It is found that the energy required to reduce particles from a mean diameter of 1 inche to 0.3inche is 11 kJ/kg. Estimate the energy requirement to reduce the same particles from a diameter of 0.1 in to 0.01 assuming: (a) Kick's Law, (b) Rittinger's Law, (c) Bond's Equation Comment on your results

Q: Q4) Write the relation between melting point temperature of ice with pressure? At 1 Atm, water melts…

A: Melting point is the temperature required for the solid to change its phase from solid to liquid.…

Q: Natural gas can only be trapped under a impermeable anticlinal formation, usually called as a gas…

A: Natural gas is a fossil energy source that formed deep beneath the earth's surface. Natural gas…

Q: The disintegration of Flerovium isotope is observed in an ampoule. It takes 20 milliseconds for the…

A: Given data: Time required to reduce the initial amount to 75 % = 20 milliseconds

Q: Derivation of the kinetic energy law for gases

A:

Q: Normal butanol (A) is diffusing through air (B) Estimate the diffusivity for the T = 20° P = 15 atm

A: Given details, Butanol(A) is diffusing through air(B) at Temperature, T=200C=20+273 =293 K…

Q: In gravimetry based on precipitations, a small value of R (~1.0) is desired. Why?

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned…

Q: explain the relation between thermal diffusivity and thermal conductivity. And why do we have two…

A: Thermal conductivity is defined as the ability of a material to conduct heat. It is the heat…

Q: Find the shortest possible wavelength of radiation emitted by the excited electron when it stops at…

A: The electrons of the atom revolve around the nucleus of the atom. They revolve in their own orbital.…

Q: E C A W Below is shown the results for a series of cake filtration experiments on two types of waste…

A: Correct. The higher slope (1.27) for Type B implies a greater increase in specific cake resistance…

Q: please give a precise answer

A: In summary it is due to :  1. Metals have larger number of free electrons2. Metal have smaller gap…

Q: Derive an expression for the heat exchange between two black bodies

A: Consider two black radiating bodies of area A1 and A2 . Heat exchange between two elementary areas…

Q: For the predeposition heat treatment of a semiconducting device, boron atoms are to be diffused into…

A:

Q: In the table below are shear stress and shear rate data for three bottles of syrup (simply…

A: In the above question shear stress vs shear rate data are given. We have to find the Non Newtonian…

Q: 1. _Give the Dimensional Analysis to explain the three cadres of the Mass Transfer and their…

A: Dimensional analysis in mass transfer  Mass transfer stands for the net movement of mass from one…

Q: дт The Joule-Thomason coefficient of a gas is given by = 3.17- atm K др )н The gas was initially at…

A: The temperature of the gas is to be determined after it passed through the throttle.

Q: Only part b and liquid density is 0.588 g.cm-3

A: (b)   Temperature of 1-butene, T = 120°C = 393.15 K Pressure of 1-butene, P = 34 bar…

Q: A core was mounted in a gas permeameter to measure permeability, and the following laboratory data…

A: Given data: Diameter of core = 2.59 cm Length of core = 6.03 cm Gas viscosity = 0.0148 cP Pressure…

Q: H.W. Derive equation 3.20 (Bragg's Law) from equation 3.19 using trigonometry formulas.

A:

Q: Calculate the total translational kinetic energy of the air molecules in a 5.0m × 5.0m × 5.0m room…

A: Given information: Room dimensions: 5.0 m x 5.0 m x 5.0 m   Case 1: Temperature, T1 = 20°C Pressure,…

Q: What is the energy change when the temperature of 13.6 grams of solid graphite is decreased from…

A:

Q: Verify that thermal conductivity

A:

Q: On which the following are depend upon? The Precipitation Titration Mohr method

A: Precipitation titration is a method of titration which involves the formation of precipitates while…

Q: 1. Quartz and pyrites (FeS2) are separated by continuous hydraulic classifications using free…

A: In the settling of particles, the denser particles settle in the hydraulic classifier and other…

Q: Determining molar mass by electrolysis. An electrolysis cell containing MSO4solution is operated for…

A: Write the reaction for the dissociation of MSO4 as follows: MSO4  → M2+ + SO42-   There are two…

Q: A solution is made by putting 100 g of NaNO3 into 200 mL of water at 70 degrees C.If the solution…

A: Answer Salt precipitates out is NIL A solution is made by putting 100 g of NaNO3 into 200 mL of…

Q: Q 3) A) What is the physical significance of the two constants that appear in the van der Waals…

A: Since you have posted multiple independent questions in the same request, we will solve the first…

Q: Derive the conduction equation that predicts q (T, X) as a function of T and X for the stopper shown…

A: Given: The temperature at one end of the stopper is T1 = 750 K, and at the other end is T2 = 300 K,…

Q: electron

A: Tc has the electronic configuration like [Kr]4d5 5s2

Q: Estimate density of n-butane at 375 K and 10 bar. Use the viral equation of state.

A: Answer Density of butane is 0.2196 g/cm3  Detailed Solution attached in Step-2.

Q: find the difference between point A and B. Take S=0.876 for Benzene and S=0.81 for Kerosene.…

A: Given: Specific gravity of benzene = 0.876 Therefore, density of benzene = 876 kg/m3 Specific…

Q: Electrophoretic separation at 1 point pH= 8.5 of a sample of proteins: 1 (100 KD), 2 (200 KD), 3…

A: Answer:      option two is the correct answer

Q: 4. Find the shearing stress based on the given below: 0.3m/s 250 mm acetone 20°C, 1 atm Im/s

A: The shearing stress for the acetone is to be calculated.

Q: Explain with a sentence in the framework of a strategy why a correction factor is used in…

A: The concept of correction factor (CT) is for the case of multiple pass shell and tube heat exchanger…

Q: The chemisorption of hydrogen. H2, on copper powder at 25 oC follows the Langmuir isotherm with a=…

A: Chemisorption of the hydrogen follows the langmuir adsorption isotherm. constant a = 3.67 KPa-1…

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.