In the figure below, pipe A contains gasoline (S.G.=0.75), pipe B contains oil (S.G.=0.91) and the manometer fluid is mercury (S.G.=13.6). The initial differential reading is 0.30m as shown. Determine the pressure difference between A and B. In the figure below, pipe A contains gasoline (S.G.=0.75), pipe B contains oil (S.G.=0.91) and the manometer fluid is mercury (S.G.=13.6). The initial differential reading is 0.30m asshown. Determine the pressure difference between A and B.0.4mOil0.3 mGasoline- MercuryB.

Answered: Image /qna-images/answer/555d5e5d-416e-45f7-b4cc-cc1bd12e65ca.jpg

In the figure below, pipe A contains gasoline (S.G.=0.75), pipe B contains oil (S.G.=0.91) and the manometer fluid is mercury (S.G.=13.6). The initial differential reading is 0.30m as shown. Determine the pressure difference between A and B. B 0,4 m Oil 0.3m Gasoline Mercury

In the figure below, pipe A contains gasoline (S.G.=0.75), pipe B contains oil (S.G.=0.91) and the manometer fluid is mercury (S.G.=13.6). The initial differential reading is 0.30m as shown. Determine the pressure difference between A and B. B 0,4 m Oil 0.3m Gasoline Mercury

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: figure 5 shows a manometer being used to indicate the difference in pressure between points A and B…

A: Question is based on the concept of manometer. A manometer is given in the questioncontains water…

Q: Air For the setup shown, a manometer was attached from a tank into a pipe with liquid (SG=0.95).…

A: Given data in question Depths Oil of specific gravity 0.95 To find out Absolute pressure at A Note…

Q: HR WATER 4cm 2. 3. OIL MEROURY A manometer connects an oil pipeline and water pipeline as shown.…

A: To calculate the difference of pressure between points 1 and 6, using the concept of manometer and…

Q: Problem 5: Hydrostatic Pressure Consider the swimming pool light fixture shown below. It has a…

A: Given data,D=Dia=15cm=0.15mR=radius=mz=depth=2.5mFINDvertical hydrostatic force (N)

Q: Two pipes A and B contain water and are connected by an inverted manometer as shown in figure below.…

Q: Determine the pressure difference (in kPa and answer should be a whole number) between the water…

Q: Question 2. The manometer in the figure is used to measure the pressure difference between two…

A: ρ = density of water = 1000 kg/m³ g = acceleration due to gravity = 9.81 m/s² h = height difference…

Q: A U-tube manometer is connected to a closed tank containing air and water as shown in the figure…

Q: From the figure shown. Find the pressure head and the pressure at A when fluid A is water, Fluid B…

Q: x=1, y=5

A: Given values: x=1, y= 5 (a) Fluid A is gasoline, G1 = 0.715 Gauge liquid is mercury, G2 = 13.6 z =…

Q: The height of the fluid inside the tube after immersion is 1/8 the height of the cylinder glass…

A: Calculating the height of tube: h=6+(h/8) 7h/8=6 h=0.0685 m

Q: The pressure in tank is 2.99atm .Determine the gauge pressure.

A: Concept- Gauge pressure is defined as the difference of absolute pressure and atomospheric pressure

Q: Calculate the pressure difference between the 2 points shown on the figure below (P1 - P2)? Fluid in…

A: Given :- The pressure difference between 2 points ( P1-P2) SG =13.6 Cross-…

Q: Determine the flow rate in Its/s and in p^3/s that circulates through the Venturi meter. The height…

Q: vessel at its o r is mercury, - figure shows the vessel is e n, find the rea her the readi 0.8. SG…

Q: (Bernoulli/continuity/Pitot tube) Two Pitot tubes and two static pressure taps are placed in the…

A: Required : Manometer readings h and H given in the diagram.

Q: Pitot Pipe By connecting a mercury pressure gauge to a vertical pipeline through which water is…

A: step 1-

Q: Gasoline line is connected to a pressure gage through a double-U manometer, as shown in Figure (1).…

A: The gasoline pressure is connected to a pressure gauge through the double U manometer. there are…

Q: Q3. The soaking bin contains ethyl alcohol used for cleaning automobile parts. If the pressure in…

Q: 14 in, da measures 3 in. If SGmercury is 13.55, a) calculate the pressure difference (in psi)…

Q: (c) Venturi-type flowmeter shown in Figure 5 is used to obtain the flowrate of oil inside a conduit.…

A: ## solution of venturi type flow meter, and calculation of volume flow rate, mass flow rate,

Q: 6- Determine the absolute pressure in a pipe which is connected to a simple U-tube manometer, the…

Q: In the figure shown, determine the height h of water and the gage reading at A when the absolute…

Q: Air is drawn into a wind tunnel used for testing automobiles as shown in the figure below. (a)…

Q: A manometer is attached to a conduit as shown. What is the pressure at A in kPa. Choices are: A.…

A: Objective: To determine the pressure at A. Given: Specific gravity of liquid B (SGB) = 10 h = 150…

Q: 16. Fluid Flow through a Compression Chamber A compressible gas flows into and out of a compression…

Q: what is the pressure (in Pa) at the higher center (P₂) if H=

Q: A U-tube manometer is connected to a closed tank containing air and water as shown in the figure…

A: Given: Air pressure = 16 psia Differential reading = 4 ft Guage fluid unit weight = 90 lb/ ft3 To…

Q: Pipe 1 which is 100 mm in diameter and 350 m long is in parallel to pipe 2 which is 300 m long. Pipe…

Q: A U-tube manometer is connected to a closed tank as shown in the figure below. The air pressure in…

A: Solution: a) Depth of oil Z PA=γoilZ+Pair2×144=54Z+0.5×144Z=4 ft

Q: SUBJECT IS HYDRAULICS SHOW DETAILED AND COMPLETE SOLUTION USED 3 DECIMALS FOR THE FINAL ANSWER A…

Q: Gasoline flows steadily downward through the pipe shown in the figure below. Viscous effects are…

Q: Gasoline line is connected pressure gage through a double-U manometer, as shown in Figure (1). If…

A: The given figure is shown below:

Q: 6. In the manometer shown at right, containing mercury (s.g.-13.6) from A to B, and oil (s.g.=0.85)…

A: Given Data Determined the pressure at point C.

Q: A pressure gauge tester is shown in Figure 3.3. The cylinder is filled with oil, B,-475x10-12PA-.…

A: Given Bulk modulus isβ=475×10-12pa-1ΔVVΔP=475×10-12pa-1ΔV=475×10-12pa-1×250cm325×106ΔV=2.96875cm3

Q: Q4/B/ Calculate the difference pressure (psf) between points A and B for the figure: 1000 mm o Water…

Q: 9. For dynamic fluid motion in a pipe, the pressure measurement cannot be carried out accurately by…

Q: 100 пm mercury B OIL

Q: Water in the pipe is shown in the figure. Determine the pressure at Point A in kPa(abs), to the…

A: Given Data for first question: Height of mercury=135 mm specific gravity of mercury=13.54 Height…

Q: In fig. if H= 88 inches, the difference in pressure =---?(the fluid is water) Piezometer (static)…

Q: (Bernoulli/continuity/Pitot tube) Two Pitot tubes and two static pressure taps are placed in the…

A: To determine the two manometer reading h and H.

Question

In the figure below, pipe A contains gasoline (S.G.=0.75), pipe B contains oil (S.G.=0.91) and the manometer fluid is mercury (S.G.=13.6). The initial differential reading is 0.30m as
shown. Determine the pressure difference between A and B.
0.4m
Oil
0.3 m
Gasoline
- Mercury
B.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

(Bernoulli/continuity/Pitot tube) Two Pitot tubes and two static pressure taps are placed in the pipe contraction shown in the figure below. The flowing fluid is water, and viscous effects are negligible. Determine the two manometer readings, h and H. V=2.2 ft/s h= H= 6.3 in. Air SG= 1.10 ft •ft H 3.5 in. h
Determine the gauge pressure at the center of pipe B in kilopascals. Mercury (S = 13.6) is the fluid in the manometer while oil (S = 0.93) is the fluid flowing in the pipe. Oil Mercury +B 0.2 m 0.02 m
The cage system shown in the figure is made of EC rod. The Flow Limit of the material is 180 MPa and the Safety Coefficient is 4 is desired to be. Accordingly, the circular cross section EC rod Calculate the diameter.
I need the answer to the question in fluids
• A simple U tube manometer is given below. The pressure at which side is higher? o Left o Right o Left = right • In order to calculate the pressure difference at locations 1 and 2 (P2 - P1), we need to know the length of the inclined tube L, as is shown below. o True o False A fow section fow device Fluid
mater 9
(Bernoulli/continuity/Pitot tube) Two Pitot tubes and two static pressure taps are placed in the pipe contraction shown in the figure below. The flowing fluid is water, and viscous effects are negligible. Determine the two manometer readings, h and H. V=1.7 ft/s h = H= 6.4 in. Air ↓ SG= 1.10 ft ft TH 3.8 in.
A differential manometer is attached to a pipe shown. Calculate the pressure difference between points A and B.
B4. An orifice meter with orifice area 1060 mm2 is inserted in a pipe of area 2120 mm2 .The pressure difference measured by a mercury oil differential manometer on the two sides of the orifice meter gives a reading of 55 cm of mercury. Find the rate of flow of oil of sp. gr. 0.85 when the co-efficient of discharge of the orifice meter =0 66 Head of water (in m) The discharge of water through pipe (in Litres/sec)
for the compound manometer what would be an advantage or disadvantage in this measure
Current Attempt in Progress A U-tube manometer is connected to a closed tank as shown in the figure below. The air pressure in the tank is 0.50 psi and the liquid in the tank is oil (y = 54.0 lb/ft³). The pressure at point A is 2.00 psi. Determine: (a) the depth of oil, z, and (b) the differential reading, h, on the manometer. (a) z = (b) h = ft ft Air Oil SG = 3.01 2.0ft + Open h