3.18 cm time taken by sample to get 50% consolidation=12.5…

Q: Given that B =1 m, L = 3 m, and Q = 110 kN, the soil characteristics given in the figure are Cs =…

A: Given - Given that B =1 m, L = 3 m, and Q = 110 kN, the soil characteristics given in the figure are…

Q: At 140 KPA, the soil's effective normal stage has a void ratio of 0.55. The soil's compression index…

A:

Q: Please provide solution for this consolidation test quest

A: P1 is equal to 50 KpaP2 is equal to 120 Kpae1 is equal to .92e2 is equal to 0.78Time required for…

Q: Estimate the ultimate consolidation settlement under the centerline of a 25 x 25 meter mat…

A:

Q: b. 184 mm c. 25% d. 0.075 m²/yea

A:

Calculation of Settlement

The vertical displacement of the structural foundation due to the loading from the superstructure is known as settlement. It is due to the reduction of air voids present in the soil. The amount of vertical displacement depends on the bearing capacity of the soil on which the foundation is laid. The effect of the settlement depends on the magnitude of settlement, uniformity, and the structural design of the structure. The maximum allowable settlement for residential and office buildings should be less than 18 mm, for industrial buildings, it is 38 mm and for commercial buildings, it is 25 mm.