In the transformer shown in the figure below, the load resistor on the right-hand side, RL , is 50 Ω. The turns ratio N1 :N2 is 5:2, and the average source voltage on the left-hand side, Vs , is 80 V. If the average voltage across the load resistor RL is 25 V, what is the source resistance, Rs , on the left-hand side?

Q: What is the reading of an AC voltmeter placed across a 50.0 Ω resistor, which carries a current i =…

A:

Q: See the attached picture of an RLC series circuit. Power supply voltage is  given as v(t) =…

A: f=ω2π = 71.619 s-1 Inductive Reactance, XL : 2πfl = 202.497 ohm Capacitive Reactance, XC : 12πfC=…

Q: An AC voltage source, with a peak output of 262 V, is connected to a 33-2 resistor. What is the rate…

A:

Q: A coil of inductance 120 mH and unknown resistance and a 1.0 μF capacitor are connected in series…

A: In electrical circuits, resistance measures how much current is opposed by the current flow. Omega…

Q: At its highest temperature, a space heater has a resistance of 47.5 ohms when it is plugged into a…

A: The average power output of the heater is;Pavg​=278.30WExplanation:Step 1:Step 2:

Q: The AC EMF in this electric circuit is described by the following equation: € = 30Ve¹(20)t What is…

A:

Q: Given an ideal transformer connected to a V1 = 260 V AC source supplying a V2 = 14 V on a device.…

A: Given: V1=260 VV2=14 V

Q: nswer the question 11 .  ?

A: Given that the ratio of the energy stored in a capacitor to the total energy id 0.20= UcUtotal= 0.2

Q: An AC source with AVmax=15.0 v operating at 55.0 Hz is driving the RLC circuit depicted in the blue…

A:

Q: A 60-Hz AC generator develops a peak voltage of 170-V. The generator is connected to a lightbulb…

A:

Q: An AC voltage source, with a peak output of 200 V, is connected to a 50-W resistor. What is the rate…

A:

Q: Group A: Connect a Series dc circuit consists of: R1= 5.6 KQ R2= 6.2 KQ R3= 7.5 KQ E = 10 v…

A: For a series combination current is constant but the Voltage is distributed based on the resistance…

Q: A device has an average power rating of 1250 W and is designed to operate using a 211 V (RMS) line.…

A: Given  average power rating of a device (Pavg)=1250 w rms voltage (Vrms)=211 volt Required…

Q: A 25.0 mH inductor, a 2.00 microFarad capacitor, and a certain resistor are connected in series…

A:

Q: high‑voltage discharge tube is often used to study atomic spectra. The tubes require a large voltage…

A: Given Transformer is connected to a line Voltage of 120 V and designed to provide 3100 V rms to…

Q: The circuit is in DC steady state for this and the next few questions: all of the circuit quantities…

A:

Q: You connect a 250-Ω resistor, a 1.20-mH inductor, and a 1.80-μF capacitor in series across a…

A:

Q: The following graph shows the voltage and current through a single circuit element where Vy-73.0V,…

A: Given: The peak voltage of the circuit is Vp = 73 V The peak current in the circuit is Ip = 2.2 A…

Q: Phasors and alternating current. A 200 resistor is connected in series with a 4.00 µF capacitor and…

A: Given, v_{A} = (5.00V) cos [(800rad / s) * t] Capacitance=4.00 µF

Q: I want to solve this problem step by step   1.  Switch mode DC / DC Converters. a.  Design a flyback…

A: To design a power converter with the given values Consider the given values The given power…

Q: In the DC circuit below, all resistors are 20 2. ɛ1 = 100V, ɛ2 = 50V %3D R E2 R R R R (a) for this…

A: Given, An Electric circuit

Q: An engineer wants to build a series resonant circuit which will resonate at 107.3MHz. He uses a 22nH…

A:

Q: Consider an RLC Circuit connected across an AC source as shown below. The current in the circuit is…

A:

Q: Phasors and alternating current. A 200 resistor is connected in series with a 4.00 µF capacitor and…

A: Solution:-

Q: I don't understand why Rint is in series with Req. I feel like they are in parallel after you've…

A: The detailed solution is following.

Q: A 60 µF capacitor is connected to a 110 V, 60 Hz a.c. supply. Determine the rms value of current in…

A: Given that,Capacitance : C = 60 (μF)RMS value of voltage : V = 110(V)Frequecncy of AC supply : f=60…

Q: = 2.00 x 105 V cos [(800 rad = 2.00 x 105 V cos [(800 rad

A: Given, Resistance = 200ohm Capacitance = 44μF voltage across the resistor as, = VR =…

Q: A 60 µF capacitor is connected to a 110 V, 60 Hz ac supply. Determine the ms value of the current in…

A: Given that - Capacitance of the capacitor C=60 μF Voltage Vrms=110 V Frequency f=60 Hz The formula…

Q: Given a series circuit with total voltage of 15, R = 7 2, R2 = 4 Q, and R3 = 2 Q. Find the V2.

A:

Q: In the alternating current circuit shown in the figure, the voltmeters and amperemeter are…

A:

Q: RLC series circuit with V(in) (t) = 12cos (1000t), R = 1 ohm, C = 100uF , L = 2.5 mH . Please use…

A:

Q: A 100-mH inductor is connected to a 110-Vmax ac source at a frequency of 30 kHz. The max current in…

A:

Q: Resistors 30 Ω,60 Ω, and 90 Ω are in series with a 60 V source. What is the induced emf of the 60 Ω…

A:

Q: An RC circuit has a 5kΩ resistor and a 1μF capacitor. This circuit is driven by a 100Hz sine wave…

A: Given : Resistance  R = 5 kΩ             Capacitor C = 1 μF             Frequency f = 100 Hz…

Q: An ideal transformer is used to either increase or decrease the voltage in an AC circuit. When the…

A: Scenario - An ideal transformer uses mutual induction principle to induce voltage on secondary coil…

Q: At its highest temperature, a space heater has a resistance of 43.5 Ohms when it is plugged into a…

A:

Q: The AC EMF in this electric circuit is described by the following equation: E = 40Ve(20)t What is…

A: XL=inductive reactance=W×L Z'=impedance

Q: An AC voltage source at 7.3 rad/s is connected to a 1.2 ohm resistor connected in series with a 7.7…

A:

Q: A battery is connected to a series RL circuit at time t= 0. At what multiple of t will the current…

A:

Q: Consider a series RC circuit as in Figure below for which R =1.8 MO, C=1.8 µF, and ɛ=30.0 V. Find…

A: Given data-R=1.8 MΩC=1.8μFε=30.0 VQ=?

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.