In the system shown, the mass at A is 10 kg and that at B is 5 kg. The mass-moment of inertia of the pulley about point C is 8 kg.m?. At the instant shown, mass A is moving downwards at 5.3 m/s. Find the total kinetic energy of the system. Neglect friction. Write your answer in Joules but do not write the units.

In the system shown, the mass at A is 10 kg and that at B is 5 kg. The mass-moment of inertia of the pulley about point C is 8 kg.m?. At the instant shown, mass A is moving downwards at 5.3 m/s. Find the total kinetic energy of the system. Neglect friction. Write your answer in Joules but do not write the units.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Prelab Exercises for Angular Motion 1. Draw a free-body diagram for mass M, while in motion (Fig.…

A: To Draw : The free body diagram for and centrifugal force.Given :

Q: 4. A bullet of mass m = 2 grams is moving horizontally with a speed of 500 m/s. The bullet strikes…

Q: V mg Sw mg 2. A drone of mass m (shown above) moves with a horizontal velocity v and is propelled by…

Q: moment c Angular velocity

Q: 4. A 42.0 kg solid cylindrical shaft, of uniform density and thickness, starts from rest and rolls…

A: The given information in the problem is shown in the following attached image:

Q: Q2. Mechanism on a slippery slope. Two uniform bars AB and BC, each of mass m, are connected to each…

Q: *The rod shown weighs 100N. The rod falls from the position shown. Determine the kinetic energy of…

Q: rotor of a turbojet engine has a mass of 250 kg and a radiu f 12000 rpm in the clockwise direction…

Q: An automobile driver took a curve too fast. The car spun out of control about its center of gravity…

A: Cars deceleration,

Q: m Review Problem: The figure above shows a "conical pendulum." Its a pendulum that maintains a…

A: The free-body diagram of a conical pendulum is drawn below. Here, T represent the tension.

Q: Determine kinetic energy of a 10 lb mass moving at a velocity of 5 ft/sec. Provide your answer in Ib…

Q: 3. A 2-kg ball S is moved in the vertical plane by a robotic arm. When 0= 30°, the angular velocity…

A: Data given- m = 2 kg θ = 30° r = 1 m r• = -0.5 m / s r•• = 0 Taking counterclockwise as…

Q: 1) Three small spheres are rigidly mounted to a horizontal shaft with rotates with angular velocity…

A: Due to rotation of shaft there will be centrifugal forces acting outwardly on the masses m2 and m3.…

Q: Four masses m1, m2, m3 and m4 are 10 kg, 20 kg, 30 kg and 40 kg respectively. The corresponding…

Q: Cart A weighing 120 lbs has a hanging mass B weighing 45 lbs attached to it by a 7 ft cable. The…

Q: 2. Angular momentum conservation | h h' A ball with mass m hits a racket with mass m, at a speed of…

Q: The cable spool shown at the right has a weight of 50 lbs and has a moment of inertia of .28…

A: Given Weight, m = 50 lbs Tension, T = 50 lb Moment of inertia, I =…

Q: 3. Two masses, mA = 2.0 kg and mB = 7.0 kg, are on inclines as shown and are connected by a massless…

Question

100%

In the system shown, the mass at A is 10 kg and that at B is 5 kg. The mass-moment of inertia of the pulley
about point C is 8 kg.m2. At the instant shown, mass A is moving downwards at 5.3 m/s. Find the total kinetic
energy of the system. Neglect friction.
Write your answer in Joules but do not write the units.
0.15 m
B
0.1 m
A
Answer:
Tavlor
Te a mn

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Elastic Constants and Their Relationship

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please do all parts. Thank you!
M M 1.5m m M m = 2kg. M = 3.5kg a) justify whether the moment of inertia about the vertical or horizontal axis have smaller value. Show your calculation. (b) Given angular velocity of 80 rev s¹ in 240 rev. Has a moment of inertia of 1.41x10-3 kg m2. Find: (i) angular acceleration. (ii) net constant torque must apply (c) A space station consists of a giant rotating hollow cylinder of mass 10 kg including people on the station and a radius of 100 m. Given initial angular velocity of 3.3rpm in order to generate artificial gravity. If 100. people, each with an average mass of 65 kg spacewalk to an awaiting spaceship. Find the new angular velocity (in rpm) once all the people are off the station. (d) Suppose a child walks from the outer edge of a rotating merry-go-round to the center. What happend to the angular velocity of the merry-go-round does it increase, decrease, or remain the same? By using the conservation of angular momentum, explain your answer qualitatively.. A large train has…
5. 1) As shown in the image below, the snowmobile has a weight of 259 lb, centered at G1, while the rider has a weight of 154 Ib, centered at G2. If the acceleration is a = 13.5 ft/s?, dimensions are di = 0.9 ft, d2 = 0.4 ft, d3 = 1.6 ft, d4 = 1.6 ft, and height h of G2 of the rider is 1.8 ft, determine the normal reaction force under the front skid at point B. Assume there is only traction (horizontal) force under the rear tracks, but no friction force under the front skid. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. Take g= 32.2 ft/s2. a G2 G1 h A В dz da -
The door has a mass of m and a center of gravity at G. The door is pushed on with a force F at location H for a time t, starting from rest. a.) How far does the door travel after time t? b.) What is the sum of the moments about point A (use + for ccw)? c.) What is the maximum force experienced by a roller (list as magnitude)? daB B hμ dAG Ē.…. Variable dAB dag ha ho ho m TH F G ha Value 4.2 m 2.1 m 0.9 m 1.5 m 3.9 m 100 kg 1.79 s 135i + Oj N hp
A wheel with rotational inertia 48 kg.m2 is mounted on a fixed, frictionless axle. The angular speed of the wheel is increased from zero to 59 rad/s in 12-s. What is the average net torque/Moment in N.m on the wheel during this time interval?
A cyclist intends to cycle up a 6.0 ⚫ hill whose vertical height is 120 m. The pedals turn in a circle of diameter 34.0 cm. If each complete revolution of the pedals moves the bike 4.90m along its path, calculate the average force that must be exerted on the pedals tangent to their circular path. Neglect work done by friction and other losses. Mass of the person riding and bicylce combined is 80 kg
Now consider two very similar semi trucks. One travels at 40 km/hr and another travels at 75km/hr. Which truck will have the greater motion inertia?
Don't Use Chat GPT Will Upvote
1000 lb -8 ft +2ft A beam that weighs 300 lbs is supported by a roller and pin B and A respectively while being subjected to a force of 1000 lbs. If the pin at A is suddenly removed, determine the beams angular acceleration, the force exerted by support B and the horizontal acceleration just after A is removed. Assume the beam is a slender rod of negligible thickness. Please don't use angle measurements when solving. Use the 3-4-5 triangle to solve, if that makes sense. Thank you! Choutranco impgo tout
4. A loading car is at rest on a track forming an angle of 25° with the vertical when a force is applied to the cable attached at C. The gross weight of the car and its load is 5465 lb WG, and it acts at point G. Know the tension in the cable connected at C is 5000 Ib Tc. Neglect friction between the car and the track. Determine how far the car travels in 15 seconds. Model this as a particle at G. 24 in. B 25 in. 30 in. 25 in.
1. Two blocks are connected by a pulley system shown in the figure below. Neglect friction between the block on the left and the ramp sloped at angle 0. Suppose that the block on the left has mass m, and that the block on the right is moving downward at a constant speed v. m Given m, 0, and v, answer the questions below. (a) Find the mass of the block on the right? (b) Find the velocity of the block on the left. (c) If the block on the right was moving at a constant speed v upward, instead of downward, how would your answer to Question la change?
The motor lifts the 40-kg crate with an acceleration of 6 m/s2 as shown in (Figure 1). Part A: Determine the x and y components of force reaction at the fixed support A using scalar notation. Express your answers in newtons to three significant figures separated by a comma. Part B: Determine the couple moment at the fixed support A. Express your answer in kilonewton meters to three significant figures. Enter positive value if the moment is counterclockwise and negative value if the moment is clockwise.