Which of the following is an incorrect way of measuring the volume of liquids from volumetric glassware?ATilt the volumetric glassware to position your line of sight to the bottom of the liquid's meniscus.B) The volume of liquid is read at the bottom of its meniscus.Record the volume of a liquid in volumetric glassware using all certain digits plus one uncertain digit.D) Position eye horizontally at the bottom of the meniscus to read the level of the liquid.

If you will tilt your volumetric glassware it definitely gives you error result of your…

Answered: incorrect way of measuring

Science

Chemistry

incorrect way of measuring

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 123CP: Sterling silver is a solid solution of silver and copper. If a piece of a sterling silver necklace...

See similar textbooks

Related questions

Q: A student follows the following protocol for making a kinetics lab solution. mL 0.0165 M KBrO3 mL…

A: Given: The volume of 0.0165 M KBrO3 is 3.00 mL. The volume of HCl, water, and KI is 4.00 mL, 1.00…

Q: ol ini ne baall nael gnblnklo nohanimsis qu odi gairesl moit anodavede uoy bo her shee Data Analysis…

A: In the given question we have to determine the limiting reactant of the following Reaction mixture.

Q: Is paper clip steel more dense or less than water

A: Is paper clip steel more dense or less than water.

Q: The concentration of glucose in an aqueous solution can be determined by oxidation with ferricyanide…

A: Given Glucose mg/ml Absorbance 5 0.132 10 0.290 20 0.498 30 0.642 40 0.750

Q: Multiply or divide the following measurements. Be sure each answer you enter contains the correct…

A: Answer: In case of multiplication and division, least number of significant figures in any digit…

Q: TITRATION DATA In the next part of the experiment, you used the standard solution of sodium oxalate…

A: The given reaction is, 2 MnO4-+5 C2O42- + 16 H+ →2 Mn2+ + 10 CO2 + 8 H2O Given that: Molarity of…

Q: A patient is prescribed Nexium as an I.V. infusion in 5.00% dextrose solution. The dose to be…

A: Answer~

Q: What is the SI unit of volume? What is the other common unit which in notan SI unit of volume.

A: The SI unit of volume is m3

Q: What would you multiply "grams of calcium" by to get the units "atoms of calcium" ? (number) (unit)…

A: Avogadro's number is the number of units in one mole of any substance equal to 6.022×1023. The units…

Q: Given that K, is 7.5x10-3 (aq) for R-NH3* (aq) + H20(1) R-NH2(aq) + H3O* (where R - is a carbon…

A: Given :: Ka = 7.5×10-3 pkb = ?

Q: Gravimetric means (volume measurement jor: the component to be analyzed .A True .B False .C .D

Q: When doing percent error do the estimated value and true value need the same amount of sig figs or…

A: The true value and the experimental values are calculated under different experimental conditions…

Q: Part B: Heat of Solution Name A) For NaOH Volume of H2O used Note: density of water, dH20 = 0.997…

A: Concept ∆Hsoln=qnwhere q= heat of the solutionn= moles of solute

Q: Initial buret reading (A) = Final Buret reading (B) = Total volume used =

A: initial burette reading=9.6ml final burette reading=24.1ml

Q: PLEASE make sure sigfigs and rounding are correct.

A: Here is a graph of the pressure of dinitrogen dioxide (N₂O₂) in a reaction.,

Q: has an equal probability of being random systematic tends towards being either cannot can Random…

A: Random error causes one measurement to differ slightly from the next. It comes from unpredictable…

Q: Which of the following is the correct sequence of weighing using an analytical balance? I. Press…

A: The steps given are,

Q: Which of the following is the correct sequence of weighing using an analytical balance? I. Press…

Q: kg The density of isopropyl alcohol is known to be 786- m³ density in the units of mg ml Determine…

Q: Why are percent error values never negative?

A: The percent error is given by: percent error=|(experimental value-theoretical value)/theoretical…

Q: I only need Delta Shorthand Notation and Omega Shorthand Notation

A: The Delta shorthand notation is given as follows: Counting total number of carbons from the…

Q: Stock or starting Serial dilutions done Total dilution factor Final concentration concentration…

A: For first we are provided starting concentration and total dilution factor. We are required to find…

Q: ound 0.221 to one sig. Fig

A: To round to a significant figure: look at the first non-zero digit of rounding to one significant…

Q: Is the precision of your two trials within 5 %? This means is your % average deviation <5 %. Support…

A: Given that

Q: Define the term unit conversion problems?

A: Unit conversion: It is defined as the conversion of units of some measurements into another units.…

Q: From Experiment Correct Value % error Cs,metal |(J/goC) 0.2335 0.400

A: The given data is :

Q: Which of the following represents the correct use of an internal standard (IS) in a quantitative…

Q: How to determine the number of significant figures when computing percent error? Is it based on the…

A: Percent error is given by

Q: The SI standard unit for mass is the gallon Newton kilogram mole

A: The SI standard unit for mass is the

Q: Give the correct standard line notation.

A: While writing a standard line notation for a cell, the species undergoing oxidation are represented…

Q: What is the si unit for the mass of flour

A: The International System Of Units abbreviated as (SI) is defined as a metric system which is used as…

Q: Rounded to the correct number of sig. fig.

Q: 1. Change 125 mL of a gas at 25.0°C to standard temperature.

A: Dimensional Analysis Method can be defined as the method helpful in solving problems that uses fact…

Q: The van der Waals equation of state was designed (by Dutch physicist Johannes van der Waals) to…

A: Given: Vanderwalls equation is : P+an2V2 × (V-nb)=nRT Where, a and b are the corrective factors.…

Q: 1. OThe balance should be kept clean. 2. ONever weigh an object heavier than the capacity of your…

A: An analytical balance is used in chemical laboratories to measure the weight of the reactants in…

Q: at Error d)

Q: Provide the correct IUPAC name for the compound shown here.

A: The given compound is We have to give the IUPAC nomenclature of the given compound.

Question

Which of the following is an incorrect way of measuring the volume of liquids from volumetric glassware?
A
Tilt the volumetric glassware to position your line of sight to the bottom of the liquid's meniscus.
B) The volume of liquid is read at the bottom of its meniscus.
Record the volume of a liquid in volumetric glassware using all certain digits plus one uncertain digit.
D) Position eye horizontally at the bottom of the meniscus to read the level of the liquid.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Since oil floats on water, what can you say about the relative densities of oil and water?
The freezing point of water is _________ K.
You have a 1.0-cm3 sample of lead and a 1.0-cm3 sample of glass. You drop each in separate beakers of water. How do the volumes, of water displaced by each sample compare? Explain.
Draw a particulate-level sketch of a heterogeneous pure substance.
Classify the following as homogenous or heterogeneous: aThe contents of the beaker on the left in the photograph bThe contents of the beaker on the right in the photograph cReal lemonade made by squeezing lemons and adding sugar and water dBeach sand
Use a molecular level description to explain why gases are less dense than liquids or solids.
Single term for liquids and solids phase. The distances of particles in solids and liquids are more compressed as compared to gases.
Water and laundry detergent are mixed together, with detergent molecules dispersing uniformly throughout the liquid. This is an example of a A) mixture of elements B) heterogeneous mixture C) homogeneous mixture (solution) D) molecular compound
Please answer 1 Part A and C
give a particulate-level explanation of why ice (solid water) is less dense than liquid water?
[answer with correct answer] Water exists as a solid (ice), a liquid and a gas (steam). Which state of matter will water be when it is easiest to compress?
What is the scientific method answers to the freezing point of water