It is desired to absorb 95% acetone from a feed mixture of acetone and air containing 2 mol% acetone, using pure water. Pure water at the rate of 800 kg/h is introduced at the top of the tower and the gas flow rate at the bottom of the tower is 450 kg/h. Find the composition of acetone in the liquid effluent flowing out of the tower.

Q: A double effect evaporator is used to concentrate an 18% CuSO4 solution. At the end of the…

A: Aqueous solution of CuSO4 is concentrated in a double effect evaporator.

Q: Consider the ionization of nitrous acid at 25 °C:

A:

Q: 3. An evaporator is concentrating solutions from the two different sources. The solution from the…

A:

Q: Write all steps in paint making process.

A: Pigments, binders, and solvents are properly weighed, milled, and blended in the paint industry.…

Q: [Evaporation] A triple effect evaporator concentrates a 10% caustic soda solution from 10% to 50%…

A: Introduction  Chemical engineers refer to a multiple-effect evaporator as a device for effectively…

Q: A cold room in a meat processing industry has for handling products whose external wall is coated…

A: To find:a) The effect of reduction in the moisture relative to air in the diffusion rate.b) The…

Q: Evaporative Crystallizer.A 5,000-lb batch of 20 wt% aqueous MgSO4 solution is fed to an evaporative…

A: Mass of initial aqueous solution of MgSO4 fed to the crystallizer, mF = 5000 lb The weight percent…

Q: 8. An ice piece at temperature 6 = 0 °C is affixed at the bottom of an insulated cylindrical vessel.…

A: The temperature of the water before it is poured into the vessel is to be determined.

Q: The packing height in an absorption tower is 4 m used to remove 90% cyclohexane from a mixture of…

A: Consider an absorption tower with height 4 m used to remove 90% cyclohexane. The process flow…

Q: Problem No 3: A material contains 75% water and 25% solid is fed to a granulator at a rate of 4000…

A:

Q: There are 300 cubic meter/min of atmospheric air initially at 25 C wet bulb temperature and 60 % RH…

A:

Q: A huge amount of clean water at 78.98°F flowing past over a flat slab of solid CiH&O2. The velocity…

A: Given: Water flows over a flat slab at a velocity of V = 0.361 ft/s = 0.11 m/s       (Convert into…

Q: An evaporator is fed with 17400 kg/h of a solution containing 12.1% NaCl, 19.9% NaOH, and the rest…

A:

Q: The aqueous acetone solution is mixed with Methyl isobutyl (MIB) solvent containing 3% acetone by…

A: It is given that an aqueous acetone solution is mixed with methyl isobutyl (MIB) solvent. The…

Q: Gas at 30 °C and 1.4 atm is flowing through an irregular duct. To determine the rate of flow of the…

A: Given that- Basis flow rate of gas entering the duct= V m3/min (supposed) Tempearture of Gas,…

Q: Solvents such as diethyl ether ( b.p. 35 °C at 1 atm) and dichloromethane (b.p. 40 °C at 1 atm)…

A: Distillation is a process of separating different components from the crudes, based on their boiling…

Q: Write out and balance the overall equation for the manufacture of vinyl chloride from ethylene,…

A: vinyl chloride = C2H3Clethylene =  C 2H4Chlorine = Cloxygen = OA( C2H4) + B( Cl2) + C(O2) ------>…

Q: In the gas ionization chamber, the amount of electrical current depends on the absorbed dose in the…

A:

Q: The aqueous acetone solution is mixed with Methyl isobutyl (MIB) solvent containing 3% acetone by…

A: Given, The molar flow rate of the lower stream, B = 400 kg/h The molar flow rate of the upper…

Q: Which of these does not result to a gas-liquid mixing? A. Flotation B. Foaming C. Aeration D. None…

A: To choose the correct option

Q: adsorption of sodium oleate

A:

Q: Which of the following unit operations in chemical engineering is primarily used for separating…

A: Your answer is Answer: B) Filtration

Q: The process by which the supernatant liquid is poured out leaving the precipitate in the container…

A: The substances that we see around us aren't in their purest forms. They are basically the mixture of…

Q: There is an air flow with a temperature of 32.0℃, and it is humidified by making it flow over a…

A:

Q: Studru 4.50 A polymeric material is being considered as a coating film to protect an optical storage…

A:

Q: 2. plata rate of 10,000 kg/hr, calculate the flowrate of the liquid quid leaving the unit, this…

A: A feed is sent into a mixer and followed by a calciner. There are two discharges from the calciner.…

Q: The air freshener shown in the figure below is used to deliver a pleasant vanilla fragrance in a…

A:

Q: The energy required for the ionization of a certain atom is 21.4 eV The absorption of a photon of…

A: The wavelength of the radiation which is incident on to the atoms is to be mentioned.

Q: Aqueous solutions are sometimes used in crystallization procedures. In such cases, the water in the…

A: Crystallization is a process in which the crystals of solute are formed by evaporating or cooling…

Q: The humidity of a humid solid (dry basis) decreases from 80% to 5% in dryer. i) Calculate the amount…

A:

Q: 1. [S] 65 kg of water at 650 °C, 20 bar are placed in a fixed volume container and converted to…

A: Water can exist in different states depending on the expernal condition of pressure and temperature.…

Q: Problem 1 Estimate the time required to evaporate 5% of a solid naphthalene sphere (moth ball)…

A:

Q: Analyze in the psychometric graph 2 states the first select according to the place where a…

A:

Q: 60% NaOH is to be concentrated in a triple effect evaporator to 15% NaOH. If equal amount of water…

A: The tripple effect evaporator system has been shown in figure The feed rate is F=100 kg/hr (Taking…

Q: .Carburization process is applied to the surface of a steel containing 0.3% carbon.Methane gas (CH4)…

A: Given data: Initial concentration of carbon = 0.3 % Final concentration of carbon = 1.2 % Amount of…

Q: Oxygen gas is most soluble in water under which set of conditions? A. Low temperature, low…

A: Oxygen gas is most soluble in water at high pressure and low temperature       Option C is correct

Q: Differential Equations: Mixing Problem A tank contains 200 liters of brine with 20 kg of salt in…

A: initial volume of brine =200 L initial amount of salt =20 Kg initial concentratio of salt =20…

Q: Calculate the number of degrees of freedom for the mixed-feed,triple-effect evaporator system shown…

A: Assumptions: Organic acid is non-volatile and perfect insulation against heat loss, i.e., no heat…

Q: 1. Based on the following figure, answer the following questions : (a) How many actual trays are…

A: Mc-Cabe Thiele diagram of a mixture is given.