Into how many time zones are the United States and its territories divided?
Q: Determine the force in each member of the loaded truss. All triangles are equilateral with side…
A:
Q: The slotted arm OA rotates about a fixed axis through O. At the instant under consideration, 0 =…
A:
Q: A tension member is an L 150x90x8 connected to an 8-mm-thick gusset plate with 6-020 mm diameter,…
A: Answer We are given L 150 x 90 x 8 gusset plate thickness = 8 mm Fy = 248 Mpa Fu = 400 Mpa Bolt…
Q: i-Why is cool clinker interground with gypsum in manufacture of Portland cement? 2- Under what…
A: Since you have posted a question with multiple sub parts, we will solve first 3 parts for you. To…
Q: Practical Part Q.1) Answer any THREE of the following question. 1- What is the objective of standard…
A: NOTE:- There are multiple questions asked, please send one question at a time.
Q: elevation is 23.23 m at a distance of 54 meters from the point of curvature. The elevation of the…
A: Given:- elevation=23.23m d=54m elevation at point of curvature=22.56m Station 4+100m grade of back…
Q: QUESTION 40 Determine location (coordinate) of the centroid of the composite body shown. (X=0.0656…
A: Centroid or centre of gravity is the point inside the body of any object through which the entire…
Q: The hoisting system shown is used to easily raise kayaks for overhead storage. Determine the…
A:
Q: For a fully developed flow of water in a pipe having diameter 25 cm, velocity 0.2 m/s and kinematic…
A:
Q: I. Determine the thickness of Portland cement concrete pavement (PCCP) slab for the two-lane toll…
A:
Q: Concrete Technology/// Practicals.
A: Given: 2) Initial setting time.
Q: The natural frequency of the system
A: Given data, A simple mass-spring oscillatory system consists of a mass m. It is suspended from a…
Q: For the shaft shown, a. Determine the maximum stress on the shaft and the maximum angle of twist of…
A:
Q: A centrifugal pump is required to pump water to an open water tank situated 4 km away from the…
A: Answer We are given Length L = 4 Km =4000 m Pipe diameter d = 0.2 m friction factor f = 0.01 Speed…
Q: A reinforced concrete beam section is "b" wide and "h" deep. It is to be reinforced with the given…
A:
Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…
A: Determine the forces in members BE and CE of the loaded truss.
Q: All dimensions are in mm and the plate weighs 7.92 kN. Determine the tension in each cable. mm sion…
A:
Q: The rotating stepped shaft in the figure is produced from 85080M30 steel by machining method. It…
A: Stepped Shaft : Stepped shaft is made to deal with the different levels of stresses which are varies…
Q: A Problem #6: P W (KN/m) L b B
A:
Q: A W12x79 of A573 Grade 60 (Fy = 415 MPa) steel is used as a compression member. It is 8 m long,…
A: Given : A W12x79 of A573 Grade 60 (Fy = 415 MPa) steel is used as a compression member. It is 8 m…
Q: Determine the MAXIMUM SHEAR and MAXIMUM MOMENTS for using SHEAR AND MOMENT DIAGRAMS OR BY ANALYTICAL…
A:
Q: What is the definition of Admiral
A: This question is related to the Dock, Harbour and Airport Engineering
Q: Two straight lines AB and BC intersect at a chainage of 510.23m, the angle of intersection being…
A:
Q: 4- List and explain methods of manufacturing of ready mixed concrete.
A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…
Q: i. ii. -8 in. B 100 lb -12 in. -8 in. 60 lb Derive equations for the shear force V and the bending…
A:
Q: 3- Explain various factors affecting workability of concrete. 4- Explain the factors which effect on…
A: 3. Factors affecting workability of concrete water content : increase in cement content of concrete…
Q: A singly-reinforced rectangular concrete beam of width 300 mm and effective depth 400 mm is to be…
A: given- B=300 mmd=400 mmM25 7 Fe500
Q: Submit your question to our 24/7 subject matter experts with Masters and PhDs and get a solution in…
A:
Q: NOTE: COMPLETE SOLUTION. SHOW ALL OF THE FREE BODY DIAGRAMS USED. Determine the maximum shear and…
A: Find maximum shear force and maximum bending moment.
Q: A sailboat moving in the direction shown is tacking to windward against a north wind. The log…
A:
Q: 5-Why is compaction necessary to concrete? 6-Explain effect of sea water on concrete. 7-What…
A: Concrete: It is a term used to indicate the paste formed by the addition of water in specified…
Q: Q1: A cruciform consists of two sections. The thickness of the black section is t, and the thickness…
A:
Q: h PI P2 HY B a - a I P3 G C a P4 L a) Determine the reactions at the supports A b) Using the method…
A:
Q: 2.) The weight of the block of wood in the figure below is 96.5N. The coefficient of static friction…
A: Weight of the wood block, w = 96.5 N friction between the block of wood and vertical wall, u = 0.45…
Q: 4m 4m Problem #8: 3m 5KN 3m B 1.5m 8KN 1.5m C 2m 2m
A: Find support reaction. Joint B is pin joint so moment from either side of is zero.
Q: Activity No. 2 Problem No. 1: Determine the reactions at the supports A and B of the compound beam.…
A: Determine the reactions at the supports A and B of the compound beam.
Q: A stream of traffic moving at a speed of 40km/h and a concentration of 20veh/km is stopped for…
A: Note: As per guidelines policy, I have answered 1st 3 sub-parts only.If you need remaining…
Q: prestressed concrete beam in below Fig, is 32 ft long and has a rectangular cross section of 15 in.…
A:
Q: Water flows out the 23-mm-diameter pipe, it strikes the vane, which is moving to the left at 1.5…
A: Given data:- The water flows the diameter of the pipe, d= 23 mm=0.023 m The area of the pipe,…
Q: Oil (SG = 0.91) enters at section 1 as shown, at a weight flow of 500 N/h to lubricate a thrust…
A:
Q: Use Method of Consistent of Consistent Deformation to solve the horizontal reaction at D in kN of…
A: Truss: Truss is a pin jointed structure which is subjected to vertical loading at the joint only and…
Q: Groundwater flows through an aquifer with a cross-sectional area of 1.0 x 104 m² and a length of…
A: Given data- Cross section Area A=104 m2Length of aquifer L=1500 mHead difference H=50 mDischarge…
Q: A copper plate, with dimensions of 3 cm × 3 cm × 5 cm (length, width, and thickness, respectively),…
A: Given:- 3 cm × 3 cm × 5 cm (length, width, and thickness, respectively thermal energy source that…
Q: Problem No. 2: Determine the horizontal and vertical components of reaction at the supports A and C.…
A: Please note that the Force F BC will be at slope of 3 - 4 - 5
Q: Determine the MAXIMUM SHEAR and MAXIMUM MOMENTS for using SHEAR AND MOMENT DIAGRAMS OR BY ANALYTICAL…
A:
Q: a = i ft/sec²
A:
Q: Two 150 mm x 300 mm concrete cylinders with randomly oriented steel fiber contents of 0 and 2% by…
A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…
Q: Which of the following are characteristics of a confined aquifer. Select all that apply. This…
A: This question is related to the Soil Mechanics from Civil Engineering. In this question, Ask about…
Q: Determine the peak runoff rate of a 70-hectare forest with matured woodland with a rainfall…
A:
Q: A Y-shaped tube is inserted upside down so that the left foot and right foot are immersed in two…
A: Given- density of first liquid ρ1=0.80 g/cm3density of second liquid ρ2=0.75 g/cm3height of the…
Into how many time zones are the United States and its territories divided?
Step by step
Solved in 2 steps
- 8.1 Create a calendar showing the beginning and the end of daylight saving time for the years 2025-2031. Year 2025 2026 2027 2028 2029 2030 2031 Daylight Saving Time Begins at 2:00 a.m. Daylight Saving Time Ends at 2:00 a.m.13. If you walked north along one of Earth’s lines of longitude until you had changed latitude by 1 minute of arc (there are 60 minutes per degree), how far would you have walked (in miles)?How high can vehicle exhaust gas (pollutant particles) climb in terms of altitude?
- Create a calendar showing the beginning and the end of daylight saving time for the years 2016–2022.4. Calculate the following conversions: b. If the longitude of a place is 125°13'15", what is the local time at the place when the standard time is 13'42"17 on 13 June 1986?How can we measure air and noise pollution
- 25. Four of the light bulbs in a box of ten bulbs are burnt out or otherwise defective. If two bulbs are selected at random without replacement and tested, what is the probability that exactly one defective bulb is found? O 24/90 O 30/90 O 12/90 O 48/90 0 耳 の P. W Type here to search hp &Consider the following data for 120 scholars of Fountain International School in San Juan City. How many scholars are studying exactly one language? a.56 b.36 c.60 d.152A 250-gallon fuel oil tank has 100 gallons of fuel left in it. What percent of thetank is full?