In a vertical gate of a small dam there is a window at a distance a per below the surface of the liquid contained in the dam, of density p0. This window holds equilateral triangle shape with side L, as shown in figure 2. Nivel de referencia Figura 2. Compaerta de reprena con una ventana inguar From the information above: If you wanted to add a second triangular window to the gate, where should the gate be positioned so that it is under the same hydrostatic force as the first triangular window?

In a vertical gate of a small dam there is a window at a distance a per below the surface of the liquid contained in the dam, of density p0. This window holds equilateral triangle shape with side L, as shown in figure 2. Nivel de referencia Figura 2. Compaerta de reprena con una ventana inguar From the information above: If you wanted to add a second triangular window to the gate, where should the gate be positioned so that it is under the same hydrostatic force as the first triangular window?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Below are incomplete views of the parts or figures. Complete them by drawing the lines of correspondence (matching strokes) between views.
Draw the the following views of the figure. Thank you.
Question 3) The length L is given as L=34 m on the plate in the figure. According to this;Question 3-A) Find the X coordinate of the geometric center of the plate. (Enter your result without writing m units. Write at least three digits after the comma.)Question 3-B) Find the Y coordinate of the geometric center of the plate. (Enter your result without writing m units. Write at least three digits after the comma.)
DRAW THE ISOMETRIC FIGURES OF THE ORTHOGRAPHIC DRAWINGS BELOW.ADD DIMENSIONS AND LEADERS
can you write step clearly
A hole is to be drilled as shown by the circle. Using the part geometry shown below, indicate on the part sketch where locator(s) should be positioned according to the 3-2-1 principle. Use dashed lines to indicate locators on hidden surfaces. Also indicate where clamping force(s) should be applied using arrows. Use the minimum number of clamping forces.
Typewritten for an upvote. No upvote for handwritten. Please skip if you have already done this. Thank you
The control knob of a window air-conditioning unit has four settings. The knobis turned from the OFF position to the HI COOL position. Find the number ofdegrees through which the knob is turned. Round the answer to the nearerwhole degree.
What is the resulting angle in radian with 2 decimal places if the complex number is 1+3 j