In Part IV of this lab, the identity of an unknown liquid will be determined by observing some of its physical properties. In lab, a student experimentally obtained the following data recorded below: Solubility in water: soluble Density: 0.785 g/mL Boiling point: 80.9 °C Using Table 1 in the lab manual, determine the identity of the student's unknown liquid. Note: Make sure to read the information box above the table! O ethyl alcohol O cyclohexane isopropyl alcohol There is not enough information to determine the identity.

In Part IV of this lab, the identity of an unknown liquid will be determined by observing some of its physical properties. In lab, a student experimentally obtained the following data recorded below: Solubility in water: soluble Density: 0.785 g/mL Boiling point: 80.9 °C Using Table 1 in the lab manual, determine the identity of the student's unknown liquid. Note: Make sure to read the information box above the table! O ethyl alcohol O cyclohexane isopropyl alcohol There is not enough information to determine the identity.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Note: The explanation of this work would be we did a work on the process of preparing diverse solution sets and regarding that these are the following sets of questions. PART: 2 What happens to the solution's concentration when you add more solute to the same volume of solvent? How to raise the concentration of an aqueous solution? When is the ppm concentration applied? What do you conclude from this lab? Was your hypothesis confirmed or not? Explain your answer.
You are asked to prepare a 1.000 L solution of 4.5 M you commit a user error while preparing this solution. Assumed volume Volumetric error Preparation details Added water 2.0 cm above the line, which corresponds to 8.2 mL (0.0082 L) additional solution volume C6H12O6 (glucose; molar mass = 180.16 g/mol) in a lab by dissolving 811.0 g of glucose in water. Consider the following two scenarios in whic Prepared in a beaker Prepared in a volumetric flask 1.000 L You add the glucose to a volumetric flask and then add water until it dissolves. The water bottle you are using has a worn tip, and you inadvertently add too much water such that the meniscus is above the line. The diameter of the neck of the volumetric flask is 2.29 cm. 811.0 g glucose Concentration: You decide to evaluate and compare the errors you made while preparing the solutions using the different methods. Calculate the actual concentrations of the intended 4.5 M glucose solutions prepared by each method based on their…
1a. Medical saline typically consists of 4.50 g of NaCl in 500.0 mL of solution. What is the molarity of this solution? What is the molality of this solution? (Use the density of water = 1 g/mL; for this question, since the concentration is dilute you may assume that the added NaCl does not result in a change in volume when it is added to water.) Do your answers make sense? Would either of these values potentially depend on temperature? 1b. Stomach acid is essentially a solution of hydrochloric acid (HCl). When first secreted, stomach acid has a concentration of roughly 0.160 M HCl. How many moles of HCl are present in 50.0 mL of stomach acid? 1c. If 5.0 mL of saline is introduced to 15 mL of stomach acid. What is the mole fraction of NaCl? What is the mole fraction of HCl? (In your calculations, use the molarities from parts (a) and (b) above).
What is the freezing point of a ethanol solution if that same solution boils at 79.5 ℃? The normal boiling point and freezing point of pure ethanol (C2H5OH) are 78.29 ℃ and -114.2 ℃, respectively. For ethanol, Kb = 1.23 ℃/m and Kf = 1.99 ℃/m.Please enter your response in standard notation to one decimal place.
10. Draw a graph of the concentration of NaCl (x-axis) against the calculated density (y-axis) for the data in section B above. Find the straight line equation. The graph has to be manual on graph paper, and you should draw a best-fit straight line. 11. Calculate the density of 35% NaCl from your graph.
. Prepare 50 mL of an aqueous solution of 2.5% (w/v) NaCl (sodium chloride, salt).Determine how many grams of sodium chloride are required. Show all steps for this calculation, using dimensional analysis with units clearly identified.2. Prepare this aqueous solution, using a volumetric flask for the precise final volume measurement. It is not a problem to use tap water.3. Clearly write the procedure (step by step) for making this solution
Use the solubility graph to answer the following question. Name the type of solution if 750 g of NaNO3 was placed in 600 mL of the water at 50 °C. Solubility Curves KI Solubility (g/L of solvent) 1400 1300 1200 1100- 1000 900 800 700- 600 500 400 300 200 100 0 polyunsaturated unsaturated saturated 0 supersaturated -HCI saturated with excess solute SO₂ NaNO3 -KNO₂ NHẠCH KCI -KCIO3 NaCl NH3 10 20 30 40 50 60 70 80 90 100 Temperature (°C)
If a sample of water is being determined to contain 389 ppm of lead, how many g of lead does one gallon (1 gal = 3785 g of water) of this lead contaminated water contain? Round your answer to 4 decimal digits.