In the simulation, set up the situation shown above. Heat the iron and place it in the water. Assume the water's initial temperature is 29.9°C. If you heated the iron to a temperature of 281°C, what is the final thermal equilibrium temperature (in °C) of the iron-water system assuming negligible heat lost to the surroundings? Use the specific heat values found in the video lessons.

In the simulation, set up the situation shown above. Heat the iron and place it in the water. Assume the water's initial temperature is 29.9°C. If you heated the iron to a temperature of 281°C, what is the final thermal equilibrium temperature (in °C) of the iron-water system assuming negligible heat lost to the surroundings? Use the specific heat values found in the video lessons.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Answer question 6please. Make sure it’s correct and explain the steps please.
I Review I Constants Part B Just about everyone at one time or another has been burned by hot water or steam. This problem compares the heat input to your skin from steam as opposed to hot water at the same temperature. How much heat Q1 is transferred by 25.0 g of water onto the skin? To compare this to the result in the previous part, continue to assume that the skin temperature does not change. Assume that water and steam, initially at 100° C, are cooled down to skin temperature, 34° C, when they come in contact with your skin. Assume that the steam condenses extremely fast. The heat capacity of liquid water is c = Express the heat transferred, in joules, to three significant figures. 4190 J/(kg · K). • View Available Hint(s) ΑΣφ ? Q1 J
Will continue to run if you leave the test. Remaining Time: 29 minutes, 29 seconds. ¥ Question Completion Status: QUESTION 1 The initial volume of a sample of gas is 400.0 mL . At constant pressure, the temperature of the gas is increased from 22.0 °C to 30.0 °C?. What will be the final volume of the gas ? TT T Arial 3 (12pt) Click Save and Submit to save and submit. Click Save All Answers to save all answers. Save 888 F5 F4 F3 F2 % 5 6 4
A 58-kg cross-country skier glides over snow as in the figure below. The coefficient of friction between skis and snow is 0.24. Assume all the snow beneath her skis is at 0°C and that all the internal energy generated by friction is added to snow, which sticks to her skis until it melts. How far would she have to ski to melt 1.5 kg of snow? Your incorrect answer may have resulted from roundoff error. Make sure you keep extra significant figures in intermediate steps of your calculation. m Need Help? Read It Master it
Please don't copy and written by hand As shown in the figure below, you have a system including a Cadmium vessel with mass Mvessel = 0.477 kg. The vessel contains water with mass Mwater = 0.219 kg. Both the vessel and water are initially at a temperature of 45.0 degrees Celsius. You add steam into the system. The steam has an initial temperature of 157.9 degrees Celsius and a mass of Msteam = 6.9289 kg. The system will reach equilibrium with all the water having vaporized at some final temperature above 100 degrees Celsius.Find the system final temperature, Tfinal = degrees Celsius Material c (J/(kg K)) Aluminum 897 Beryllium 1820 Cadmium 231 Iron 412 Lead 129 Polyethylene 2303 Steel 466 Uranium 116 Water c (J/(kg K)) ice 2090 water 4186 steam 2010
I am doing some practice problems to prepare for an exam and i cannot solve this problem, specifically part a but I would like to check this problem A piston cylinder device contains 0.8 kg of air initially at 100 kPa, 27 °C. The air is now compressed slowly in a polytropic process during which PV^1.3 =constant, until the volume reaches 1/2 its original volume. The system is then heated at constant pressure until the volume gets back to its original value. NOTE: THIS IS NOT A CYCLE. Data: Rair = 0.287 kJ/kg K; Cv=0.731 kJ/kg K; Cp=1.018 kJ/kgK. a) Determine the amounts AND directions of the Work and Heat(each in kJ) for each of the two processes. show all work used to get your values. b) Sketch the two processes on a P-v diagram, clearly showing all three state points and the two processes with their directions.
Please explain each step
A 12 g bullet is fired from a gun and moves vertically upwards at a velocity of 950m/s and strikes a 2kg brick which is originally at rest, as shown in the picture below. If the bullet emerges from the brick at a speed of 290m/s, determine 1. What is the The maximum height to which the brick rises? 2. What is The increase in the internal energy of the whole bullet-brick system? 290 m/s 950 m/s
This is a calculation only. Energy2d isn’t able to do phase changes as far as I’ve learned. There was a different simulation for this but it is not currently free. You combine 50g of ice at -10oC with 150g of liquid water at 75oC. After a few minutes, you measure the final equilibrium temperature of all of the H2O to be 35.1 oC. Use this information to “experimentally” determine the heat of transformation of water, Lfusion. cwater=4190 J/kgK, cice=2090 J/kgK Show all of your work and compare to the accepted value Lfusion=3.33x105 J/kg.
ConstanS T Pent Part A An experiment measures the temperature of a 400 g substance while steadily supplying heat to it. The figure shows the results of the experiment. (Figure 1) What is the specific heat of the solid phase? Express your answer to two significant figures and include the appropriate units. ? Value Units C = Submit Request Answer Part B What is the specific heat of the liquid phase? Express your answer to two significant figures and include the appropriate units. ? Value Units C = Submit Request Answer Part C Figure What is the melting temperature? Express your answer to two significant figures and include the appropriate units. T(°C) 80 ? 60 40 T, - Value Units 20 Q (kJ) 40 80 120 160 200 -20 Submit Request Answer -40