In an equimolar counter diffusion of A in B, the bulk concentration and the flux of A were measured to be 0.002 kmol/m³ and 0.08 kmol/hr.m², respectively. Given the total pressure of the system, P = 1.5 bar; the temperature, T=250°C; and the diffusion coefficient at 1 bar and 100°C, DAB = 0.16 cm³/s, caleulate: i- The thickness of the film where the diffusion of A occurs ii- The mass transfer coefficients, k, and k', iii- The concentration of A halfway the gas film

Q: Two bulbs are connected by a straight tube, 0.001 m in diameter and 0.15 m in length. Initially the…

A:

Q: Q2// A tube of 1 cm inside diameter and 20 cm long is filled with N2(A) and CO (B) gases at a total…

A: Step1     given data:-    →tube inside diameter =1cm    →length of tube=20cm    →Total pressure…

Q: Mass Transfer Coefficient

A:

Q: A cylindrical tube connects two large gas tanks (Tank-1 and 2). Both tanks contain mixture of carbon…

A: Given: The partial pressure of the first tank, The partial pressure of the second tank, The length…

Q: • 18. The activation energy for Al in a Cu solvent is 1.6 x 10° J/kmol. What is the diffusion…

A:

Q: Based on chemical equilibrium, obtain a general expression for dependenceof the partition…

A:

Q: Determination of mass transfer coefficient by relating mass transfer coefficients and diffusion…

A: Mass transfer coefficient of oxygen at 200C = 0.0045 m/s Diffusivity of benzene at 20 0C = 1.02×10–9…

Q: Q1: The absorption of ammonia from a mixture of ammonia and air containing 10% of ammonia by volume,…

A:

Q: Question: Calculate the osmotic pressure of 5% solution of urea 100 ml at 273 K.

A: Given thatVolume ,V  = 100 ml T = 273 k 5 % solution of urea

Q: • Gases A and B are diffusing towards each other at steady state by equimolar counter diffusion…

A: The case is diffusion through variable cross section area. The flux would change but rate of mass…

Q: 11.25 In a process producing KNO; salt, 1000 kg/h of a feed solution containing 10% KNO, is fed to…

A: Given: F = 1000 kg/h ; xF = 0.1 ; xE = 0.5 ; xC = 0.95 ; xR = 0.35 ;C= 0

Q: Find the height of a packed tower that uses air to strip hydrogen sulfide out of a water stream…

A: Given:Liquid flow rate                           Water stream contains 0.2%  Liquid out contains Air…

Q: 20 kg each of substances A and B are dissolved in 60 kg of water. The solubility of A is 1.5 kg per…

A: Given, Mass of substance A, mA = 20 kg Mass of substance B, mB = 20 kg Mass of water, mw = 60 kg…

Q: For the percolation theory – based equation derived for the fixed-bed adsorption, as shown below,…

A: The given adsorption equation is  ∂q⏜∂t=k(q*-q⏜)=kK(c-c*)

Q: Estimate the diffusivity of acetic acid diffusing through air at 298 K at 2 atm using the Fuller-…

A:

Q: irreversible homogeneous reaction

A:

Q: Estimation of a Gas Diffusivity.Estimate the diffusion coefficient for oxygen (A)/benzene (B) at…

A: The diffusion coefficient for the given oxygen-benzene mixture is to be calculated.

Q: Show that [B], = a +º satisfy the diffusion equation when the concentration of a2[B]r 2 a[B]r…

A: Given that, Concentration Br = a + br The concentration of diffusion molecules is independent of…

Q: An evaporator is concentrating solutions coming from three different sources. The first source…

A:

Q: The process by which the supernatant liquid is poured out leaving the precipitate in the container…

A: The substances that we see around us aren't in their purest forms. They are basically the mixture of…

Q: A steady-state continuous distillation column is used to purify alcohol from a combination of water…

A: a. Azeotrope: it is a mixture of two or more liquids which has a proportion which doesnot change…

Q: A rough rule of thumb in polymer solution theory is that a 4 molar aqueous polymer solution will…

A:

Q: The diffusion coefficient, D  (m2/s) of Zn in Cu at 500 oC

A: Given that  T = 500 C = 500 +273.15 =773.15 k we have to find diffusion coefficient ,D of Zn in cu…

Q: Estimation of Liquid Diffusivity. It is desired to predict the diffusion coefficient of dilute…

A: Given that- Solution of dilute acetic acid in water at, T1=282.9 K T2=298 K  As per Wilke-Chang…

Q: Consider the case in which liquid A evaporates and diffuses through stagnant gas B. The process is…

A:

Q: 3. Find the height of a packed tower that uses air to strip hydrogen sulfide out of a water stream…

A:

Q: A cylindrical tube connects two large gas tanks (Tank-1 and 2). Both tanks contain mixture of carbon…

A: Given Data  The cylindrical tube connects two large tanks (Tank 1 and 2). The tanks contain CO2 and…

Q: A viscous liquid sweetener contains 80% (w/w) aqueous solution of sugar (90% glucose, 10% sucrose).…

A: Take the basis for the calculation as 100 g of the solution. Mass of water in the solution, mW =…

Q: Determine the binary diffusion coefficient of H2 in air a.) at 400 K and 0.8 atm in m2/s. b.) at 600…

A:

Q: What is the magnitude of Dat 1100°C?

A:

Q: A 1 cm diameter, thin-walled tube carries liquid metal through saturated water at one atmosphere.…

A: Given: Tube diameter is 1 cm (0.01 m) Radius (R) is 0.005 m Metal temperature is 250°C Heat transfer…

Q: A semipermeable membrane separates two aqueous solutions at 20 °C. For each of the cases, determine…

A: A semipermeable membrane, also termed a selectively permeable membrane, a partially permeable…

Q: In this type of Fickian diffusion, the diffusing species is moving through a "stagnant" bed of…

A: Unsteady-state Diffusion- it is the rate of diffusion which is also a function of time unlike steady…

Q: The following diffusion coefficients are are obtained from an experimental setup. The data is fitted…

A: given that diffusion coefficient are obtained from  experiment  data of DExperimental and DModel are…

Q: .The following diffusion coefficients are are obtained from an experimental setup. The data is…

A:

Hazard Analysis and Design in Chemical Engineering

Hazard is the intrinsic property of a material or process which harms the people, buildings, or environment. Health, safety, hazard, risk assessment, loss prevention, and environmental consideration play an important role while designing a chemical processing plant. Hazard is often confused with risk. Risk measures the magnitude of loss and injury of likelihood incidents or the consequence and frequency of incidents.