In KFC company the electrical generator installed provides a power output of 120 MW with an efficiency of 66%. Calculate, (a) The rate of energy supplied to the generator for 5hrs (b) The rate of energy input requirement if the generator is replaced with newer one and it has an efficiency of 77% (c) What do you infer form this problem?

In KFC company the electrical generator installed provides a power output of 120 MW with an efficiency of 66%. Calculate, (a) The rate of energy supplied to the generator for 5hrs (b) The rate of energy input requirement if the generator is replaced with newer one and it has an efficiency of 77% (c) What do you infer form this problem?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: in a work environment 50 Hz 220V Find the following hardware in the power system 1. .piece 100W…

A: Given f = 50Hz Vrms =220V Since all the loads work at a rated voltage of the supply we will…

Q: An energy meter revolves 190 revolutions of disc for a unit of energy. Find the number of…

A: Need to find the number of revolution for the given load conditions then find error

Q: Figure 3 shows a transformers consists of soft-iron core, coils X and Y. Soft iron core aс, 240 V…

A: Transformer is a static device that transfers power from one circuit to another by using the…

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 250 Volts at 1.2 milli…

Q: A parallel generator gives KWD 260 volts at a speed of 1100 revolutions per minute, if the product…

A: In the given question there are two cases given. 1. when motor draws 5 amp current then speed =…

Q: An automotive alternator is rated 550 VA and 20 V. It delivers its rated voltamperes at a power…

A: Given data, The value of the Rate is 550 VA, The value of line voltage is 20V The given power factor…

Q: Assume the maximum amount of power a plant can generate is 10,000 MW. For half the year it generates…

A: In this question, Assume the maximum amount of power a plant =10,000 MW. For half the year power…

Q: A steam turbine generator is designed to generate 5.5MW of electrical power at a 6300V, 50HZ and…

Q: A heating unit has a power output of 8 kW. The initial temperature of the unit is 20 ⁰C at 220 V. A…

A: Given: A heating unit has a power output of 8 kW The initial temperature of the unit is 20 ⁰C at 220…

Q: 10. If a generator is overcompounded and you want to decrease the degree of compounding, then the…

A: simple straight forward questions on DC machines

Q: A wind turbine has the following data: Downstream wind velocity = 12 m/s Upstream wind velocity =36…

A: For a wind turbine , downstream and upstream wind velocity is given and also power output is given…

Q: A universal series motor, when operating on 220 V d.c. draws 10 A and runs at 1419 r.p.m. Find the…

A: Universal motor is a motor, as the name suggests, an electric motor capapble of running on both AC…

Q: SOURCE TRANSFORMATION VS RA RB Do not include the unit. The answer must be in 2 decimal places. IS…

A: We need to find out the current through given resistor in the given circuit by using of source…

Q: A) An energy meter whose constant is 1500 reVolutions per KWh makes, 20 reVolutions in 30 seconds.…

A: In this question we need to find the following A) Calculate the load inKW. B) meter constant and If…

Q: What is geothermal energy? With the aid of a schematic diagram, describe how we can generate…

A: Geothermal energy is a renewable source of energy stored inside of the earth. This energy comes from…

Q: A 50-cycle voltage with maximum value of 24 V. (a) What will be the value of the instantaneous…

Q: plase answer five a quesion option corrctly 9.In AC circuits, power consumed is A.it depends…

A: In this question we will find power in ac circuits , potential transformer etc.. As per our…

Q: Example1.Two 220-V, d.c. generators, each having linear external characteristics, operate in…

Q: A 2 pole, 50 Hz, 11 kV, 100 MW alternator has a moment of inertia of 10,000 kg.m2. The value of…

Q: b) A power station has the following daily load cycle as Figure Q1(b) below: 16-20 20-24 20 Time in…

Q: Q1. A certain power station has the following daily load cycle:- Time In hours (6-8)am (8-12)am…

Q: An energy meter revolves 190 revolutions of disc for a unit of energy. Find the number of…

A: Given: Load voltage VL=220 V, Load current IL=14 A, Load power factor PF=0.8 (lagging).

Q: a) Explain briefly how electricity can be sold to a grid by use solar energy.

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Main goal of using feed water heaters is to minimize the amount of heat addition in steam generator.…

A: A feed water heater is a power plant component used to pre heat the water delivered to the steam…

Q: Which negative environmental impact is NOT present in wind energy? O a. all of these O b. water use…

A: Answer is (All of these) Option : a

Q: A meter is used to measure the energy consumed by a load of 20A, 230V at 0.5 power factor. For one…

Question

100%

In KFC company the electrical generator installed provides a power
output of 120 MW with an efficiency of 66%. Calculate,
(a) The rate of energy supplied to the generator for 5hrs
(b) The rate of energy input requirement if the generator is replaced with
newer one and it has an efficiency of 77%
(c) What do you infer form this problem?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

i need the answer quickly
Range of a generating voltmeter is 30 to 300 kV dc and its indicating meterreads a minimum current of 3μA and maximum current of 35 μA, find the capacitance of thegenerating voltmeter.
A 230V, 10A single phase energy meter makes 180 revolutions per kW hour. If a load is supplied through the energy meter at rated condition with unity P.F for 1 hour. Then the speed of energy meter
(Q1b) A separately excited de generator has a no-load voltage of 100 V. We increase the excitation current by 10%. What voltage would we measure in the terminals? (a) 100 V, (b) 107 V, (c) 110 V, (d) 113 V
A wind turbine gives maximum output power of 10KW at a wind speed of 12m/s.Choose the correct statement for this wind turbine.؟ a. The input wind power is 1.69KW b. The input wind power is 16.9KW C. The input wind power is 169KW d. The input wind power is 16.9MW
generator has maximum power of 60 MW, 60 HZ, efficiency of 50% and load factor of 0.4 . to produce 1 KWh it needed 860 kcal/h, calorific value of raw material (coal) is 6000 kcal/kg the average power is: C-34 MW d-not mentioned b-60 MW a-24MW
Fourth time to ask but always wrong answer . Please correct answer
Explain the types of generators used in wind turbines with a neat diagram and also discuss the grid-connected issues related to it
EE energy engineering Solve the The part indicated in the photo ( last two questions)
The meter constant of a 245 volt, 70 ampere, single phase energy meter is 1650 revolutions per KWh When tested at quarter load, rated voltage and 0.8 power factor, the meter is found to make 100 revolutions in 65 seconds. Determine the percentage error at quarter load