Answered: In an open channel, velocity of flow…

In an open channel, velocity of flow was found to be 1.23 m/s. If average bed shear stress is 1 N/m?, then the Chezy's coefficient Cis nearly.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter10: Stresses In A Soil Mass

Section: Chapter Questions

Problem 10.13P: Repeat Problem 10.12 for q = 700 kN/m2, B = 8 m, and z = 4 m. In this case, point A is located below...

See similar textbooks

Related questions

Q: A closed cylindrical tank 900 mm in diameter has a wall thickness of 0.8 mm. The allowable…

Q: A line load and a point load are resting on the ground level as shown. Calculate for the net stress…

Q: Determine the stress increase due to the embankment load at point A as shown in Figure 2. The unit…

A: Draw the figure.

Q: Compute the stress in Mpa in a 90 cm pipe with a wall thickness of 9.50 mm if water fills it under a…

A: Given data, Diameter of the pipe= D = 90cm = 900mm Thickness (t) = 9.5mm Head= H = 70m

Q: 0,90m 1m Sand e= 0.47 Gs 2.68 6m

A: Sand e= 0.7 Gs=2.68 To find Saturated Unit weight of soil and total pressure, pore pressure,…

Q: Take o, = 580 kPa (Figure 1) Express your answer to three significant figures and include the…

A: Consider the given figure.

Q: Assuming static condition, what is the stress in the pipewall if the wall thickness is 12.50 mm and…

Q: 2. A rectangular loaded area ABCD shown in figure below carries a load of 80kN/m? Using Fadum chart…

A: Draw:

Q: A concentrated load of 1800 kN is applied on the surface of the ground. By using Boussinesq…

Q: A vertical load of 320 kips is applied to a 5ft by 5ft area at the ground surface that is level in…

A: P=320 kipsArea= 5×5 ft To find-

Q: An open top vertical standpipe 12 ft in diameter and 50 ft tall contains water with a specific…

A: Given Data: Inner diameter, d=12 ft Thickness, t=0.5 in = 124ft Specific weight of water, S = 62.4…

Q: Calculate the vertical stress at a depth of 50 ft below a point 10 ft oubide the corner (along the…

Q: A UU test was conducted on saturated clay. The cell pressure was 200 kPa and failure occurred under…

A: Dear sir, Please find the answer in the below attachments Thank you

Q: Sketch Mohr's Circle for Strain. Indicate the following Y Max InPlane on your sketch the following…

Q: The following figure shows the stress-displacement results of four direct shear tests under…

A: From the given graph: Normal stress Shear stress (At failure) psi 10 9 20 18 40 34 80 60

Q: 9. Acylindrical tank has an inner radius ofr = 1.5m and length of L = 3m, if it subjected to an…

Q: A concentrated load of 1521 kN is applied at the ground surface at point A whose coordinate is…

Q: 11. Consider the downward flow of water through a layer of sand in the tank shown. (see picture…

A: The question is based on the flow of water through the layer of sand in the tank. The dimension of…

Q: ertical and in recent.

A: According to given dataDepth of zone = 500m

Q: The pressure drop in a 30 cm diameter horizontal pipe is 60 kPa in a distance of 15 m. The wall…

Q: In a 4 cm diameter pipeline carrying laminar flow of a liquid withu = 1.6 centipoise, the velocity…

Q: A penstock pipe 10m diameter carries water under a pressure head of 100m. If the wall thickness is…

A: Given data, Pipe diameter D = 10 m = 10000 mm Pipe thickness t = 9 mm Pressure head = 100 m…

Q: The flow of water (mass density = 1000 kg/m³ and kinematic viscosity = 106 m²/s) in a commercial…

A: Given data- Mass density=1000 kg/m3, Kinematic viscosity = 10-6 m2/s, Equivalent roughness ks=0.12…

Q: An open top vertical standpipe 12 ft in diameter and 50 ft tall contains water with a specific…

A: It is required to determine the pressure in the vessel. P=γwh Here Yw is the specific weight of…

Q: Find effective stress at A and determine the stability of cut under given condition. (ii) What…

A: Calculation of soil mechanics problemPart i) effective stress at A and…

Q: An embankment load on a silty clay soil layer as shown below. Determine the stress increase under…

Q: Q1: Find the boundary layer thickness (6) equation, the shear stress (t) and the coefficient of drag…

A: Given velocity profile: uU=2yδ-3yδ2+3yδ5 Using von Karman momentum integral equation τoρU2=dθdc:…

Q: b.) Determine the value of P so as not to exceed the allowable shearing stress of 138 Mpa in the…

A: a.) Given data Allowable bearing stress=310.5MPa b.) Given data Allowable bearing stress=138MPa

Q: 3. The upward flow of water through a layer of sand in the tank shown in figure has the following…

A: e = 0.50G = 2.67To find:1. Effective stress at point A.2. Effective stress at point B.3. Upward…

Q: ile of Sm the load. 5-11 A uniform surface load of 220 kPa is applied over the area shown below.…

A: Given Data: The uniform surface load is, q=220 kPa To Determine: The stress increase in soil due…

Q: Q4: A line load of 100 kN/m run extends to a long distance. Determine the intensity of vertical…

A: Given: The vertical line load is P=100 kN/m. The perpendicular distance from the line is xf=2 m. The…

Q: A cylindrical steel pressure vessel with a diameter of 1200 mm and a wall thickness of 20 mm is…

A: In thin cylinders the circumferential stress is twice than that longitudinal stress.

Q: An embankment load on a silty clay soil layer as shown below. Determine the stress increase under…

Q: 3. At a different location in the Chesapeake, the same u-=4.4 cm/s and z,=3.1 cm were measured. At…

A: This study presented estimations of the bed shear pressure related with the three layered limit…

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

In an open channel, velocity of flow was found to be 1.23 m/s. If
average bed shear stress is 1 N/m?, then the Chezy's coefficient Cis
nearly.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An embankment load on a silty clay soil layer as shown below. Determine the stress increase under the embankment at points A and B that are loaded at a depth of 6 m below the ground surface. 5 m 1H:2V 1H:2V 1H:1V 8 m 13 y=18 kN/m Y=18 kN/m³ 6 m : B : A CS Scanned with CamScanner
Q: You have been assigned to check the stability of a pond constructed in stiff saturated clay underlain by a layer of sand. The necessary information are given in the following figure. (i) Find effective stress at A and determine the stability of cut under given condition. (ii) What should be water level into the pond to ensure factor of safety = 1.5. (Given that yw = 9.81 kN/m³) H = 5 m 7m 2m 2m J Saturated clay Sand Ysat = 16 kN/m³ 4m Ysat = 15 kN/m³
Q- Velocity distribution function for flow over a channel is represented by u = 0.6z - z² where u is the velocity in m/sec at a distance 'z' m from above the channel. If dynamic viscosity of fluid is 0.8 Ns/m², then find the shear stress at 0.25 m from boundary.
Q1: Find the boundary layer thickness (6) equation, the shear stress (t.) and the coefficient of drag (Co) if the velocity distribution in the laminar boundary layer over the face of a spillway was observed to be: (An +-0)-()*+C) U
In a 4 cm diameter pipeline carrying laminar flow of a liquid withu = 1.6 centipoise, the velocity at the axis is 2 m/s. What is the shear stress midway between the wall and the axis?
Open channel flow question
solve situation 2
Take o, = 580 kPa (Figure 1) Express your answer to three significant figures and include the appropriate units. HÀ ? o, = Value Units Submit Request Answer Figure Part B Determine the shear stress acting on the inclined plane AB. Express your answer to three significant figures and include the appropriate units. В HA ? 30° Value Units A
A circular Beam with roller joint R L y y oo = 298.6055 Pa Ro = 2.0649 m L = 61 m Material Data E[ GPA] Oyp [MPa] p [kg/m^3 V 200 0.3 700 7800 Find: Displacement in X, Y, Z direction, von misses stress, tresca stress, and triaxial stress at x = L, at x = L/2 and x = 0. Please show all work
2 decimal places for the answer, pls answer asap
Stress. Distribution in soil.
Solve.