In the circuit below, Is=6*10^-16 of BJT and B=100. It is VA=infinite, which means the degree of early effect. Vin is 0.005sin (2000t) [V]. (1) To determine the magnitude of the amplitude above the Output signal(means ac component) , correct the circuit below to a small signal circuit. (2) Find the magnitude of the amplitude of the output signal(means ac component) (3) Draw a small signal circuit to find the input resistance and find the input resistance (4) Draw a small signal circuit to find the output resistance and find the output resistance

In the circuit below, Is=6*10^-16 of BJT and B=100. It is VA=infinite, which means the degree of early effect. Vin is 0.005sin (2000t) [V]. (1) To determine the magnitude of the amplitude above the Output signal(means ac component) , correct the circuit below to a small signal circuit. (2) Find the magnitude of the amplitude of the output signal(means ac component) (3) Draw a small signal circuit to find the input resistance and find the input resistance (4) Draw a small signal circuit to find the output resistance and find the output resistance

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A Phase Modulator has a phase deviation constant, Kp = 35°/V. The carrier signal is ec = 8 cos2n(800k)t, volts and the modulating signal is em = 5 sin2r(2000)t, volts. a. What is the equation of the PM signal? b. What is the maximum phase deviation? c. what is the amount of deviation in the carrier phase angle at t = 160µs?
Discuss the significant different between the construction of an E-MOSFET and a D-MOSFET.
Q4. For the circuit shown in Figure Q4: i) What is the type of MOSFET and the amplifier configuration? ii) Find the Q-point (Ip and Vps) iii) What is the device transconductance, gm? iv) What are the voltage gain and output voltage? v) Draw the input /output voltage waveforms showing the phase relationship between them. Be sure to label them properly. +20V IDON = 15 mA@ VcsON = 6V VGSTH = 1V 1kQ Rp C2 10M2 Ro1 out Vin 3.3MQ Ra, 47003 Rs 50mV Figure Q4
I need the answer quickly
Why is there a difference in the beta value? (D. C) and the beta (A. C) value in some transistor output characteristic schemes.
Subject : Electronics Engineering Draw and explain a small signal high frequency CE model of a transistor.
9.8. (a) Plot the even and odd parts of the signal of Figure. * In] 3. 2. ... ... -2-1 -6-5-4-3 01 2345 6
Please answer question a and b
i need the answer quickly
What is the difference between DC and AC analysis of an amplifier? State few characteristics of each analysis techniques.
Q6. Determine small signal voltage gain if VCEO =4.5 V. Transistor parameters (NMOS): k, = 100 pA/V, VIN-1 v, and A= 0.01 V. Transistor parameters (BJT): B = 100, VaE(on)= 0.7 V, and VA=00. 10V 8V Yo -38.08 b. -47.48 Oc -56.84 d-77.54 -66.15 -30.57