A concentrated load of 1800 kN is applied on the surface of the ground. By using Boussinesq equation. Determine the following: 1. Vertical stress increment due to this load at a depth of 4.8 m directly below the load. 2. Vertical stress increment due to this load at a depth of 4.8 m below the ground level and at a horizontal distance of 3.7 m from the line of the concentrated load.

A concentrated load of 1800 kN is applied on the surface of the ground. By using Boussinesq equation. Determine the following: 1. Vertical stress increment due to this load at a depth of 4.8 m directly below the load. 2. Vertical stress increment due to this load at a depth of 4.8 m below the ground level and at a horizontal distance of 3.7 m from the line of the concentrated load.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Pb-4, A point load of 700 kN is applied on the surface of thick layer of saturated clay. Using the Boussinesq's elastic analysis, find the estimated vertical stress at a depth of 2 m and radial distance of 1 m from the point of application of the load.
I need correct solution
4. Estimate the profile of vertical effective stresses for Zw= 100m and for Zw=3000m. Compare results. Z = 2 m A 16 Water surface Zw Soil surface Ysat = 17 K (108.3 pcf)
b) An electric pole is held vertically by three equally spaced wires tied at the top of the pole. Each wire is inclined at 45⁰ with a tension of 1 kN, Calculate the vertical stress increase at 1 m depth and the elastic settlement below the axis if E is given as 40 MPa and μ = 0.45. Use Boussinesq’s point load theory
the profile of on 2 m from the load. 5-11 A uniform surface load of 220 kPa is applied over the area shown below. Estimate the stress increase in soil due to the surface load at a depth of 15 m below point A. 10 m 20 m IT 10 m A
Stress. Distribution in soil.
A uniformly distribute line load of 500 kN/m is acting on the ground surface. Based on Boussinesq's theory the ratio of vertical stress at a depth 2 m to that at 4 m, right below the line of loading is.
A concentrated load of 2000 kN is applied at the ground surface. Determine the vertical stress at a Pono winch is 6m directly below the load, Also calculate the vertical stress at a point R which is at a depth of 6m but at a horizontal distance of 5m from the axis of the load.
answer the following
The cross-sectional area of bar ABCD is 500 mm^2 . Determine the stress in segment BC
The center of a rectangular area at the ground surface has Cartesian coordinates (0, 0), and one corner has coordinates (7, 18). All dimensions are in meters. The area carries a uniform pressure of 135 kPa. Estimate the stresses at a depth of 15 meters below the ground surface at each of the following locations: (0, 0), (0, 18), (7, 0), (7, 18), and (12, 28).a. Obtain the values by the Boussinesq methodb. Compare the results with those of the 2:1 methodc. Comment on the resultsHint: In the Boussinesq method, the equations attached can be used.
Compute the increase in the stress at point A when two line loads of value 90 kN/m and 325 kN/m act on the soil surface at a distance of 4 m between them. Also, the point A is 3 m below the surface and at horizontal distance of 2.5 m from the second line load.