In the diagram below, The raccoon has a mass of 40kg and is 5m from the hinge. The beam is 8m long and is 6kg. The cable is 2m long. The beam has a diameter of 8cm. a) What are the horizontal and vertical forces on the hinge? b) What is the shear force from the cable on the beam?

Q: A cantilever beam of length l and carrying a point load W at the free end is shown in Fig. 2.41.…

A: A cantilever beam of length l and carrying a point load W at the free end  is shown in fig;

Q: F1, F2 and F3 are equal to 3 KN, 7.5 KN and 6 KN respectively. The moment M has a magnitude of 8.5…

A:

Q: Question 7- SFD & BMD - Simply Beam (UDL) UDL = 6 kN/m 8 m i) Draw the Free-Body Diagram & Find…

A:

Q: Question 2 (Shear and Bending Moment Diagrams): Consider the beam ABCD shown in Fig. 2. The beam is…

A:

Q: Question 4. A uniform, 8 m long beam with a mass of 1150 kg is hinged to a wall and supported by a…

A: a) Free Body Diagram: b)To calculate Tension take moment about Point O: mg*L2cos30=T*(8-2)cos…

Q: Consider the beam system below. Assume that the 300 N force is able to move anywhere along the beam.…

A: Consider the force  is located at a distance of x from point A.Draw free body diagram of the…

Q: In the following figure, a uniform beam of length 6.00 meters is supported by a horizontal cable and…

A:

Q: 13)The Beam in figure below is weightless. A moveable weight(mass)W of 300 Ibm is to be attached as…

A:

Q: A cantilever beam AB with a built-in restraint at end A is subjected to a combination of loads as…

A:

Q: Q3. Complete the following: 1. Find the reaction forces. 2. Draw the shear and moment diagrams. 3.…

A: To find out :- 1. Find the reaction forces. 2. Draw the shear and moment diagrams. 3. Find the…

Q: 1) Determine the tension in cable AB and the force developed in struct AC. 7 ft 13 ft 4700 Ib 16 ft

A: It is required to determine tension in cable AB and the force developed in struct AC.

Q: c) A thin-walled, cantilever beam supports two shear loads, one in the horizontal plane at its free…

A: Given:The cross-section of the beam is shown below; The thickness of the flange is

Q: When a beam has only uniformly distributed forces applied, the moment diagram consists of piecewise…

A: A beam with Uniformly distributed load given

Q: For the same beam as in Question 1, if the applied moment Mz on the cross section is 1.0 kN.m, the…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.