Part A & B pls In the figure, what is the current supplied by the emf when the frequency is very small?Assume that R1 = 100 N and R2 = 40 N .(Figure 1)Express your answer to two significant figures and include the appropriate units.HAIrms =ValueAFigure1 of 1Part BWhat is the current supplied by the emf when the frequency is very large?Express your answer to two significant figures and include the appropriate units.R,10 V rmsHAO, E) ?50 mH: 20 μFIms =ValueALwWelR,

XL=j2π×f×L inductive reactance is directly proportional to frequency so it behaves short circuit for…

In the figure, what is the current supplied by the emf when the frequency is very small? Assume that R1 = 100 N and R2 = 40 2 .(Figure 1) Express your answer to two significant figures and include the appropriate units. 圖] ? Irms = Value A Figure 1 of 1 Part B What is the current supplied by the emf when the frequency is very large? Express your answer to two significant figures and include the appropriate units. R, R 10 V rms HA 50 mH :20 µF Irms = Value A

In the figure, what is the current supplied by the emf when the frequency is very small? Assume that R1 = 100 N and R2 = 40 2 .(Figure 1) Express your answer to two significant figures and include the appropriate units. 圖] ? Irms = Value A Figure 1 of 1 Part B What is the current supplied by the emf when the frequency is very large? Express your answer to two significant figures and include the appropriate units. R, R 10 V rms HA 50 mH :20 µF Irms = Value A

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.8MCQ: An ac resistance is higher than a dc resistance. True False

See similar textbooks

Similar questions

Okay for Determine the mathematical expression for the voltage vC and the current iC for the discharge phase. I got Vc = 8e-t/0.2s V and iC = -4e-t/0.2mA But I need help with the last question Plot the waveforms of vC and iC for a period of time extending from 0to 2 s from when the switch was thrown into position 1.
Determine the CH2 average value considering half-cycle. Write the values only in four decimal places. the correct answer is 0.4584. show the solution pls thank you.
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
Q2) Consider the circuit in Figure (3), and answer 3 branch only. a) What type of circuit is this? b) What is the total peak secondary voltage? c) Find the peak voltage across each half of the secondary. d) Sketch the voltage waveform across RL. 4:1 120 V rms RL 1.0 k2 D2 eelee
Electrical Engineering 1) A sinusoidal signal of 500 mV and 1 kHz from peak to peak is given as the input signal from the function generator. a) Calculate the voltage gain of the circuit in Figure 1. b) What is the phase relationship between input and output signals? (Assume ß = 50 and VBE = 0.4 V) RE 10kO RL 56kO C2 Vout C1 Q1: 10µF 10uF BD139 : Víni RB1: 2.2k0 RB2 : 500 mVpp 1-kHz S0.56kO Figure 1
The 3-phase half-wave rectifier given in the figure is connected to 3-phase 380 380 V 50 Hz network and feeds 20 Ω ohmic load. Plot the average value of the current flowing through the load and the waveform (vdc) of the voltage across the load on the dashed curves given.
400 V is the input voltage given to a chopper, the required output is 650 V. The thyristor is conducting 300 usec. what is the addition of conducting and non conducting period? (Write your answer in usec) Answer:
Reduce 4-3j 2+2j 0.25 +j1.75 O 0.25-j1.75 -0.25 +j1.75 -0.25 -j1.75
What will happen to the value of the impedance if the resistance will be increased or decreased? Explain...
Do all questions
Which of the following statement is true? a. Angle between load voltage and load current in a pure capacitive load is 45 degree. b. Angle between load voltage and load current in a pure capacitive load is is 180 degree. c. Angle between load voltage and load current in a pure capacitive load is is zero. d. Angle between load voltage and load current in a pure capacitive load is is 90 degree.
A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source. Solve for the current 2 milliseconds after the switch was turned on. a. 2.0000 Amperes b.1.9999 Amperes c.1.0001 Amperes d. 2.0001 Amperes