Josh has just raised a 2.5 kg bucket of water using a well’s winch when he accidentally lets go of the handle. The winch consists of a rope wrapped around a 3.0 kg, 4.0-cm-diameter cylinder, which rotates on an axle through the center. The bucket is released from rest 4.0 m above the water level of the well. How long does it take to reach the water?

Josh has just raised a 2.5 kg bucket of water using a well’s winch when he accidentally lets go of the handle. The winch consists of a rope wrapped around a 3.0 kg, 4.0-cm-diameter cylinder, which rotates on an axle through the center. The bucket is released from rest 4.0 m above the water level of the well. How long does it take to reach the water?

Similar questions

A large pipe with a radius of 50 cm has oil flowing through in at 1.5 m/s. The pipe narrows into a narrower tube with a raduis of 10 cm. what is the speed of the oil flowing through the smaller pipe? 1. 0.375 m/s 2. 3.75 m/s 3. 37.5m/s 4. 0.25 m/s 5. none
The density of ice is 917 kg/m3, and the density of sea water is 1025 kg/m3. A swimming polar bear climbs onto a piece of floating ice that has a volume of 6.29 m3. (a) What is the weight of the heaviest bear that the ice can support without sinking completely beneath the water? To verify her suspicion that a rock specimen is hollow, a geologist weighs the specimen in air and in water. She finds that the specimen weighs twice as much in air as it does in water. The density of the solid part of the specimen is 5.42 × 103 kg/m3. (b) What fraction of the specimen’s apparent volume is solid?
The following container is spun with an angular velocity of 12 rad/s after being 45% filled with water. Determine the pressure that would be at the base of the container at the most outer diameter if it has a diameter of 250mm, a height of 200mm and the container is sealed. Ø250mm Ø200mm P= ?
Water leaks from a hole in a water tank which is a 17.66 meters below the surface of the water which is 3.83 meters deep.The velocity of the water just leaving the hole is
The towers holding small wind turbines are often raised and lowered for easy servicing of the turbine. Shown is a 1000 kg wind turbine mounted on the end of a 24-m-long, 700 kg tower that connects to a support column at a pivot. A piston connected 3.0 m from the pivot applies the force needed to raise or lower the tower. At the instant shown, the wind turbine is being raised at a very slow, constant speed. What magnitude force is the piston applying?
A fuel pump sends gasoline from a car's fuel tank to the engine at a rate of 7.06x10-2 kg/s. The density of the gasoline is 730 kg/m3, and the radius of the fuel line is 2.20x10-3 m. What is the speed at which gasoline moves through the fuel line?
A 1400 m wide dam holds back a lake h= 97 m deep. (Figure 1) Figure Part A What is the moment that the water exerts about the bottom edge of the dam (point P)? Express your answer in newton-metres. Π ΑΣΦ A ? M= 1 of 1 N-m
#8
The density of ice is 917 kg/m3, and the density of sea water is 1025 kg/m3. A swimming polar bear climbs onto a piece of floating ice that has a volume of 4.65 m3. What is the weight of the heaviest bear that the ice can support without sinking completely beneath the water?
A uniform disk of mass 10.0 kg and radius of 0.248 m spins at 302 rev/min on a low-friction axle. It must be brought to a stop in 1.00 min by a brake pad that makes contact with the disk at an average distance of 0.218 m from the axis. The coefficient of friction between the pad and the disk is 0.499. A piston in a cylinder of diameter 5.00 cm presses the brake pad against the disk. Find the pressure required for the brake fluid in the cylinder. Pa Need Help? Read It