For the transformer in the picture, determine: The transformer ratio, Np/Ns The secondary voltage, Vs The secondary current, Is The primary current, Ip| The power to the load, Ps V mA mA W NP 100 turns Is lp VP = 110V RL 20 k Ohm NS 500 turns

Q: Evaluate the advantages and disadvantages of transmitting power by AC and DC and the implications…

A: Advantages of AC Transmission:Efficient over Long Distances: AC transmission is more efficient over…

Q: At what velocity (in revolutions per minute) will the peak voltage of a generator be 490 V, if its…

A: peak voltage of the generator is  = 490 VN = 495 turns diameter d = 8 cm = 0.08 mB = 0.250 T

Q: You have a transformer with a primary current of Ip = 15 A and a primary voltage of Vp = 2050 V. The…

A:

Q: nas ). The output voltage of the generator is 4.50 kV. (a) What is the line loss if a transformer is…

A: GivenResistance per unit length=4.3×10-4 ΩmPower Tansmitted, P=5 MW=5×106 WLength over which power…

Q: A step-down transformer has a turns ratio of 1:10, and its primary is connected across the terminals…

A: If a voltage 'V' is applied across a resistance 'R', then the power dissipation in that resistor is:…

Q: 8. A pair of power transmission lines each have 2.50- resistance and carry 650 Amp. If the primary…

A: R = 22.5 I = 650 A vp = 2.4 kv Step of transformer      Vs / Vp = 10/1 Vs = Vp × 10 Vs = 2.4 × 10 =…

Q: What is the potential difference across a 23.2_mH indüctor if the current 514 mA to 313 mA in 11.8…

A: Given: Inductance of the inductor L = 23.2 mH Drop down in current ∆i=514-313=201 mA Time ∆t=11.8 μs

Q: For Transformer winding1 N131000 turns, N2= 200 turns and V1=220 Volts, secondary resistance of 22…

A: Solution:-Given thatFor Primary windings;N1=1000 turnsN2=200 turnsV1=220 voltsFor Secondary…

Q: A scale train transformer is plugged into 120 V ac and draws 0.35 A while supplying 7.5 A to the…

A:

Q: A transformer has a turns ratio of 2.5:1 the primary voltage is 208V what is the voltage of the…

A:

Q: A transmission line that has a resistance per unit length of 4.30 x 104 n /m is to be used to…

A:

Q: A series RL circuit is connected to an emf source of angular frequency @. The current O is zero. @R…

A: Here is the step-by-step explanation:Step 1: Key Concepts:​A. Inductive Reactance (XL)In a series RL…

Q: A portable x-ray machine is designed to operate on normal 110V AC power.  Its maximum capacity is…

A: Voltage, V1 = 110 VVoltage, V2 = 110 KV = 110000 VCurrent, I = 100 mATurn ratio, N2/N1 = ?

Q: For the LR circuit shown below, L = 2 mH & ? = 3 ms. The switch is closed and 5.25 ms later the…

A:

Q: Give an example of an electrical device that runs on DC. Explain how the device has to be adapted so…

A: Example of an Electrical Device that Runs on DC Device: LaptopA common example of a DC-powered…

Q: For the LR circuit shown below, L= 30 mH & r = 4 ms. The switch is closed and 6 ms later the current…

A: Given :  L = 30 mah  Time constant = 4 ms Time (t) = 6 ms  Current = 0.15 A

Q: 100 A of rms current is incident on the primary side of each transformer. Rank the transformers on…

A: Ip = 100 A (rms current on primary side)

Q: A transformer has a primary coil with 360_turns and a secondary coil with 5600_turns. If the voltage…

A:

Q: For Transformer winding1 N1=1000 turns, N2= 200 turns and V1=220 Volts, secondary resistance What is…

A: Hey dear this is very simple problem. I have firstly calulated V2 and then I2 and the primary…

Q: An RL series circuit has the following components: 5.0-mH coil, 1.0-W resistor, What is the time…

A: