Soil mechanic Basic Relationships Page 23ALi othmanx:9A specimen. of Soil is found to have a wet mass of 167:gim,and a dry mass of 112 gm. The vol ume of the specimenis measured before drying and is equal to lo2 cm'. TheSpecific gravity is 2.65. Find ; the voids ratio , Porosity,değree of Saturation and the dry density -

Answered: Image /qna-images/answer/0d286e4f-78da-473e-bf86-3ccb5f1ffdd2.jpg

JA specimen. of Soil is found to have a wet mass of 67.9, and a dry mass of 112 gm. The . Nal ume .of the specimen is measured before drying and is equal to lo2 cm’. The Specific gravity is 2.65. Find ; the voids ratio, Porosity, degree. of Saturation. and the dry density -

JA specimen. of Soil is found to have a wet mass of 67.9, and a dry mass of 112 gm. The . Nal ume .of the specimen is measured before drying and is equal to lo2 cm’. The Specific gravity is 2.65. Find ; the voids ratio, Porosity, degree. of Saturation. and the dry density -

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Good brick earth should contain about 20% to 30% of

A: Bricks are the most commonly used construction material. Bricks are prepared by moulding clay in…

Q: Explain how asphalt mixes get placed in the field

A: Following steps are involved in placing an asphalt mixes in the field. 1.The already present debris,…

Q: soil mechanics Q1-a-- Define the weathering,and discusses the types of weathering including outcome…

Q: You have been tasked with leading the community garden in your neighborhood! It is located in a…

A: A = 1/3 acre = 1.66 g/cm3d = 10 inch or 0.833 ft

Q: Give some examples of bulking agents in a biofilter?

A: Brief concept introduction- Bulking agent- It is an additive that contributes to the bulk without…

Q: Dexter is preheating her oven before using it to bake. In moisture content determination, what is…

A: Preheating is the process of preparing an oven prior to the analysis. When an oven is preheated, it…

Q: 4. Classify each of the following materials by the AASHTO & USCS classification methods: % Passing…

A: Solution: Soil#1: AASHTO classification: No. 200 = 70 > 35% A-4, A-5, A-6, A-7 LL = 65 > 41%…

Q: Describe the general time frame for the processes of mechanical and chemical weathering.

A: Mechanical weathering and chemical weathering are two primary types of weathering that occur on the…

Q: Referring to the attraction that typically exists between water and clay particles, what is adsorbed…

A: The water is held in the diffuse double layer of the clay particle is called absorbed water or…

Q: Relationship Between Particle Size Analysis and Moisture Content.

A: The particle size analysis is used for the gradation and classification of the soil for the…

Q: Rocks that are acidic rocks such as granite used for what purpose of work?

A: The rocks are the hard and solidified strata available on the surface of earth. The main supply of…

Q: What do you mean by bulk density of the particulate layer?

A: Bulk density is defined as the ratio of the mass of the particles to the total volume of the…

Q: Peat or organic soil is the best soil condition to sustain the building system ? True False

A: Peat or organic soil refers to soil that is predominantly composed of decomposed organic matter,…

Q: Characterize asphalt cement.

A: Asphalt cement is a highly viscous liquid form of petroleum. It acts as the glue that binds the…

Q: Problem statement: Give a brief explanation about Lime, types of lime and various impurities in lime

Q: Classify below material based solely on the soil grading, according to TRH14 Sieve Size(mm)…

A: Given: Sieve size %passing 50 100 37.5 100 28 89 20 73 14 72 5 51 2 25 0.425 15…

Q: What is the importance and role of moisture content in the construction material utilization?…

A: It is very important to determine the moisture content of the construction material for following…

Q: Is the below statement is true ? if yes, how ? Air is not an important part of soil

A: Note: As this question has asked in the civil engineering queue. So we will answer this question by…

Q: Describe about the Stresses Caused by the Soil Mass.

A: Stresses in a soil mass are essential for its good performance but can be problematic if they exceed…

Q: Explain the Capillary Rise in Soil.

A: Capillarity is the primary force allowing the soil to retain water and to regulate its movement.

Q: What is the cumulative percent retained on the sieve with the highest percent retained? (2 decimal…

A: We will take average of all three trials and find the cumulative percent retained.

Q: If we use more or less amount of water than consistency limit, what will happen?

A: Let us discuss the effect of water addition on consistency limit on step 2.

Q: Define shrinkage limit. What is the water content above and below shrinkage limit.

A: These limits are given by atterberg.

Q: Explain the factors contributing to soil liquefaction?

A: Soil liquefaction, the temporary loss of strength and stiffness by saturated soil due to increased…

Q: A fence has a dimension of 6 meters and 10 meters high including the portion below normal grade…

A: Given data:- The dimension of the fence is, A =6m×10m

Q: What is the Frost Heave in Soil?

A: Frost heaving of soil is defined as the phenomenon during which the soil mass swells up in upward…

Q: Describe Frost Heave in Soils.

A: The two critical frost actions in the soil are the frost heave and the frost boil. Frost heave is…

Q: Discuss the different types of defects in the soil masses (150 - 250 words).

A: In soil mechanics, various types of defects or…

Q: Define mud or slurry

A: Mud or slurry is defined as:

Q: Describe about the vibrating plate compactors effectiveness.

A: Vibratory plate compactors:

Q: QUESTION 1 a. Rocks is one of the basic material use in civil engineering construction. Discriminate…

A: a) Geological classification of stones: According to this classification, the rocks are of the…

Q: What is the basic objective of the various soil stabilization procedures, and how do the stabilizing…

A: Objective of soil stabilization:

Q: What is the state or nature of the water immediately surrounding a clay particle?

A: Various types of Soil water are 1- Structural water 2- Adsorbed water 3- Capillary water 4- Free or…

Q: Describe the the process used to determine soil moisture content.

A: Various methods can be used to determine soil moisture content : 1- Oven drying method 2- Pycnometer…

Q: Describe how sand makes a good adsorbent?

A: Sand contains pores that allow it to absorb water. The sand's absorbency, or water retaining…

Q: Weight of Sieve with Sieve no. Weight of Empty Weight Retained Aggregates Sieve (grams) (grams)…

A: Given Seive No. Weight of empty seive, Weight of seive with aggregate, To Determine Weight retained…

Q: at makes soil different as a construction material in comparison to concrete, asphal

A: Construction materials play a pivotal role in the built environment, exhibiting distinct properties…

Q: Determined and fil-up the unknown data of the given table. Physical Properties Mix Design Specific…

A: Concrete Concrete is a composite material used in engineering that closely resembles rock in its…

Q: Describe the methods of soil mixing.

A: Soil intermixture consists of exploitation specially designed augers or special tools to…

Question

Soil mechanic

Basic Relationships Page 23
ALi othman
x:9A specimen. of Soil is found to have a wet mass of 167:gim,
and a dry mass of 112 gm. The vol ume of the specimen
is measured before drying and is equal to lo2 cm'. The
Specific gravity is 2.65. Find ; the voids ratio , Porosity,
değree of Saturation and the dry density -

Branch of science that deals with the stationary and moving bodies under the influence of forces.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Approach and find basic parameters.

VIEW

Find the required parameters.

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

1:0) 3G Z 4.5G+ I. A docs.google.com Q3: Answer all questions -If the percentage of total absorption of standard solid clay brick is 20%, and the volume of combined pores equal to 850 cm3 .Assume water density =1 g/cm3 - Find the weight of sample immerse in water? Your answer - Find the Bulk Specific Gravity (saturated) Your answer - Find the Apparent Specific Gravity Your answer
Define Cement. Write Examples of Calcerous & Agrillaceous compund.
Construction material
How does the water molecules become attracted to the clay particles?
Differentiate between Freeze-Thaw weathering and Exfoliation weathering in aspect of engineering geology.
Define the term optimum moisture content.
Define: 1. Characterization2. Adsorption studies3. Adsorption Capacity4. Percentage removal
List some Clay minerals and their uses.
What is the MINIMUM head diameter for an asphalt shingle fastener? 1. .105 in. 2. 375 in. 3. 4. 405 in. .750 in.
How many grams (whole number, no need for unit) of fine aggregates used in this experiment? Blank 1 Blank 1 Add your answer
8. If the sieve #8 with effective area of 67,000 mm2 is used, how much is maximum allowable quantity of material retained on a sieve?
What sieve size has the highest percent passing? (2 decimal places, no need for unit) Blank 1 Blank 1 Add your answer