In a rolling mill, the rollers can exert a pressure of 219 MPa on the sheet being rolled. If the friction coefficient between the roller and the sheet metal is 0.35 and the flow stress of the steel being rolled is 120 MPa, what diameter rolls would reduce the thickness of 2mm thick sheet by 25% in a single pass?

Q: Von mises and tresca agree in pure shear

A: In machine design, mainly five failure theories are used to relate stress with the strength of…

Q: A 300-mm-wide strip 25-mm thick is fed through a rolling mill with two powered rolls each of radius…

A: The answer has been attached in the form of images as follows:

Q: is recreating rolling The large stone columns by animal power and pivot points cut into the center…

A: (a) Draw a free-body diagram of stone column.

Q: As James orbits, he slams into a space elevator, peals himself off, and gets in. On the way down, he…

A: Write down the given values using suitable variables. Here L signifies leg length, m signifies leg…

Q: What is the force required to punch a 20-mm diameter hole in a plate that is 25 mm thick? Shear…

A:

Q: required at the moment of reaching the yield point (ℇ = 0.002) b) Force required when you have a…

A:

Q: 1) Drawing: Consider a cylindrical rod fabricated from a linear strain hardening material with a…

A: Given:The constitutive relationship is .The original diameter of the rod is .For completely elastic…

Q: The force required to punch a 25 mm hole in mild steel plate 10 mm thick, when ultimate shear stress…

A:

Q: entry angle = 15o. The starting diameter is 0.100 in. And the final diameter = 0.080 in. The…

A: first of all find out tru strain and then mean flow stress from given data.refer below image.

Q: A cold rolling operation is to be used to reduce a 50 mm thick and 200 mm wide copper plate. The…

A: given; initial thickness(h1)=50mminitial width(w1)=200mmentry velocity(v1)=15m/minexi…

Q: A tube of 12 mm external diameter and 1mm thickness is to be reduced to 16 mm external diameter and…

A:

Q: A punch must cut a hole of 30 mm diameter in a sheet of metal  with 2 mm thick. The ultimate shear…

A: Given that ,  d=30mmτ=55MPat=2mm

Q: 2. Plane Strain. A brick has the following initial dimensions: 400 mm deep, 25 mm high, and 100 mm…

A: Disclaimer from Bartleby:Hello. Since your question has multiple sub-parts, we will solve the first…

Q: A long, copper strip, 500 mm wide, 3 mm thick, was found to have 450 MPa yield stress. The strip is…

A: The width of the strip, b = 500 mmThe thickness of strip, t = 3 mmThe yield strength, σ = 450 MPaThe…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.