K (J)KS0123Pliq (g/cm³)(8c14p40) A small solid ball is released from rest while fully submergedin a liquid and then its kinetic energy is measured when it has moved 7cm in the liquid. The figure gives the results after many liquids are used.The kinetic energy K is plotted versus the liquid density Pliq, and K =0.012 J sets the scale on the vertical axis. What is the density of theball?Submit Answer Tries 0/12What is the volume of the ball?Submit AnswerTries 0/12

a) An object of the same density as the surrounding liquid is not going to accelerate up or down…

Answered: K (J) K S 0 1 2 3 Pliq (g/cm³)…

Similar questions

Steel ball with radius of 0.09 m lays on a bottom of the lake 5 m deep. What work is needed to lift the ball to the surface of the lake? Density of steel is 7860kg/m3. The volume of a sphere is
A PROBLEMS 6.63, 6.64 6.64 This "double" nozzle discharges water (at 10°C) into the atmosphere at a rate of 0.50 m /s. If the nozzle is lying in a horizontal plane, what x-component of force acting through the flange bolts is required to hold the nozzle in place? Note: As- sume irrotational flow, and assume the water speed in each jet to be the same. Jet A is 10 cm in diameter, jet B is 12 cm in diame- ter, and the pipe is 30 cm in diameter.
² A cylinder is fitted with a piston, beneath which is a spring, as in the drawing. The cylinder is open to the air at the top. Friction is absent. The spring constant of the spring is 4900 N/m. The piston has a negligible mass and a radius of 0.034 m. (a) When the air beneath the piston is completely pumped out, how much does the atmospheric pressure cause the spring to compress? (b) How much work does the atmospheric pressure do in compressing the spring? (a) Numberi (b) Number i Units Units
#69, bottom question...please help!
I Review I Constants I Periodic Ta Water flowing through a 2.5-cm-diameter pipe can fill a 200 L bathtub in 3.3 min . ▼ Part A What is the speed of the water in the pipe? Express your answer in meters per second. ? V = m/s Submit Request Answer
The spring of the pressure gauge shown in the figure below has a force constant of 1 350 N/m, and the piston has a diameter of 1.40 cm. As the gauge is lowered into water in a lake, what change in depth causes the piston to move in by 0.700 cm? 4.635 X Your response differs from the correct answer by more than 10%. Double check your calculations. m Vacuum
A house weighs 12,000 pounds. a. Air normally has a density of 1.29 kg/m^3 but at 250 degrees air has a density of 0.9 kg/m^3. What volume of hot air balloon is needed to float this house off the ground? b. At standard temperature and pressure Helium has a density of 0.16 kg/m^3. How many 30 cm diameter helium balloons will it take to float the house?
A chemistry graduate student is designing a pressure vessel for an experiment. The vessel will contain gases at pressures up to 150.0 MPa. The student's design calls for an observation port on the side of the vessel (see diagram below). The bolts that hold the cover of this port onto the vessel can safely withstand a force of 2.80 MN. W 0 -pressure vessel cm bolts port Calculate the maximum safe diameter w of the port. Round your answer to the nearest 0.1 cm. zide TO 0.P d 220
A cube of some unknown substance is held submerged in water. The cube has a mass of 0.540 kg and a volume of 0.000770 .What is the acceleration of the cube when it is released?
Blood is flowing through an artery of radius 2.3 mm at a speed of 35 cm/s. a. Determine the flow rate through the artery, in cubic centimeters per second. b. Determine the volume, in cubic centimeters, that passes through the artery in a period of 30.0 s.
A child is playing with a 0.5 kg ball in the swimming pool. The ball is made of a stiff rubber and has a radius of .25 m. Assume the volume of the ball does not change when held under water. What downward force must the child exert on the ball to hold it in equilibrium just below the surface of the water? a. b. How does this answer change if the child was holding the ball near the bottom of the pool (1.5 m down)?