Q2) A hydro-electric generating plantis supplied from a reservoir ofcapacity 20000000 m3 with a headof 200 m. The hydraulic efficiency ofthe plant is 0.8 and the electricefficiency is O.9. What is the total* .available power output in 10 hours

In this question plant given reservoir capacity , head , efficiency...We have to find out total…

is supplied from a reservoir of pacity 20000000 m3 with a head 200 m. The hydraulic efficiency of the plant is 0.8 and the electric efficiency is 0.9. What is the total available power output in 10 hours

is supplied from a reservoir of pacity 20000000 m3 with a head 200 m. The hydraulic efficiency of the plant is 0.8 and the electric efficiency is 0.9. What is the total available power output in 10 hours

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: (9) The coefficient of performance of a residential heat pump is 1.95. If the input power to this…

A: The coefficient of performance of a pump is the ratio of heat produced in the pump to the amount of…

Q: Q1 Using vocal analysis metheel, find current analysis in each branch of the circuil. All…

Q: A 230 V, single phase, watt hour meter has a constant load of 5A passing through it for 8 hours at…

A: Given: For a watt-hour meter VL=230 VIL=5 At=8 hrcosϕ=1Meter constant=460 rev/kWh

Q: МСВ Instruction Check Connection ON A Voltmeter 1 Ammeter Wattmeter Reset V Add to Table…

A: The setup shows two voltmeter, ammeter, wattmeter, auto transformer, Transformer and MCB.

Q: If in warehouse scale computer we have the following 1- critical load = 10 MW ( Mega Watt) 2…

A: PUE stand for Power usage effectiveness. It is the metric use for determining the energy…

Q: Read the question carefully and match the answer with its respective question: It has been predicted…

A: given present load factor = 0.67 present year maximum demand = 6 MW load factor = average…

Q: Energy required in the US in 1995 was 3.92*10^6 Gwh. What is the equivalent in BTU?

A: 1 GWh=3.412×109 BTU Energy in BTU=3.92×106 GWh×3.412×109 BTU/GWhEnergy in BTU=13.38544×1015…

Q: A diesel engine power plant has one 600 kW and two 250 kW generating units. The fuel consumption is…

A: We have an diesel engine power plant with total of 3 units, 1 unit of 600 KW 2 unit of 250 KW Fuel…

Q: A Hydroelectric Plant has a Turbine and Generator with an efficiency of 63%. If the dam has a Head…

A: To find the power generated in the hydroelectric power plant First convert all data in SI Unit

Q: In KFC company the electrical generator installed provides a power output of 120 MW with an…

A: Given output power=120 MWEfficiency η=66%

Q: A 5 hp motor (mechanical power), wye connected with a 208V line: a. What is the apparent power…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Consider the following data from the Efficiency of Light Bulb. Data for the Efficiency of Light Bulb…

A: It is given that: TR Mi Miw V I ti tf Ti Tf 23° C 85.0 g 290.0 g 11.5 V 2.10 A 0 s 13.8 s 12° C…

Q: What is the KW rating of a 200V dc motor to drive a pump that required to discharge water at a rate…

A: It is given that: V=200 VH=60 mη=0.70Q=100 litersminQ=100×1.66667×10-5m3sQ=1.66667×10-3m3s

Q: A factory has an average daily load of 200 kW and a maximum demand of 250 kW. The factory operates…

A: In this question We need to determine the load factor of the factory. We know Load factor is define…

Q: Define energy management.

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The thermal efficiency and electrical efficiency of a steam power station are 30 % and 92 %…

Q: (a) If an H winding and an X winding short together, the result will be this is a normal mode of…

A: (a) If an H winding and an X winding short together:High current flow and transformer failure:This…

Q: The maximum power demand of a consumer is 2 kilowatt and the corresponding daily energy consumption…

A: Given, Maximum power demand = 2 kW. Daily energy consumption = 30 units = 30 kWh

Q: Test # Reading 1016 986 3. 981 990 1011 6. 1011 997 8 1044 9. 991 10 966 2. 4.

A: Test # Reading 1 1016 2 986 3 981 4 990 5 1011 6 1011 7 997 8 1044 9 991 10 966

Q: Ageneration station of 10MW Suppl region of two consumers A and B where The Variation of The load is…

Q: A 10A current flows through a 3-ohm resistor. Calculate the energy subsided by the resistor in 100…

Q: Find the complex power supplied by the source and the power factor of the source for the network…

A: The solution can be achieved as follows.

Q: 5. A hydroelectric power station is supplied from a reservoir having an area of 50 km and a head of…

A: we have given; over all efficiency of the plant η=60%=0.6total head area =50mgenrating power…

Q: A renowned wind turbine company wants to sell you a wind turbine to go on your roof. They say that…

A: Wind turbine : the electrical machines which convert wind energy into Electrical energy is called…

Q: 1. The nominal resistance value of the a 4-band resistor is 470 k2 + 5%. a. What is the resistance…

Q: A thermal station has the following data: Max. Demand = 40,000 kW, Load factor = 60%. Thermal…

A: In this question we need to find a consumed coal to produce 1KWh of Electrical energy.

Q: With improvement of efficiency of the PV Module, we can improve a. its Surface Area b. its output…

A: In this question , we will write With improvement of efficiency of the PV Module, we can improve..

Q: Question: Cost analysis of a house's electrical energy needs. Requirement: 15 KW/h for heating…

A: We must determine the energy consumption and cost for each season separately, as well as account for…

Q: A 75 MW thermal power station uses coal of calorific value of 6400kcal/kg. Thermal efficiency of the…

A: Given data, Capacity of thermal station is P = 75 MW, Calorific value is 6400 kcal/kg, Thermal…

Q: why need to improve a power factor (in electrical)

A: Given : In the above question they want to know the how the power factor can be improved in an…

Q: hat could happen if the Zener diode would be changed to a Zener which has a higher breakdown…

A: Breakdown voltages for commonly available Zener diodes can vary widely from 1.2v to 200v. for diodes…

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

Q2) A hydro-electric generating plant
is supplied from a reservoir of
capacity 20000000 m3 with a head
of 200 m. The hydraulic efficiency of
the plant is 0.8 and the electric
efficiency is O.9. What is the total
* .available power output in 10 hours

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The maximum power demand of a consumer is 2 kW and the corresponding daily energy consumption is 30 units. What is the corresponding load factor?
Briefly explain 3 benefits of improving power factor
The capacity factor of a commercial PV generation facility is determined 0.486 over one-year period. Given the installed power of this facility 7.8 MW, how much energy (in GWh) does this facility generate in one year?
A hydro-electric generating plant is supplied from a reservoir of capacity 20000000m' with a head of 200m. The hydraulic efficiency of the plant is 0.8 and the electric efficiency is 0.9. What is the total available energy Ans: [7.85GWH]
In a pumped hydro system 325 MWh of electric energy was drawn from the grid to störe water with an energy of 270 MWh, While discharging, it delivers the grid an energy of 230 MWh. The turnaround efficiency is: 83.1% 70.8% 90.1% 85.2%
Find the efficiency
A hydro station has a water discharge of 550 cubic meter/hour. The head of the water in the dam is 25 m with total efficiency of 80 %. The power generation of the station is * 29.94 kw 107800 kw 45.87 kw 205764 kw Non of them
What is the efficiency of the turbine if Power of the wind is 120.2 W and power of turbine is 402.2 W? a. 28.1% b. 31.8% c. 29.8% d. 30.09%
A certain wind turbine has a nameplate capacity of 2 MW. If the average capacity factor is 47%, how much energy in MWh does the turbine generate each week? Please include one decimal place in your answer. Hint: there are 168 hours in a week.