In the figure below, a small block of mass m 4 kg can slide along the frictionless loop-the-loop, with loop radius R = 17 cm. The block is released from rest at point, at height h 6.0R above the bottom of the loop. Does the block complete the loop? If yes, what is its speed at the top of the loop?

In the figure below, a small block of mass m 4 kg can slide along the frictionless loop-the-loop, with loop radius R = 17 cm. The block is released from rest at point, at height h 6.0R above the bottom of the loop. Does the block complete the loop? If yes, what is its speed at the top of the loop?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter7: Work And Kinetic Energy

Section: Chapter Questions

Problem 7.7CYU: Check Your Understanding suppose the radius of the loop-the-loop in Example 7.9 is 15 cm and the toy...

See similar textbooks

Similar questions

A particle of mass 0.50 kg moves along the x -axis with a potential energy whose dependence on x is shown below. (a) What is the force on the particle at x = 2.0, 5.0, 8.0, and 12 m? (b) If the total mechanical energy E of the particle is —6.0 J, what are the minimum and maximum positions of the particle? (c) What are these positions if E = 2.0 J? (d) If E = 16 J, what are the speeds of the particle at the positions listed in part (a)?
A 100 — kg man is skiing across level ground at a speed of 8.0 m/s when he comes to the small slope 1.8 m higher than ground level shown in the following figure. (a) If the skier coasts up the bill, what is his speed when he reaches the top plateau? Assume friction between the snow and skis is negligible. (b) What is his speed when he reaches the upper level if an 80 — N frictional force acts on the skis?
Review. A bead slides without friction around a loop-the-loop (Fig. P7.3). The bead is released from rest at a height h = 3.50R. (a) What is its speed at point ? (b) How large is the normal force on the bead at point if its mass is 5.00 g? Figure P7.3
“ E=K+Uconstant is a special case of the work energy theorem.” Discuss this statement.
A person in good physical condition can put out 100 W of useful power for several hours at a stretch, perhaps by pedaling a mechanism that drives an electric generator. Neglecting any problems of generator efficiency and practical considerations such as resting time: (a) How many people ‘would it take to nm a 4.O0-kW electric clothes dryer? (b) How many people would it take to replace a large electric power plant that generates 800 MW?
As shown in Figure P7.20, a green bead of mass 25 g slides along a straight wire. The length of the wire from point to point is 0.600 m, and point is 0.200 in higher than point . A constant friction force of magnitude 0.025 0 N acts on the bead. (a) If the bead is released from rest at point , what is its speed at point ? (b) A red bead of mass 25 g slides along a curved wire, subject to a friction force with the same constant magnitude as that on the green bead. If the green and red beads are released simultaneously from rest at point , which bead reaches point first? Explain. Figure P7.20
In the movie Monty Python and the Holy Grail (https://openstaxcollege. org/l/21monpytmovcl) a cow is catapulted from the top of a castle wall over to the people down below. The gravitational potential energy is set to zero at ground level. The cow is launched from a spring of spring constant 1.1 104 N/m that is expanded 0.5 m from equilibrium. If the castle is 9.1 m tall and the mass of the cow is 110 kg, (a) what is the gravitational potential energy of the cow at the top of the castle? (b) What is the elastic spring energy of the cow before the catapult is released? (c) What is the speed of the cow right before it lands on the ground?
In an iconic movie scene, Forrest Gump (https://openstaxcollege.org/l/21ForrGumpvid) runs around the country. If he is running at a constant speed of 3 m/s, would it take him more or less energy to run uphill or downhill and why?
A 200-g steel ball is tied to a 2.00m “massless” string and hung from the ceiling to make a pendulum, and then, the ball is brought to a position making a 30 angle with the vertical direction and released from rest. Ignoring the effects of the air resistance, find the speed of the ball when the string (a) is vertically down, (b) makes an angle of 20 with the vertical and (c) makes an angle of 10 with the vertical.
A block of mass m = 5.00 kg is released from point and slides on the frictionless track shown in Figure P7.6. Determine (a) the blocks speed at points and and (b) the net work done by the gravitational force on the block as it moves from point to point . Figure P7.6
A 6.50 102-kg elevator starts from rest and moves upward for 3.00 s with constant acceleration until it reaches its cruising speed, 1.75 m/s. (a) What is the average power of the elevator motor during this period? (b) How does this amount of power compare with its power during an upward trip with constant speed?
Physics Review A team of huskies performs 7 440 J of work on a loaded sled of mass 124 kg, drawing it from rest up a 4.60-m high snow-covered rise while the sled loses 1 520 J due to friction, (a) What is the net work done on the sled by the huskies and friction? (b) What is the change in the sleds potential energy? (c) What is the speed of the sled at the top of the rise? (See Section 5.5.)