Is longitudinal diffusion of the solute a more serious problem in gas or in liquid chromatography? gas chromatography liquid chromatography Why is longitudinal diffusion a more serious problem in this type of chromatography? Gas chromatography is carried out at higher temperatures than liquid chromatography. The blute must volatile for application of gas chromatography. The linear velocity in gas chromatography is greater than the linaer velocity in liquid chromatography. Diffusion coefficients of gases are much greater than those of liquids.

Is longitudinal diffusion of the solute a more serious problem in gas or in liquid chromatography? gas chromatography liquid chromatography Why is longitudinal diffusion a more serious problem in this type of chromatography? Gas chromatography is carried out at higher temperatures than liquid chromatography. The blute must volatile for application of gas chromatography. The linear velocity in gas chromatography is greater than the linaer velocity in liquid chromatography. Diffusion coefficients of gases are much greater than those of liquids.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

what are key reactions involved in seperation of liquid mixtures by simple and fractional distillation and gas chromatography? chemicals used: 10ml 1:1 mixture of ethyl and butyl acetate techniques: simple and fractional distillation, gas chromatography. target molecules: Ethyl acetate C4H8O2 Butyl acetate C6H12O2
a) What would you see if you ran a Thin Layer Chromatography (TLC) on a mixture of the three solids shown below using silica gel as the stationary phase and ethyl acetate/hexanes as the mobile phase? Whichsolid would have the highest Rf and which would have the lowest Rf? Explain b) Would changing the mobile phase (from part a) and increasing thepolarity by introducing small amount of methanol to the mobile phase change the order ofRf of the above 3 compounds? Explain c) Another type of chromatography is Reverse Phase Chromatography. In this type ofchromatography, the stationary phase is non-polar and the mobile phase is polar. If astudent performed Reverse Phase TLC on the mixture of 3 solids (from part a),what would be the order of Rf’s of the compounds? Which would have the lowest Rf andwhich would have the highest Rf?
The solid material in column chromatography is typically referred to as: O 1) the stationary phase 2) the mobile phase
What are the functions and procedure of analysis of many volatile organic molecules by using Gas chromatography
A three-component mixture containing compounds A, B, and C is separated by simple distillation. A fraction from that distillation is collected and analyzed by gas chromatography. The resulting chromatogram is overlaid on a ruler in the figure shown below. Using this figure and the data contained therein, determine the percentage composition of each component in this fraction by the triangulation method (i.e. determine the percentages of A, B, and C in this fraction). Be sure to show the setup for your calculations. 15 10 AAA 5. B 10 15 20 25 30 35 (both axes are in mm)
The required mobile phase for the analysis caffeine in soft drinks in liquid chromatography are methanol and water. What class of methanol and water must be used? Kindly explain the answer.
1. Compare and contrast the techniques of gas liquid chromatography (GC) andliquid chromatography (HPLC) in terms of nature of samples, mobile phase, columns,detection and relative cost.
Classify the stationary phases based on whether they are commonly used in reversed-phase liquid chromatography (RPLC) or normal-phase liquid chromatography (NPLC). RPLC pentafluorophenyl (-(CH₂)3 C6F3) octyl (-(CH₂), CH3) Answer Bank diol (-(CH₂), OCH₂CH(OH)CH₂OH) octadecyl (-(CH₂)17 CH3) phenyl (-(CH₂), C6H₂) NPLC amino (-(CH₂)2NH₂) cyano (-(CH₂)₂C=N)
In column chromatography, the following statements are true except-* The stationary phase is held in a narrow tube through which the mobile phase is forced under pressure The effectiveness of the chromatographic column in separating two solutes depends in part on the relative rates at which the two species are eluted The stationary phase is supported in a flat plate or in interstices where the mobile phase moves through by capillary action or under the influence of gravity Predict the order of elution of the following components if a normal phase column and hexane:methylene chloride mobile phase was used in the separation. (A.) Propanone (B.) Propanoic acid (C.) Methyl ethanoate BCA ABC ACB The following are true for the observed tailings and fronting in a chromatogram, except- Fronting and tailing leads to a good separation and reproducible elution times Tailing is observed when the tail appears to the right of the chromatogram and front is steepened while fronting is observed when…
Make a results and discussion in Laboratory Report Format of the following: 1. Separation of mixture using different techniques 1.1 Simple distillation: Water + acetone 1.2 Fractional Distillation: Methanol + ethanol 1.3 Chromatography: Separation of mixture of Red ink and blue ink 2. purification of impure samples by crystallization 2.1 Copper sulfate 2.2 Potash alum 2.3 Benzoic acid
What properties should the stationary-phase liquid for gas chromatography possess?
In a reverse-phase separation, a solute was found to have a retention time of 19.6 min, while an unretained peak had a retention time of 1.45 min when the mobile phase was 20/80 v/v% methanol/water. (b) Calculate the k’ for the solute. (c) Calculate the new k’ if the mobile phase is changed to 60/40 methanol/water assuming identical void volume. (d) Calculate a solvent composition that would bring k’ from initial value to a value of 1.20 using tetrahydrofuran/water mobile phase rather than 20/80 v/v % methanol/water.