In the figure below, after sitting for a long time in position a, the switch in the circuit was moved to position b at t = 0. A student measured and plotted the current (i) flowing through the inductor (graph below) after the switch was moved. The data point on the graph is equal to 8.05A, which occurs at 5 milliseconds. What is the value for X, in milliseconds (the time at which the current is equal to 8.05A) ? a) What is the value of the current source Ix, in Amps? Enter only the numerical value. b) What is the value of the current source Iy, in Amps? Enter only the numerical value. c) What is the time constant, in milliseconds? Enter only the numerical value. d) What is the value of Ra, in Ohms? b Ra t = 0 500mH 10 8 X time (ms) Inductor Current (A)

In the figure below, after sitting for a long time in position a, the switch in the circuit was moved to position b at t = 0. A student measured and plotted the current (i) flowing through the inductor (graph below) after the switch was moved. The data point on the graph is equal to 8.05A, which occurs at 5 milliseconds. What is the value for X, in milliseconds (the time at which the current is equal to 8.05A) ? a) What is the value of the current source Ix, in Amps? Enter only the numerical value. b) What is the value of the current source Iy, in Amps? Enter only the numerical value. c) What is the time constant, in milliseconds? Enter only the numerical value. d) What is the value of Ra, in Ohms? b Ra t = 0 500mH 10 8 X time (ms) Inductor Current (A)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

(b) A current waveform, I(t) (Figure Q1(b)(i) is applied to the circuit in Figur (i) Write the expression for 1.(1) (ii) Draw the voltage, V.(t) waveform
2
3. For the circuit, (i) Find the voltage vc and the current ic if the capacitor was initially uncharged and the switch is thrown into position A. (ii) Find the voltage vc and the current ic if the switch is thrown into position B. (iii) Plot the waveforms for the questions (i) and (ii) for both the voltage vc and the current ic. Mark the time constant for part (i) and part (ii) in the waveforms with the corresponding values for current and voltage. A ww ic 20 kΩ B + + 12 V Vc. R, •10 kΩ 0.05 μF
How to solve given a 0.7-H inductor connected in series with a 9-ohm resistor. If the connection is energized from an 11-V DC source, determine the voltage (in volts) across the resistor at t = 2.75 ms. The initial current is 175 mA.
I need the answer as soon as possible
7 Use Kirchhoff's loop rule to R2 write two equations describing this cir- cuit (assuming the switch is closed). You may use any of the symbols in the fig- ure and any currents or capacitor charges that you define. opyright C1 C2
How much current flows through a 250-millihenry inductor when a signal of 12 volts and 60 hertz is applied across it?
4. Why do we examine the behavior of an inductor when the current through it is changing? 5. What is the definition of the time constant? The definition of the time constant is I
Please provide Handwritten answer
An initially charged capacitor has an initial voltage of Vo=53 Vand a capacitance ofC=175μFand it is connected to a resistor of resistance R=4.85kΩas shown in the figure below. The switch is closed at t=0. Determine the current running in the circuit one time constant after the switch is closed. Express your answer in units of mA using one decimal place.