In the Potentionmeter experiment, if the balance point in the galvanometer was obtained at point C, where AC = 35 cm, AB (the wire Length on the meter stick) = 100 cm, and the power supply of the circuit is rated at 9 Volts, the value of Ex (in Volts) is: О а. 3.15 O b. Zero O c. 5.8 O d. 9

In the Potentionmeter experiment, if the balance point in the galvanometer was obtained at point C, where AC = 35 cm, AB (the wire Length on the meter stick) = 100 cm, and the power supply of the circuit is rated at 9 Volts, the value of Ex (in Volts) is: О а. 3.15 O b. Zero O c. 5.8 O d. 9

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: When two cells of e.m.fs. E, and E, are connected in series so as to assist each other the balancing…

A: To Compare : E.m.fs. of two cells E1E2 Given: (E1) and (E2) are e.m.fs. of two cells, L1 = 2.7 m,…

Q: For the circuit shown, the power dissipated in the load resistance R, is given as a function of R.…

Q: Draw a switching circuit that represents the symbolic statement. (pv q) A (r V-s) Choose the…

A: The symbolic statement is given

Q: For items 1-3, study the schematic below. R, = 1.3n 1.5 A R = 1.5n CR3 = 1.8n 20V Fig. 6.3.9.…

A: The direction of the loop is clockwise.

Q: B. For the circuit shown in Fig. 2.2b, the current i(1)= 6e-2' mA for t>0 and i¡(0) =4 mA. Find (i)…

A: (i) v1(t) be given as,

Q: In the circuit below, the switch has been open for a long time and then closes at t= If R=22 Ohms…

A: R = 22 ΩL = 42 H V = 20% E

Q: If the battery in the circuit below is 9.78V, resistor R₁-217.51, and resistor R₂=160.920, what is…

Q: If the battery in the circuit below is 12.64V, resistor R₁-20.46, and resistor R₂-49.18, wh is the…

Q: In the Power Transfer experiment, A ioad resistance R = 5 Ohms is connected across the terminals of…

Q: The electric oven in your kitchen is plugged into a 240.0V out and it draws a 19.5 A current. If you…

A: Potential difference = 240 V Current = 19.5 A Time = 30 mins = 1800 seconds

Q: Two 150-V batteries-with their positiive terminals in the same drection-are inserted in series into…

A: Solution: a). Since the batteries are connected in series, the net voltage of the batteries is the…

Q: ap www wwww (V,) (V2) A А V R 2 = 130 N connected as shown in the figure. Estimate the values shown…

A: Given values:- Resistance,(R1)=740 Ω ----(1) Resistance,(R2)=130 Ω ----(2) Potential difference…

Q: In the circuit shown in the figure, the ideal ammeter measures = 0.4A in the indicated sense, and…

Q: The battery terminal voltage in the figure below is E = 8.30 V and the current I reaches half its…

A: Given:- The terminal voltage is ε= 8.30 V The current reaches half of its maximum value of current…

Q: ww 22. 3R R ٤٠ DC Circuit In this circuit R = 10.0 and ε = 5.0 V. a. What current flows through the…

Q: Suppose a power supply has an emf of 22 Volt and an internal resistance of 3 Ohm. The total maximum…

A: Given Emf = 22 volts =V Internal resistance = 3 ohm =r Total power delivered in the circuit Let…

Q: For the following circuit in the figure below, find the power ( in units of Watt) delivered to the…

A: The solution is provided below.

Q: A cauterizer, used to stop bleeding in surgery, supplies 1.95 mA at 13 kV. What is its power output,…

Q: 7. a O R₂ Given E-12V, R₁-1002, R₂ = 150 and C=1uF. a) The switch S has been on position a for a…

Q: 53 : A 25 W lamp conneted to A.C. potential of peak value 100 V. Calculate the r.m.s. value of the…

A: Given Power (Pav) = 25 W Voltage E0 = 100 V

Q: Q10. The current (in A) passes through the cross section of bridge's wire for equilibrium state (le…

Q: Find the loop currents i1, 12 and i3 in the given circuit using Mesh Analysis. Find the 11, 923/01/0…

Q: In the potentiometer experiment, the slope of the calibration curve was found to be 25 V/m. When the…

A: Solution: Given that, the slope of the calibration curve is 25 V/m. The calibration curve is the…

Q: Compute the power dissipated on the Resistance on the red box. Given R1 = 15 ohms, and R2 = 30 ohms.…

Q: For the circuit shown, the power dissipated in the load resistance R, is given as a function of R…

Q: (e) the current in the 2.00 Q resistor (Enter the magnitude in mA.) Redraw the circuit, labeling…

A: Given Data: The voltage in a circuit is, ε=8.00 V The resistance in a circuit is, R=5.10 Ω Part…

Q: A 50.7 ohm resistor is put into a circuit with a 16 volt battery. What is the power dissipated (in…

Q: Given that V= J/A-s and 1 Kwh = 3.6 x106 J, what does it cost to operate a window-type air…

A: Given V = J/A-s 1 Kwh = 3.6 x 106 J Current = 10 Amp Voltage = 110 V

Q: The newest generation of smartphone uses three different batteries connected in series…

A: When cells are linked in series to make a battery, the net potential difference between the…

Q: in the Circuit shown in fig. |- Cal cu late the equivalemt resis tance at AfS. 2- Calcutate the…

A: The equivalent resistance for this circuit can be found by breaking down the circuit, by removing…

Q: For the circuit in the figure, at t = 0 the switch S is closed with the capacitor uncharged. If C =…

A: Given,

Q: 5.5-kW water heater operates at 240V. i.Should the heater circuit have a 20A or a 30A circuit…

A: i. write the expression for power.

Q: The reading on the ammeter in the figure below is 2.80 A, and the current runs from right to left…

A: We shall draw current loops and do the loop analysis. To solve this problem we have to keep in mind…

Q: For the circuit shown in Fig. 2.2 calculate (a) the circuit resistance, (b) the circuit current, (c)…

A: Given data The magnitude of the first resistance is R1 = 330 Ω The magnitude of the second…

Q: What would be the current and voltage passing through the 37Ω resistor when connected to a…

A: The Resistance R1 in series with the combination of resistors. The effective resistance of the…

Q: 5. The d-e network in the figure contains a battery B, a motor M, a generator G and 5 resistors.…

Q: A current of I = 3.7 A passes through the circuit shown, where R = 78 Ω. (a) In terms of R, I, and…

Q: A cauterizer, used to stop bleeding in surgery, supplies 2.2 mA at 12.5 kV. What is its power…

Q: For the given circuit, the maximum power transferred to the load resistance (in mw) is: A R = 2002…

Q: 26.4. A 32-N resistor and a 20-N resistor are connected in parallel, and the combination is…

Q: "You are asked to make a 13 2 resistor with a spool of wire of radius 7.5 × 10-5 m and resistivity…

A: given R = 13 ohm Resistivity = 1.68 × 10-8 ohm r = 7.5×10-5 m Using formula

Q: A copper conductor has a diameter of 0.1 in and it is 1244 feet long. Assume that it carries a total…

Q: phy.

A: Step 1:When the switch is closed and after very long time, the wire in which the capacitance is…

Q: In the given circuit, R¡= 6.00 ohms, R2 = 3.00 ohms and Rz = 5.00 ohms. The battery has negligible…

A: Given:Resistors, R1 = 6 Ω R2 = 3 Ω R3 = 5 ΩThus, the current…

Question

In the Potentionmeter experiment, if the balance point in the galvanometer was obtained at
point C, where AC = 35 cm, AB (the wire Length on the meter stick) = 100 cm, and the power
supply of the circuit is rated at 9 Volts, the value of Ex (in Volts) is:
О а. 3.15
O b. Zero
c. 5.85
O d. 9

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Given the circuit and currents i1=0.026A, i2=-0.0142A, and i3=0.0154, Find change in voltage from point A to point F. Find through short (VA->E->F) and long (VA->B->C->F) ways. Answer in units of Volts. Hints: Use Kirckoff's Laws. Answer should be +9.0741V for both ways.
Consider a series RC circuit as in Figure below for which R =4.0 MQ, C=6.0 µF, and ɛ=34 V. Find the current (in units of HA) in the resistor 10.0 s after the switch is closed. R Select one: А. 2.20 В. 5.60 C. 9.00 D. 3.74 E. 14.94
Q 9 please
Hello, I need help with this question. Pls & thank you!
A battery of a computer has an emf of 12 Volts. The computer uses l=360mA while running. If the computer runs out of battery in t=7.3 hours, what is the energy stored in the battery?(answer will be answered in units of Wh....note: in order to transform Joule into Wh, which means Watt hours, just divide the number obtained in Joule by 3600-s)
In Figure 2, E1 = 5.00 kV, &2 = 4.50 kV, E3 = 3.50 kV, Rị = 650.0 N, R2 = 450.0 Q, R3 = 540.0 Q, R4 = 150.0 Q and R5 = 230.0 N. 2. Using Kirchhoff's Laws, calculate the currents I1, I2 and I3. Assume that the batteries have negligible internal resistance. R1 I3 R2 I1 E3 R3 E1 I2 R5 E2 R4 Figure 2
Either solve all parts or none.....
01
(a) In the figure what value must R have if the current in the circuit is to be 1.1 mA? Take ε1 = 1.5 V, ε2 = 3.5 V, and r1 = r2 = 4.0 Ω. (b) What is the rate at which thermal energy appears in R? Please be specific about the units in the work and the final answer.
Eto sorbe kosto
b. Fig. 2 shows the same filament lamp and a resistor of resistance 1.2 Q connected in series with a battery. The battery has e.m.f. 4.5 V and internal resistance r. The voltmeter has very high resistance. The current in the circuit is 2.0 A. 4.5V (i) Show, with the help of Fig. 1, 2.0A r that the voltmeter reading is 3.4 V. lamp 1.20 (ii) Calculate the internal resistance r of the battery. V Fia. 2
... SW1 100к МАХ VR1 100K MAX VR2 100K 100K V1 D1 10V R2 8K VR2 is set to 9.1 % setting. The switch is pressed and activates the SCR. What is the voltage measured at the gate terminal, VG, if the actual current flowing at the gate is 0.78 mA? Required, VG ? (in volts, in 2 decimal places) :