In the Ericsson cycle, the pressure of the air entering the compressor is 100 kPa, its temperature is 35°C and its flow rate is 2.5 kg/s. Since the pressure and temperature at the inlet of the turbine are 1.1 MPa and 1300 °C, respectively, a) Find the heat supplied to the cycle, the heat removed from the cycle and the net power produced. b) Find the thermal efficiency. c) Find the heat taken in or given off in the regeneration process.

Q: a) Rankine cycle ratio (RCR) b) Theoretical steam rate (TSR) c) Actual steam rate (SR) d) Steam flow…

A: Definition:The Rankine cycle ratio (RCR) is the cycle's net work output divided by its heat intake.…

Q: he intake air to an ideal Otto cycle has a max volume of 0.004m^3 at 27 degre

A:

Q: A certain coal-fired power plant has a rated power capacity of P = 950 MW. The output of this plant…

A:

Q: Consider one stage of an impulse turbine consisting of a converging nozzle and one ring of moving…

A:

Q: A regenerating brayton cycle that uses air as the fluid has a pressure ratio of 8. The minimum and…

A: Pressure ratio = 8 Compressor efficiency = 72 % Turbine efficiency = 82 % Effectiveness = 62 %…

Q: The Insulated piston-cylinder assembly expands isothermally from 72.5 psi at 773.15°K to 14.5 psi.…

A: Here I'm going to calculate the work done for an isothermal process, after that I'm gonna calculate…

Q: Steam generated in a power plant at a pressure of 8200 kPa and a temperature of 510 ° C feeds a…

A:

Q: The air entering the turbine with 1200 K and 1200 kPa expands to 100 kPa pressure in two stages.…

A: Given Data Turbine Inlet:1200 K Two stage expansion process P1=1200 kPa, P2=350 kPa, P4=100 kPa

Q: Q2: For air standard diesel cycle the following data is available: compression ratio Heat added / kg…

A: Dear student as per the policy i have solved first three subparts for you , request you to post…

Q: Water vapor enters a turbine at 500 °C and 1200 kPa pressure and exits at 300 °C and 200 kPa…

A:

Q: a) Using the Euler whirl equation, find the power transfer between a throughput of 100kg/s of air…

A:

Q: In an ideal Stirling engine with a regenerator that uses air, the maximum and minimum volumes of the…

A: Given: Minimum pressure P1=100kPaMaximum temperature T3=T4=900KMinimum temperature T1=T2=30°C or…

Q: Answer this ASAP,thx In a gas turbine, air enters the compressor at a temperature of 290 K and a…

A: (a) To find: The thermal efficiency. Given: The inlet pressure and temperature at compressor is…

Q: Steam with a pressure of 6 MPa and a temperature of 400oC is created in a boiler at a flow rate of…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.