ra to take a picture of the bird? Round your answer to nearest deg -correct response: degrees degrees degrees degrees

Q: ROD READING INSTRUMENT MIDWAY INSTRUMENT SET-UP NEAR B BETWEEN A AND B A 2.07 m 3.43 m B 0.23 m 1.65…

A: Let us take a = 2.07m, b = 0.23m, c = 3.43m, d = 1.65m  Solution:-  A. True Difference in Elevation…

Q: Problem A) A rod of mass M and length l moves across a frictionless surface with a speed v. It hits…

A:

Q: To perform a standard penetration test, a hammer of 140 lb should be falling from 'to be valid. O 20…

A: SPT is used determine relative density , Bearing capacity of soil . To perform a standard…

Q: [Exercise 1] Measure the height difference between points A and B with a level instrument. It is…

A: Elevation of point A (Ha) = 12.658 m Centre cross reading at point A = 1526mm Centre cross reading…

Q: What is the correct way for me to report (50kN)(60nm)

A: Correct way to represent kilonewton (SI unit of force measurement) is kN.so, 50 kN is correct.

Q: incorrect please recheck i did the same method and got it incorrect , the book answer is 78.48kn

A: A vertical Sluice gate width = 2m                                  depth = 2mUpstream side water…

Q: What is the flow in (ft³/s) through an 8-ft Parshall flume when Ha-2.50 ft assuming there is no…

A: Throat width ftFlow depth in converging section Ha=2.50ft Flow through the Parshall flume

Q: 5/18 Determine the x-coordinate of the centroid of the shaded area. y 2a 0 r = k₁+ k₂0 a Problem…

A: A shaded area is given:- The value of r = k1 + k2 ×θ r = a when θ = 0 r = 2a when θ=π2 To…

Q: 2. 3" 3"

A:

Q: Rainfall intensities during each 30 minutes of a 150-minute storm are presented in the table below.…

A:

Q: free-body diagram. Yo

A:

Q: If A1=230 sf and A2=310 sf, and the distance between cross sections is 100 ft, what is the…

A:

Q: Ex-4: Convert (324.46259) to degrees, minutes, and seconds.

A: conversion of 324.4625 to degree minutes and seconds

Q: Determine the Tension in the cord

A:

Q: (a) Locate the centroid andỹ of the shaded area. Given, h (20+ last digit of your ID) cm y 40 cm h

A: Consider the free body diagram; Calculate centroid of area BCD from y-axis x1=23×80x1=1603cm…

Q: Question 26 A cut is to be made in a saturated clay, as shown in the figure below. The cut slope…

A:

Q: A vertical curve on a roadway has a BVC at station 23+00 and an elevation of 900.00'. If the EVC is…

A: Given data: BVC station=23+00 EVC station=33+00 g1=4.00% g2=-3.50% Elev at station 29+00=?

Q: Question 12 of 14 > - /5 View Policies Current Attempt in Progress Determine the coordinates of the…

A:

Q: A soil sample has a volume of 0.07 ft^3 and a total weight of 9.10 Ibs. After oven dried, the soil…

A:

Q: Part A What error results on a 200-ft sight with a level if the rod reading is 11.307 ft but the top…

A:

Q: please answer only if it is correct. will thumbs up if correct.

A: To delineate the watershed boundary for Lynn Camp Run, you would follow these steps:Identify the…

Q: Convert to degree minutes and seconds (DMS): -132.8043°

A: Surveying Degree Minutes Seconds

Q: (a) By observation, determine zero force members of the bridge shown in Figure 2.1 (No calculation…

A: I

Q: ! 4.2. A 16 ft wide sand bed stream (Sf=0.002, n'= 0.015, with smooth channel banks) has the…

A:

Q: Please only answer if sure it is correct. will thumbs up if correct!

A: the solution is provided in the image thank you.Explanation:

Q: (400 gpm). 16. Determine the maximum steady-state pumping rate in Ips (gpm) for a 305-mm (12-in.)…

A:

Q: Which of the following is a simple measuring instrument used to indicate the projection of the end…

A: Plumb bob- It is a device used in surveying to mark the position of object center on the ground…

Q: Problem Statement Based on Problem 5-87 from the textbook. Both pulleys are fixed to the shaft and…

A:

Q: This type of error occurs when you use a level that is not calibrated and the bubble level is not on…

A: Levelling instrument is used in surveying to get a horizontal plane with respect to the level…

Q: Draw the shear and moment diagram of the loaded beam shown below and determine the maximum moment…

A: GIVEN:

Q: Consider the following data with respect to the design of flexible pavement: • Design wheel load =…

A:

Q: Determine the composite SCS runoff curve number for a 600-acre basin that is entirely in Soil Group…

A: Area (A) = 600 acre 50% straight row crop has CNsr = 81 50% meadow has CNm = 58 Determine the…

Q: Soils with a particle size of retained on sieves #4 and above are collectively known as O gravels…

A:

Q: A ballon with density 1.46 kg/m³ and volume 4 m³ descends in a fluid with density 0.96 kg/m³.…

A:

Q: 5.43 What is alkali-silica reactivity? What kinds of problems are caused by ASR? Mention two ways to…

A: Alkali Silica Reactivity Alkali-silica reactivity (ASR) is a chemical reaction that occurs between…

Q: To determine the stud spacing (maximum span of the plywood), assuming a uniform load of 712.50 pst…

A: 3/4'' BB-OES plywood. Uniform load= 712.5 psf To determine- Stud spacing (maximum span of the…

Q: The frame is made from pipe that is fixed connected. If it supports the loading shown, determine the…

A:

Q: Find: Moments of inertia Iu and Iy

A:

Q: Problem 4: Determine the reactions for the given beam: 85N 200 /m I5m Gm 6m

A: To find support reaction

Q: determine the height of a pole above the ground on the basis of following angles of elevation from…

A: Given: The horizontal distance ab is 30 m. The height of the instrument at a is 1.48 m. The height…

Q: 1) Determine the moment of inertia for the shaded area about the x and y axis

A:

Q: Continued the above question: A soil sample is tested. Its minimum dry density=96 pcf and maximum…

A:

Q: Calculate the moment of inertía of the shaded area about the x-axis. 76 mm 26 mm – 46 mm →-46 mm…

A:

Q: In the two-peg of a dummy level, the following observation are taken.   Rod Reading on A Rod…

A:

Q: Determine the x-andy-coordinates of the centroid of the shaded area. 12 Answers: (X.)-( -13- Jin

A:

Q: Staff reading taken on a benchmark or a point of known elevation is called A. Any one of these B.…

A: Staff reading taken on a benchmark or a point of known elevation is called Back Sight reading.…

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.