In the single solvent recrystallisation of benzil with methanol, where will a methanol insoluble (in bot or cold methanol) impurity be removed? O will not be removed and will crystallise with the benzil as an impurity O this impurity will remain in the cold methanol solution when the benzil crystallises O this impurity will stay in the filter paper when the hot methanol solution is filtered

In the single solvent recrystallisation of benzil with methanol, where will a methanol insoluble (in bot or cold methanol) impurity be removed? O will not be removed and will crystallise with the benzil as an impurity O this impurity will remain in the cold methanol solution when the benzil crystallises O this impurity will stay in the filter paper when the hot methanol solution is filtered

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

O KINETICS AND EQUILIBRIUM Calculating the solubility of an ionic compound when a... Calculate the solubility at 25 °c of BaCro in pure water and in a 0.0170M BaCl₂ solution. You'll find ê data in the ALEKS Data tab. sp Round both of your answers to 2 significant digits. solubility in pure water: 17/0 solubility in 0.0170 M BaCl₂ solution: 0²/ 0 x10 X □ × ロ 0/3 8
Liquid-liquid mixture is separated with solvent extraction by adding O Soluble O Insoluble solvent. Immiscible O Partially soluble
Explain why any or all of the following solvent pairs cannot be used for mixed-solvent recrystallization? Please explain each. benzene and carbon tetrachloride water and hexane chloroform and methanol all of the above
during re-crystallization, it's important to use the in smallest possiblefthe solvent at high temperature to: Select one: O a. have a saturated solution of the compound, so when the solution is colder and precipitation starts, the maximum amount of the compound precipitates of tion O b. better dissolve the sample Oc. none of the statements mentioned is valid O d. complete a certain total weight of the mixture ion the aqueous layer is a liquid vwith water as the solvent
= STATES OF MATTER Applying like dissolves like For each solute, click the button under the better solvent. H H HO U C solute H I 2 CIH Η 2=0 CaC1₂ H H CH₂ - CH₂-OH Which is the better solvent? CH₂(CH₂) CH3 H₂O CH₂ CH₂OH :0: || CH₂- - CH3 I CH CC14 CH₂OH - CH3 0/5
Solution 1 Solution 2 Solution 3 Solution 4 Solution 5 Concentration iron(III) nitrate 0.00200 0.00200 0.00200 0.00200 0.00200 [Fe(NO3)3] (M) Concentration potassium thiocyanate 0.00200 0.00200 0.00200 0.00200 0.00200 [KSCN] (M) Volume Fe(NO3)3 (mL) 5.00 5.00 5.00 5.00 5.00 Volume KSCN (mL) 5.00 4.00 3.00 2.00 1.00 Volume DI water (mL) 0.00 1.00 2.00 3.00 4.00 Initial concentration [Fe3+] (M) 0.00100 0.00100 0.00100 0.00100 0.00100 Initial concentration [SCN‍] (M) 0.00100 0.000800 0.000600 0.000400 0.000200 Absorbance 0.269 0.192 0.154 0.104 0.052 Equilibrium [FeSCN2+] (M) 0.000198 0.000141 0.000113 0.0000765 0.000038 Equilibrium constant Kc Average Kc
2. The size of a molecule is a factor that can greatly affect solubility of ions. Which molecule is larger, acetone or water? How could this affect the solubility of Nat and CI" ions in each solvent? 3. It is very likely that the acetone partition still contained a fairly good amount of water (and that the water partition contained acetone). Only one of the three concentration units will be affected by the water in the acetone solution. Which one is affected? Explain why, and why the other two concentration units will be unaffected by the amount of water.
1. Assuming that sand and sodium chloride are the impurities in a sample of benzoic acid, state which is a soluble or insoluble impurity in the solvent system (water) and describe how the impurities are removed from benzoic acid during recrystallization.
Concentration of Acetic Acid in a Vinegar Solution. Average molarity of NaOH Volume HC₂H30₂ sample Final buret reading Initial buret reading Volume NaOH (Show all units and all calculations) Molarity of HC₂H30₂ (unrounded) Average molarity of HC₂H302 (unrounded) Deviations Average deviation Best estimate for molarity of HC₂H302 Average mass percent HC₂H302 46.4mL Oml Ran out of Base ↓ ↓ ↓ ↓ 10.014 HOA je beart giov isults weari?! ferottelucuny Cambia) 10 Kousad Question 1. A Rolaids tablet contains calcium carbonate that neutralizes stomach acid. If 44.55 mL of 0.448 M hydrochloric acid is required to neutralize one tablet, how many milligrams of calcium carbonate are in a Rolaids tablet? CaCO, (s) + 2HCl(aq) → CaCl₂ (aq) + H₂O (1) + CO₂ (g)
. Consider the two molecules shown here. 1-butanol (1)- 7.3g/100ml and butyric acid (2)- miscible The solubilities of each in water is given. What is “solubility”? What does the solubility value given for (1) here mean? Please explain, based on their structures, why the solubility of (2) is greater than the solubility of (1) in water. For a complete answer, you should start with the types of IMFs involved in the different parts of the dissolving process. You should also use the kind of reasoning from class regarding the contributions…
For results/conclusions Using the images attached Write 2 paragraphs 1st paragraph: Starts with Objective. Results of DeltaT and i stated 2nd paragraph: sources of errors discussed The objective is The colligative properties are the properties that undergo a change when a solute is introduced to a solvent. Freezing point depression is also a colligative property. The addition of a solute to a solvent reduces the freezing point of the resulting solution. The freezing point of the solution is always lower than the freezing point of the solvent. This difference in the freezing point between solvent and solution is called freezing point depression. The freezing point depression is directly proportional to the molality of the solution or the number of moles of solute present in the solution.
Explain why one would recrystallize a solid from a solvent pair instead of a single solvent. Explain how it works in terms of solubilities. please give detail, will only rate if sufficent detail is given. thank you!