In transformer, the power will wi th decrease in current. O be doubled O decreases remain same O increases

Q: test is used to measure the iron losses of the transformer. A6

A: We need to tell about name of test which is used to measure iron losses.

Q: What kVA rating is required for a transformer that must handle a maximum load current of 8 A with a…

A: As it is given that, the maximum load current is 8A on secondary side of transformer. And the…

Q: Three coils each having resistance of 14 0 are connected in delta across 414 V, 50 Hz supply. Then…

A:

Q: Wi8 = W19/ (R3 /21,B, +1) = 10µ/(2k*V(200µ*2m)+1) = 51.3 µm. %3D . ono+ the tro nsistors Mɔ,

A:

Q: Defermine the branch aurentz in the netwoarks. 152 A AMA 1ov to

A: In this question we will find branch currents...

Q: 1- Connect a Full Adder using two half adders & OR gate ,then fill the table below CN-1 A B Q CN 0 0…

A: One manipulation you do just in the variable not in concept. I took Cout in place of CN  & Cin…

Q: What kVA rating is required for a transformer that must handle a maximum load current of 8 A with a…

A: If you are having doubt in any step please comment here. Thank you

Q: 21 It 580 Ohm 5.136 uF 390 Ohm 0.859 H 12 E 220 Ohm 30 VISO H20 Deg 330 Ohm 22 14.475 uF 1.49 H

A:

Q: Find the equivalent total resistance

A:

Q: For the following circuit if the secondary voltage of the transformer is 20V max, the output voltage…

A: given here a electrical circuit and asked to find the output voltage.

Q: Calculate average load voltage of the circuit if C=0 and a = 5 and RL= 470 ohms. 中 220V GOHZ DI C R…

A:

Q: R R; 42 12 B, 28 V 7V – B, FIGURE A USE CLOCKWISE DIRECTION for ALL your loop current, refer to…

A:

Q: show that in a mass T= 2T M शा, K Spring System

A:

Q: Determine the maximum load current of a certain transformer rated at 48K VA if 1200 V is on the…

A:

Q: In cables, the insulation is depended upon_ O current O resistance O voltage

A: Insulation of cable is generally made up of dielectric material that means insulation is totally…

Q: * For the following circuit if the secondary voltage of the transformer is 20V max, the output…

A: We need to select correct option for output voltage for given circuit

Q: Three coils each having resistance of 30 Q are connected in star across 427 V, 50 Hz supply. Then…

A: total power consumed = 3×Phase voltage2Resistance for star connection, phase voltage = line voltage3

Q: A transformer having 100 primary turns is connected to a 400V a.c supply. For a secondary voltage of…

A: Transformation ratio, k = V2V1=N2N1 where, V2 = Transformer secondary voltage = 800V V1 =…

Q: ROV Vn V16₁ V₁ cating related voltage/current levels 4. (a) Draw wave Extra: Computo values of…

A: Given: In this question, the given details are, a) To draw waveforms as applicable indicating…

Q: 22.6 Equivalent Circuit (Iron- core Transformer) Ep 10/11 www moo Rp www Rp2 N N 000 ell 000 Xs www…

A: Given circuit:Asked to find the total impedance and total resistance of the transformer?

Q: Design a schematic for a main transformer for a lathe according to the following request Number of…

A: To design a schematic for a main transformer for a lathe according to the following request, Number…

Q: device may be used for extending the range of voltmeter . O shunts O series multiplier current…

A:

Q: This is the most important sector in the power industry. O Transmission O All of the sectors…

A: The explanation for the important components of a power system is as follows.

Q: Find the value of the v across 6H

A:

Q: 2. Determine the inductance at terminals A-B in the network in the follow diagram: ' 1mH 1mH 2mH…

A: In this question we need to find a equivalent inductance between the two terminal of the given…

Q: What are the branch currents, 12 and 13? R₁ 4 kOhm

A: Given, I2 = ? I3 = ?

Q: What kVA rating is required for a transformer that must handle a maximum load current of 8 A with a…

A: GIven the maximum load current and secondary voltage and required to find the kVA rating.

Q: Testing Stage 1--- L1 only Peak-to-peak voltage across the 1kQ resistor is measured as Vg=2V.…

A: Answer 1:  Testing stage 1  Although current flowing through resister is  iR=VRRiR=21×103iR=2…

Q: govt Find Nx and i ata 902 13F str t 301 0.5i ·505

A:

Q: If the supply frequency to the transformer is increased, then the iron loss will be

A: The transformer is used to step up or step down the input voltage. In power system, the transformer…

Q: Is N1 (N2 = 140 turns) 42 0.66 A 84 1.285 A 112 1.645 A 140 1.917 A

A: The given table of the secondary short circuit current and the number of turns in the primary coil…

Q: be closed is: * A 3 15V De 12 5 A O 2 A О ЗА

A:

Q: Full explain this question very fast solution sent me step by y The transformer has a turns ratio…

A: given that full wave bridge rectifier with input transformer input voltage  V = 120 V (rms)…

Q: What is the value of I2

A:

Q: B = 0.25 T to the right l = 2 m i = 1.5 A Figure 2(c)

A: We need to find out force on current carrying wire placed in magnetic field .

Q: what is the current of welding is to set for weld the 3.2 mm metal thick O a. 50-90 Amperes O b.…

A:

Q: The primary of 200/1 A, 5 VA, 0.8 pf current transformer carries 100 A. The secondary current is…

A: It is given that: turns ratio or nominal turns ratio, K=2001VA=5cosϕ=0.8 pfIp=100 AIsec=0.495 A

Q: Lighting loads can be powered easily by transformer connection. O Delta-Star O Scott O Star- Delta O…

A: Given that Lighting loads can be powered easily transformer connection.

Q: Determine the voltage in the secondary as the case may be and mark the transformers with the…

A: The given figures of the ideal transformers are shown below. We need to determine the voltage in…

Q: For the following circuit, 1) Determine the mathematical expressions for iL and vL following the…

A: Both the parts of the given question have been explained in detail. If any doubt please feel free to…

Q: 20 та 5 чка we + vo s5 ка Find Vo I+

A:

Q: 11. A transformer with a ratio of 10 has a primary current of 50A, what is the secondary current?…

A:

Q: Question 7 The magnetic force acts on the wire 1 -5 cm- 20 A 15A 10 cm 2 cm None of the choices…

A: Find the force due to current I1 to the rectangular coil.

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.