In lab, you add 2.018 g salicylic acid to a 125 mL Erlenmeyer flask, as listed in the procedure. You carefully add 4.0 mL acetic anhydride, swirl for a few minutes, then have your TA add 5 drops of sulfuric acid. After completing the synthesis and filtering, you place the crystals to dry on an evaporating dish that weights 21.844 g. After drying, the crystals and evaporating dish weigh 23.108. Calculate the percent yield of aspirin.

Q: In running a Beer’s Law lab, you are given 50.00 mL of a 25.00 µM solution of the organic pigment…

A: The initial concentration of crystal violet is 25.00 µM and volume of this solution is 50.00 mL…

Q: Calculate the cfu per ml of each dilutions and cfu per ml of the stock suspension (highlighted…

A: basically, in this question we have to find the cfu per ml of each dilution and dilution values…

Q: Pipets used for transfer of samples of solutions are always rinsed with a small portion of the…

A: The percent error in an experiment is obtained by calculating the ratio of total error divided by…

Q: The unknown salt you will be identifying is composed of one of the 6 anions and one of the 6 cations…

A: The preliminary tests provide information that helps to identify the cations and the anions present…

Q: The formula weight of CaCO3 is 100.087 ±0.004 g/mol. You are preparing a standard solution of CaCO3…

A:

Q: A. Determine the concentration of the glucose stock solution in mg/mL. B. Complete the table above…

A: For preparation of stock solution, 500 mg of glucose was taken to form 25 mL of the solution.

Q: Data: (make sure to include appropriate units) Unknown number 1.509g Trial 1 Trial 2 0.51ml 1.15ml…

A: • In a balanced chemical reaction the reactants react and products form in the molar ratio of their…

Q: Using the stock solution above, the student made additional dilutions, with the final volumes below.…

A: [Fe(NO3)3] = 0.200 M [KSCN] = 0.00200 M Volume of  Fe(NO3)3 used = 9.60 mL millimoles of Fe(NO3)3 =…

Q: If 120 mL of a 10% stock solution is diluted to 240 mL, the final concentration of the solution is…

A:

Q: In a fractional distillation experiment, what do you think would be the result if you had distilled…

A: The fractional distillation is the method for separating the miscible liquids. It works on the…

Q: Which of the following would result in an incorrect value for the density of the acrylic slug using…

A: There are various reasons for error in density: mass change, temperature, etc.

Q: For each of the following scenarios, determine if the error will cause the molarity of the…

A: For Error in molarity:- (A) 50ml water add instead of 25ml means solution gets more diluted hence…

Q: An oil sample had its iodine number determined using the pyridinium tribromide method. The sample…

A:

Q: 150 140 130 120 110 100 90 80 70 60 50 40 30 XCIO3 10 -Ce₂(506)s D Đ 10 20 30 40 50 60 70 80 90 100…

A:

Q: You are assigned one of the unknown compositions below according to your last name. Let’s assume you…

A: The three components can be separated by the principle of solubility of organic and ionic compounds.…

Q: Can someone PLEASE check my work to see if I calculated this problem correctly. I had to find the…

A: Mass of the solution is equal to the product of number of moles of solution and molar mass. So, the…

Q: Describe the simple distillation graph/curve.

A: Distillation is the separation technique where different components of a mixture are separated based…

Q: two solvents A (d=0.859 g/mL) and B (d = 1.290 g/mL) are immiscible. When 12.0 mL of solution A is…

A: Density=1.0314g/ml

Q: Weigh out 5g of table salt. Dissolve it in 50mL of distilled water in a container using a stirrer…

A: Given information is as follows: The mass of table salt = 5 g The volume of distilled water = 50 mL…

Q: What will you see in the blood of a diver that has been deep in the ocean but then came rapidly to…

A: In accordance with Henry's Law, with the increase in pressure, the solubility of a gas also…

Q: Refer to procedure in Part 1 of your lab manual. You have a solution that you wish to test for…

A: Benedict test is used to determine the presence of reducing sugar in water. Benedict's solution is a…

Q: is In the school laboratory, a usually used as fractionating column. The glass called as beads serve…

A: A fractional distillation is used to seperate volatile compounds having their similar boiling point,…

Q: Notice that the mass of copper in the digestate for Lab A, Sample 1 has been calculated for you…

A:

Q: Determine which of the following steps show correct technique when using a 250.00 mL volumetric…

A:

Q: CI. gut = OH 0°C concentrated X 1. LIAIH 2. H₂O* NaOH

A:

Q: Which of the following statements is true? A Liquids can be weighed using a weighing paper. B In…

A: Find out the true sentence from given four sentence and explain why it is correct while others are…

Q: = O CHEMICAL REACTIONS Calculating molarity using solute mass A chemist prepares a solution of…

A:

Q: Prepare the following test solutions Approximately 0.5 M KOH by diluting 20 mL of 6 M KOH into the…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: What happens when you put 1 tablespoon of oil in water? What happens when you drop soap into the…

A: Result of these activities is based on like dissolved like. Molecules having same behaviour i.e.…

Q: Create a graph displaying the relationship between Concentration and Density for the sugar solution.…

A: The data of concentration v/s density given is,

Q: You obtain an Unknown Sample from the Stockroom.  You begin testing the solution through the steps…

A: Pb, Hg and Ag all produce white ppt of PbCl2, Hg2Cl2 and AgCl respectively . But in hot water, PbCl2…

Q: Six clean, dry, 18 x 150mm test tubes 1-6 was labeled.  5.00 L of 2.00 x 10-3 M Fe(NO3)3 solution…

A: Please note the typo in your question.  Actually, we have to add, 5.00 mL, NOT 5.00 L of 2.00 x 10-3…

Q: How can we remove hardness from water? write any one method

A: The hardness of water are  two types: 1.Temporary Hardness :The presence of magnesium and calcium ,…

Q: A student would like to prepare a 0.010 M solution from a 1.0 M stock solution with minimal error.…

A: To answer: Which method has the smallest overall relative uncertainty and what is the value?

Q: Describe how to create a 3.0 mL sample with concentration of 1.5 x 10-4 M from a starting stock…

A: Dilution Dilution process is the process to change (decrease) the concentration of solution in…

Q: Procedure: Experiment 1. Prepare 50 mL of an aqueous solution of 0.10M NaHCO3 (sodium bicarbonate,…

A:

Q: PROCEDURE: 1. Design a procedure for preparing 100 mL of 0.50 M sugar solution. 2. Present your…

A: Procedure is in 2 nd step .

Q: Based off information from the attachment, please help with #9 on second attachment

A: We have been asked to provide help with question #9. Final volume of isopropanol ice solution = 70ml…

Q: I had a 6.00 M NaOH solution and I diluted it to a 50mL solution of 0.300 M NaOh solution by adding…

A: According to the unit conversion, 1 mL is equal to 10-3 L. The number of moles in the 20 mL of the…

Q: When you walked in to Mrs. Bateast's lab today, you noticed that your partner group had a 0.05432 ml…

A: Given: Initial volume of mixture = 0.05432 mL. And volume of water added = 5.2 mL.

Q: Q3/ How many grams of NaAsO, should be weighed out to prepare a stock solution of 100 mg/L in 500 mL…

A: A numerical problem based on quantitative analysis, which is to be accomplished.

Q: One milliliter (mL) of pure water has a mass of 1 gram (g). You add 100 mL of water and 100 mL of an…

A: A separatory funnel is used to separate two immiscible liquids, 2 layers are seen in a separatory…

Q: 1.A student performed an experiment to find the number of water molecules associated with the CuSO,…

A:

Q: Using recrystallization techniques, a student attempts to purify 0.50 g of compound H. Based on the…

A: Given : Mass of sample = 0.50 g Mass of purified crystals obtained = 0.396 g And maximum percent…

Q: If you have 155 mL solution of a 0.762 M FeCl, solution, how many grams of FeCl, are contained in…

A: Fill in blanks as shown on problem

Q: Given a solid sample that contains impurities, how would you determine which solvent to use for…

A: A solid sample that contains impurities.

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.