In lab, you observed and classified multiple reactions. You mix a clear blue solution and a clear yellow solution and observe the results to determine if a chemical reaction took place. Which of the following is NOT an indication that a chemical reaction took place? O The resulting solution violently bubbled. O An orange precipitate was formed. O The resulting solution dropped in temperature. O The resulting mixture became neùtral (underwent a pH change). O The resulting solution appeared clear green.

In lab, you observed and classified multiple reactions. You mix a clear blue solution and a clear yellow solution and observe the results to determine if a chemical reaction took place. Which of the following is NOT an indication that a chemical reaction took place? O The resulting solution violently bubbled. O An orange precipitate was formed. O The resulting solution dropped in temperature. O The resulting mixture became neùtral (underwent a pH change). O The resulting solution appeared clear green.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

(please type answer no write by hand)
O Kf will change depending on what solute is dissolved in the solvent. QUESTION 11 Which term can be used to describe the process in the reaction below? 2 NaHCO3 (s) Na2CO3 (s) + H2O (g) + CO2 (g) Dissociation Precipitation Hydration Decomposition QUESTION 12 Which of the following would NOT be considered valid sources of error in a laboratory experiment? Click Save and Submit to save and submit. Cick Suve All Answers to save all ansicers
13. A chemistry student offers a possible improvement to this lab. Since one goal of this lab is to determine the mass of the precipitate produced, wouldn't it be possible to measure the mass of an empty beaker, mix the solutions, and boil off the water until it is entirely evaporated, leaving only solid behind? Then the beaker with the precipitate could be weighed, and the difference between this mass and that of the empty beaker would be the mass of the precipitate. This would eliminate the need for the filtration step. Explain why this is a poor suggestion. Remember to check your reasoning on this question and all other questions with your instructor.
Three moles of sodium carbonate are mixed with two moles of lead nitrate in aqueous solution, leading to formation of a solid precipitate. How many moles of spectator ions remain in solution, assuming 100% yield of the precipitate? A. 12 B. 10 C. 5 D. 6 E. 11
Paraffin wax vapor reacts with oxygen gas to form carbon dioxide gas and water vapor. Paraffin wax is a mixture of hydrocarbons having a general chemical formula of CnH2n+2 where n is at least 16. Assume that for this wax n=30 1. Write the symbolic form of this chemical reaction. 2. Classify this chemical reaction and write the general form of this type of reaction. 3. If the wax is a solid at room temperature, why does the reaction state that it is a gas? 4. Explain why the reaction stopped after the glass was placed over the candle. 5. Explain what was on the inside surface of the glass and where it came from.
You have an unknown solution and you want to determine if it contains ammonia. How will you detect its presence in the laboratory analysis? Please provide two ways to analyze its presence and explain your chosen technique in determining the ammonia.
Classify each of these reactions. Ba(CIO, ), BaCl, + 3 0, CaO + CO, → CaCO, single replacement combination O double replacement single replacement decomposition double replacement combination decomposition NANO, +HCI → NaCl + HNO, ZNSO,+Mg → Zn + MgSO, combination double replacement decomposition single replacement double replacement combination single replacement decomposition
Write the equation for the dissolving of iron(II) hydroxide in water. Be sure to specify the state of each reactant and product. +
b) To 1 ml of antimony trichloride solution in a test tube add sufficient water to form a precipitate. What is the precipitate formed? Add 6M hydrochloric acid drop by drop until the precipitate dissolves. Add more water. Write the equation for the reaction. c) Place 50 mL of water into a 100-mL beaker and add 5 mL of 0.1M ferric chloride. Acidify the solution with 5 drops 6M hydrochloric acid. Add 5 mL of ammonium thiocyanate solution to the mixture. Write the equation for the reaction involvea.
1) Get two medium test tubes. Into one, place about 2 mL of a solution of copper (II) sulfate. Into the other add about 2 mL of a solution of sodium phosphate. Note the appearence of the two solutions and then mix them together noting any changes that have taken place. -Changes that take place -Balanced chemical equation -Balanced ionic equation -balanced net ionic equation
Write the (i) balanced conventional equation (CE), (ii) total ionic equation (TIE), and (iii) net ionic equation (NIE) for each of the reactions below. Include all state symbols. Assume that, if there is a reaction, it will go to completion. If there is no reaction, write "No Reaction" for the NIE but still complete the CE and TIE. a. Aqueous solutions of potassium sulfate and calcium iodide
Question 9 A student is attempting to identify the anion in an unknown solid. The student first dissolves the solid in aqueous solution, and then adds aqueous barium nitrate. A solid product forms. The student then adds hydrochloric acid, which causes the solid to dissolve. Which of the following anions might be in this unknown sample? Select an answer and submit. For keyboard navigation, use the up/down arrow keys to select an answer. a Phosphate Nitrate Carbonate d Sulfate e Chloride