In an oscillating LC circuit, the total stored energy is (6.11x10^-1) J and the maximum charge on the capacitor is (5.6230x10^-5) C. When the charge on the capacitor has decay to (1.187x10^-6) C, what is the energy stored in the inductor? Express your result in mJ with three significant figures. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: Answer x10

In an oscillating LC circuit, the total stored energy is (6.11x10^-1) J and the maximum charge on the capacitor is (5.6230x10^-5) C. When the charge on the capacitor has decay to (1.187x10^-6) C, what is the energy stored in the inductor? Express your result in mJ with three significant figures. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: Answer x10

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A capacitor is made of 2 rectangular metal plates with side length of 3cmx6cm separated by a distance of 2.36cm with water in between the plates. The capacitor has a voltage of 110v and is not connected to a battery. Calculate the capacitance. What is the new capacitance if we replace water with a new dielectric material with a constant of 3.75 in between the plates? What is the new voltage? What is the charge on each plate? Follow this format- Given: Required: Equtions: Solution: Answer:
the equivalent impedance of a capacitor in parallel with an iductor is equivalent to an open circuit (i.e equal to infinity) at a certain frequency.Drive an expression for this frequency
i need the answer quickly
A sinusoidal current of 1.5 Arms is flowing through a capacitor of capacitance 20 uF. Find the Voltage across the capacitor at a frequency of 250HZ. Select one: O a. 0.471 O b. 0.047 O. 47.746 O d. 0.181
Question 5 We have a 1 H inductor connected between the input and the output of a circuit with a gain of -100. We wish to replace this inductor with two new inductor: one across the input and one across the output. Find the values of these two new inductors using Miller's theorem. Show your calculations.
Please use Nodal Analysis to solve this problem please. For the following circuit assume it has been in this state for a very long time . Determine the energy stored in the inductor and the capacitor Wl and Wc
Find the voltage across and the current through the capacitor both at =20μSec Please try some part in typing format...
An inductor with L = 150mH and r = 200(Omega) is in series with a capacitor, a resistor, and a generator of w = 1000 rad / s The voltage across the inductor Vind is measured to be 10.87 V, VR is measured to be 4.65 , and Vc is measured to be 5.96 V. What is the generator voltage V? (Hint: This is the measurement to be performed in this laboratory for LCR circuits. Use the appropriate equations to find VL and Vr' and then use them and the values of VR and VC to calculate V.)
The current in a 24-mH inductor is given by the waveform in the figure below. Find the waveform for the voltage across the inductor.
In the shown circuit, the capacitor is initially uncharged. The switch S is closed at time t-0. Find the current in the circuit (in µA) when the charge on the capacitor is 8.1 µC. 10 V 20 juF 0.05.M
Find the equivalent circuit of the given circuit. Voltage across inductor at t=39micro second. Also find the equation for the current and the voltage. Time constant of the circuit?
Required information Consider the given circuit, where L-12 mil and is-3emA 4 mmH 6 mH NOTE: This is a multi-part question Once an answer is submitted, you will be unable to return to this part Find the energy stored in the given inductor Lat -1s The energy stored in the inductor is 24.53 nJ