In an ideal Rankine cycle the boiler pressure is 10 MPa. All components are operating at steady state and adiabatically. The steam enters the turbine at 550oC. The condenser pressure is 15 kPa. Determine the cycle efficiency. Find the entropy generation for the condenser for 6 kg/min mass flow rate of steam.   This is a Thermodynamics question. Please explain all steps and write nicely. Thanks.

Q: In a lenoir cycle, helium is taken in at 87 K with a pressure ratio of 7.73. The ratio of the volume…

A: Inlet temperature,T1=87 K The pressure ratio,(rp)=7.73 The volume ratio,V3V1=2.46 For helium,…

Q: The pump in the Rankine cycle increases the pressure from 20 kPa to 6 MPa. The boiler exit…

A: P1 = 20 kPaP2 = 6 MPa or 6000 kPaBoiler exit temperature, T = 600°CRequired:Q ( heat supplied to…

Q: Open feed water heater in the power plant operating according to the Rankine cycle with ideal…

A: Open feed water Rankine Cycle,

Q: The Stirling cycle, shown in the figure, is useful to describe external combustion engines as well…

A: To find: The efficiency of the cycle in terms of the parameter shown and the compare the efficiency…

Q: Steam at 10 MPaa, 550 degrees Celsius enters an ideal enginethat has one stage of regenerative…

A: The cycle diagram and state points are attached here.

Q: In a lenoir cycle, helium is taken in at 53 K with a pressure ratio of 12.47. The ratio of the…

A: The initial temperature at point 1 is T1=53 K The pressure ratio is rp=12.47 The ratio of volume is…

Q: WATER IS USED AS THE WORKING FLUID IN AN IDEAL RANKINE CYCLE STEAM ENTERS THE TURBINE AT 20MPA AND…

A: given; →net workoutput(wnet)=?→heat transfer in steam generator (Q1)=?→thermal efficiency (η)=?→heat…

Q: In an ideal steam cycle, steam at (20 bar, 360 C°) is expanded in a turbine to (0.08 bar). It then…

A:

Q: 2.3 A. Calculate the thermal efficiency of a Rankine cycle in which the steam is initially dry…

A:

Q: In a Steam Power Plant steam enters the turbine at 6 bar and 400 C and is expanded isentropic ally…

A: Answer: (a) Condition of steam : Mixture of saturated water and saturated vapor with dryness…

Q: A power plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600oC in the boiler. It…

A:

Q: 4. A steam power plant that operates on a simple ideal Rankine cycle, the boiler pressure is 2 MPa…

A:

Q: find the thermal efficiency of the cycle and the mass flow of water vapor circulating in the cycle.

A: Given: Steam power plant Power=300 MW P3=10 MPa T3=500oC P4=10 kPa To determine: the thermal…

Q: A Rankine cycle with superheat and reheat has steam entering the turbine at 15 MP a and 500C. The…

A:

Q: A steam power plants operates between a boiler pressure of 40 bar and a condenser pressure of 0.04…

A:

Q: the pump works, calculate: A. The mass of steam bled from the turbine per Kg of steam leaving the…

A:

Q: steam power plant saturated steam at 50 bar enters the turbine and leaves at 1 bar. Show by…

A:

Q: A power plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600oC in the boiler. It…

A: Given dataP=3MPaT=600°CQ=10MWPs=500kPaTs=45°C Here we using the steam table with respect to the…

Q: Complete and legible solution please; The condensing pressure for a Rankine engine is 1 bar.…

A: Given:Pc=1 barPe=50 bar

Q: 1. Steam at 14 Mpa and 700°C is received by a regenerative cycle. Before condensation at 70 kPa,…

A: Given that: Turbine inlet conditions are: 14 Mpa and 700°C Condenser is at 70 kPa Feed water heater…

Q: Steam is admitted in a Rankine engine at 3280 kpa, 500 °C and is exhausted at 328 kpa (saturated).…

A:

Q: 2. Steam at 4 Mpa and 400°C is received by a regenerative cycle. Before condensation at 0.005 Mpa,…

A: The T-s diagram of the system is

Q: 2.1 Sketch a carefully drawn temperature-entropy diagram of a Camot cycle. Explain as many features…

A: Given data To sketch the T-S diagram of carnot cycle.

Q: A simple Rankine cycle works betw een pressures 43 bar and 10 Kpa, the initial condition of steam…

A:

Q: A reheat steam cycle has 13,580 kPa of throttle pressure at the turbine inlet and a 37.50308414 atm…

A: Given data: Cycle : Reheat steam cycleThrottle Pressure = 13580 kPaReheat Pressure = 37.50308414…

Q: A reheat cycle with two stages of reheating is executed, with steam expanding initially from 90 bar…

A: given that: For the two stage reheat cycle, steam expanding initially from 90 bar and 530C two…

Q: Considering that the change in enthalpy at the first stage of a Reheat Rankine Cycle  is 450 BTU/lb…

A:

Q: Draw the T-s diagram and Plant Lay-Out A steam power plant has a steam generator (boiler) exit at 4…

A:

Q: Compute the thermal efficiency of an ideal Rankine cycle for which steam leaves the boiler as…

A:

Q: 5.) An ideal Reheat Cycle has a turbine inlet pressure of 10 MPa wi steam temperature of 400C. The…

A:

Q: A turbine is supplied with steam at 25 BAR, 42C and exhaust into a condenser at 55 KPa. Find the…

A: Given data as per the question turbine inlet pressure =25 barturbine inlet temperature…

Q: A reheat steam cycle has 13500 kPa throttle pressure at the turbine inlet and 2800 kPa reheat…

A:

Q: 3. A reheat steam cycle has 13,580 kPa of throttle pressure at the turbine inlet and 37.50308414 atm…

A:

Q: Find the boiler heat transfer including the reheat process (kW)

A: