A resistor and a capacitor are connected in series across a supply of 250V. When the supply frequency is 50HZ, the current in the circuit is 5A. When the supply frequency is 60HZ, the current is 5.5A. Find the value of the capacitance.

A resistor and a capacitor are connected in series across a supply of 250V. When the supply frequency is 50HZ, the current in the circuit is 5A. When the supply frequency is 60HZ, the current is 5.5A. Find the value of the capacitance.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: O2- Astring of3 sus pevision Asulators, if the voltage across 17.5 KV and each unit iasulator to…

A: In this question we need to find a efficiency of string.

Q: What do you understand by Ferranti effect? Subject Power Transmission and Distribution

A: to explain the ferranti effect

Q: a) State Kirchoff's first and second laws and name the fundamental physics principle that each law…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: A 220 microfarad capacitor has an initial charged of 800 microcoulomb. It is discharged through a…

Q: A) A solid specimen of dielectric, dielectric constant of 4.5, shown in the figure has an intemal…

A: As per Bartleby guidelines we are allowed to solve only question with maximum three subparts, please…

Q: Example A 13 mm-diameter tensile specimen has a 50 mm gage length. The load corresponding to the 0.2…

Q: consider the following circuit composed of three resistors and two batteries. each resistor has a…

A: Given circuit is,I1 = 0.600 AI2 = 0.800 AE1= 10.0VAll resistor values are taken 2 ohm. (Since…

Q: What is the value of the phase difference between voltage and current for a purely resistive, purely…

A: R = resistance L = inductor C = capacitor L= lagging load C = leading load R = Both voltage and…

Q: *Chapter 27, Problem 045 In the figure the resistances are R1 1.6 V, and 82 E3 = 4.2 V. What = 0.99…

Q: Problem 2. (a) Find the equivalent resistance between point a and point b in figure below. (b) If…

A: It is given that:

Q: Q2]] write swing equation (P. U.) for Power system stability. - - Q-LAB V copl. v Si-e Define…

A: The swing equation is useful to analyze the stability in terms based on disturbance in the system…

Q: 100 V 50 8mH 600 200 A The switch is initially open in the circuit diagrammed above. A) What current…

A: In the Transient analysis of any circuits, the Inductor always opposes the sudden change of…

Q: following equation applies: V = IR. Outside of the linear range, V*IR, outside of the linear ranges…

A: In the given question we need to plot the i-v plot for the resistor and find the range of voltage…

Q: Can you explain in detail? Thank you HIGH VOLTAGE Define Pschen’s theory related to breakdown of…

A: HIGH VOLTAGE To understand high voltage first we need to understand voltage. Voltage is the…

Q: The electric current I in a circuit shown in the figure was measured as a function of the resistance…

A: In the circuit Relationship between the current, emf and resistance. Where r internal resistance R…

Q: Apply each of diode approximations given the following parameters: D1: Si, rB = 2 Q, rR = 220 k D2:…

Q: What is the characteristic, given in the figure and which curve represents operation at…

Q: In the figure below, N batteries, each with electromotive force ɛ and internal resistance r, are…

A: According to question: The circuit is drawn as

Q: State the condition for the stability of a linear system.

A: Linear system:- If a system satisfies the superposition theorem or additivity and homogeneity both…

Q: Post a response to the following discussion questions. The introductory course sessions have…

A: Solution of first subpart: It is asked to cite some sources of nonlinearities that arise in the…

Q: In the figure is shown a battery having an emf of 12 Volts and an internal resistance of 0.40 Ohm.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 3: An inductance of 1 henry and a resistance of 2 ohms are connected in series with an e.m.f. of Eet…

Q: A J- type thermocouple is used to measure the temperature in a heating process. The length of the…

Q: thermocouple which has an input of a temperature change, the output form is Select one: a Resistance…

A: We need to tell about the output of thermocouple.

Q: Write down the equations for the instantaneous charge and current for charging and process in a dc…

A: It is given that: DC RC series circuit

Q: Q2) In a co-axial cable, the outer radius and the applied voltage are constant as r2 = 8.4 and U =…

Q: Using this diagram: Given that This circuit runs on the flashbulb of a camera. Circuit is powered by…

A: For the given circuit, source voltage E=4×1.5=6 V, capacitor C=50 mF, resistor R1=10 Ω, flashbulb…

Q: Sample Problem continued with solution process Step 1: Drawing a circuit diagram and labeling the…

Q: A thermistor is being used to measure temperature. For a given resistance R the temperature is given…

A: For a resistance R, The temperature measured by the thermistor is given by the following equation,…

Q: A 6-uF and a 10-uF capacitor is connected in parallel are in series with a 12-uF capacitor. The…

Q: Q2 () () What is the difference between a Wheatstone bridge and a Kelvin bridge? Your explanation…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: We have the following electronic circuit and the corresponding load line and diode V-I response.…

A: According to the question, we need to find the value of source voltage, resistor R, the approximate…

Q: 1- Why dose the I-V characteristics pass through the origin? 2- Give a definiti

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Watch the video "Can 100% renewable energy power the world?" by Federico Rosei and Renzo Rosei.…

A: Renewable energy: Renewable energy is energy that comes from natural sources that can be…

Q: (a) defibrillator sends a 6 A current through the chest of a patient by applying a 11000 V potential…

Q: Q5 Figure Q5 shows a Heating Room. There is a thermal system consisting of an electric heater in a…

A: From heater heat that enters to room is q1. The heat is transferred to surroundings is q2 & same…

Q: 6) You work as an engineer in a company and you have been given the assignment of measuring the…

A: We need calculate conductivity at both temperature, and energy band gap .

Q: (b) Referring to the waveforms shown in Figure Q1(b), 60 A 60° -20 V. Figure Q1(b) (i) Sketch the…

Question

Show complete and step by step solution.

A resistor and a capacitor are
connected in series across a supply of
250V. When the supply frequency is
50HZ, the current in the circuit is 5A.
When the supply frequency is 60HZ,
the current is 5.5A. Find the value of
the capacitance.
96.436 microfarad
O 43.966 microfarad
34.696 microfarad
63.943 microfarad
O 69.436 microfarad
36.496 microfarad

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Xc 10 ? 100 2 R 20 2 E = 120 V Z
3. a) List and describe the suggestions of two major assumptions of the lumped capacitance method. b) For quick response of a thermocouple to observe varying temperature of fluids which one of the following suggestions is correct. Explain your answer by giving the reasons. )Diameter must be large i) surface heat transfer coefficient must be large Bi <0.1 iii)material specific heat must be large iv)material density must be large
can someone help me with parts A-C and explain the concepts for the slope parts explain how exactly you are getting those numbers
Describe how steady-state accuracy of the system can be measured. Determine the accuracy of the system given different types of test inputs. Show examples for every type of test inpts to prove your answer.
Identify the characteristics of AC and DC voltage. Runs at a higher temperature Answer 1Choose...DCAC More dangerous to transfer Answer 2Choose...DCAC Easy to produce Answer 3Choose...DCAC Easier to transform voltages Answer 4Choose...DCAC Voltage remains at a constant value Answer 5Choose...DCAC Cheaper to produce
In the figureBy solving with the Surrounding Flow Method;a) Find the value of the ambient current (Three circumferencesThe correct ones of the current).b) Find the Currents of all elements (6element current).c) Find the Voltages of all elements (6the voltage of the element).d) Find the Powers of all elements (6strength of its element).e) Show that the Tellegen's Theorem is satisfied.(Select Perimeter Currents clockwise)
- Define the Zeroth law of Thermodynamic? -What is Energy? And Energy forms?
Given, A=5 B=2 c=4 Given circuit Diagram R₁= AA.C2 = 55.4-2 52.42 R2 = AB.C 223 R3 = BCA = 24.52 R4 CA.B 2 $ 45.22 RS = AC-BR 54-2-2 R6 = BA. C 22 ⇒ 25-4-2 42052 R7= (BAR X = 2 AB V ⇒ 25.2 V I = 0 BCA 0.245 A
I need the answer as soon as possible
None
A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.12 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 135KV. Find the Voltage distribution across each unit and the String Efficiency
Q1. Give the definition of: a) Resistance: b) Reactance: c) Phasor diagram: d) What is the unit of reactance?