John Acorn- Friday Fliers. Six, 8-foot (2.44 m) long aluminum “paper airplane” forms are placed throughout campus. This artwork symbolizes the potential of what can be discovered if childish curiosity and enthusiasm are maintained. These sculptures weigh approximately 400 kg each with the center of mass weight being located 1.62 m from the pointed end of the Flier. This Flier is supported at points 0.50 m from each end. Assuming that the pointed end of Flier is directed left, determine the force on the left support and the force on the right support.

John Acorn- Friday Fliers. Six, 8-foot (2.44 m) long aluminum “paper airplane” forms are placed throughout campus. This artwork symbolizes the potential of what can be discovered if childish curiosity and enthusiasm are maintained. These sculptures weigh approximately 400 kg each with the center of mass weight being located 1.62 m from the pointed end of the Flier. This Flier is supported at points 0.50 m from each end. Assuming that the pointed end of Flier is directed left, determine the force on the left support and the force on the right support.

Similar questions

To get up on the roof, a person (mass 62.0 kg) places a 6.80 m aluminum ladder (mass 11.0 kg) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The top of the ladder rests against a plastic rain gutter, which we can assume to be frictionless. The center of mass of the ladder is 2.00 m from the base, as measured along the ladder. The person is standing on the ladder 3.00 m from the base, as measured along the ladder. Find the normal reaction and friction forces (in N) on the ladder at its base. (Enter the magnitudes.) normal reaction force friction force
I need help on question 8.1?
A flagpole has a uniform mass density and total mass of M and length L. It is hinged at the ground and makes an angle of U with respect to the horizontal, as shown. To support the pole, a horizontal cable is attached to the pole at a point L from the bottom of the pole. 3 What is the correct sum of torque equation for the axis perpendicular to the page and passing through the bottom of the pole? cable 2L/3 0-Mg + 흙LT=0 O-Mgcos0 +LTsin0 = 0 ○ 들Mgsind + 능TCOS6) +Tcose = 0 Mgsino + LTcos0 = 0 O- Mgsin0+LTcos0 = 0
The meterstick shown is 100 cm long. It is free to pivot around its center of gravity (CG), which is at the 50 cm mark. There is a 25.0 N block hanging from the 80 cm mark. Decide where each of the other blocks should be placed, one at a time, to balance out the 25.0 N block.
Three children are trying to balance on a seesaw, which consists of a fulcrum rock, acting as a pivot at the center, and a very light board 3.4 m long (Figure 1). Two playmates are already on either end. Boy A has a mass of 45 kg, and boy B a mass of 35 kg. ▼ Part A Where should girl C, whose mass is 25 kg, place herself so as to balance the seesaw? Express your answer to two significant figures and include the appropriate units. for Part A for Part Addo for Part redo for Part A reset for Part A keyboard shortcuts for Part A help for Part A x= Value Units
A uniform, 20-kg, 8.0-m-long, wooden plank that is parallel to level ground is supported by two pivots: one pivot is at the extreme left end of the plank, and the other pivot is 3.0 m inward from the extreme right end of the plank. A 80-kg construction worker, who is initally standing on the extreme left end of the plank, begins to walk to the right. How far from the right end of the plank will the worker be located when the plank begins to tip? 4.0 m 4.0 m 5.0 m a. 4.50 m O b.5.00 m O c. 4.25 m d. 5.25 m O e. 4.75 m
The diagram above shows a 3.00 m long uniform beam. The left end of the beam is attached to a wall by a frictionless pivot. The beam is supported by a string that keeps the beam horizontal. The string makes an angle of 35.0° relative to vertical. The beam has a mass of 7.00 kg. A 2.00 kg mass is located at the end of the beam. A 6.00 kg mass is located 1.00 m from the 2.00 kg mass, as shown in the diagram. a. What is the tension in the string? b. What is the y-component of force applied to the beam by the pivot?
The wow expert Hand written solution is not allowed.
The meterstick shown is 100 cm long. It is free to pivot around its center of gravity (CG), which is at the 50 cm 10 20 30 40 50 60 70 80 90 mark. There is a 20.0 N block hanging from the 80 cm mark. Decide where each of the other blocks should be placed, one at a time, to balance out the 20.0 N block. 3 2 1 At what mark on the meter stick would you place a 19.0 N block to balance the 20.0 N block? mark: cm At what mark on the meter stick would you place a 42.0 N block to balance the 20.0 N block? mark: cm about us careers privacy policy terms of use contact us help -8
Don't Use Chat GPT Will Upvote And Give Handwritten Solution Please