In a given parallel plate capacitor with a capacitance of "C" Farad, if the distance between the plates is increased by 3 times and Area of the plates is increased by 12 times then the new value of the capacitance = Farad. O 36.00"C O 4.00°C O 0.03"C O 0.62*C

Q: BJT vs FET

A: Following are the points of difference between BJT and FET: BJT stands for Bipolar Junction…

Q: Given a series circuit comprised of the following element: 68.13-ohm resistor, practical inductor…

A:

Q: Define Ohmic region of FET characteristics and Write down the relation between VGS and ID?

A:

Q: 3)- a)- What are the differences between doping and alloying? b)- What is the importance of lattice…

A: Here I have solved it.

Q: Which one of the following needs less repair than other resources? a. Wind O b. OTEC O c. Hydro…

A: Among all the renewable energy sources hydro power plant needs less repair so option c is correct…

Q: Name the following figure

A:

Q: results in poor voltage regulation. Select one: O a. High Power O b. High Power factor O C. Low…

A: As the electrical circuit draws current, voltage drop starts to occur in the elements. Voltage…

Q: What is the difference between MCB and ELCB? Give one example each for Radial and Ring Circuit?…

A: In this question we will write difference  about MCB and ELCB ...Also example of ring and radial…

Q: The voltage regulation can be equal to zero when: O The t and current is not too high. OThe p.f. is…

A:

Q: What is the value of frequency of dc

A: The number of times a repeated event occurs per unit of time is known as frequency.  It's also…

Q: Define power factor and describe the characteristic of current and voltage in capacitive circuit.…

A:

Q: What is the relative permitivity of the insulator used in a capacitor given that a copper resistor…

A: Specific resistivity of copper= 1.7x10-8 ohm-meter total resistance R=136 milliohms capacitor rating…

Q: Kirchhoff's voltage law states that in any junction point sum of all voltage raise and voltage drops…

A: The explanation for Kirchoff's Voltage Law is as follows.

Q: 4)-What is HRC Fuse : Working & Its Applications. please answer not by hand

A: HRC Fuse: High rupturing capacity fuse or HRC fuse are fuses that carry a short circuit current for…

Q: Q22. Define the crest factor of a current waveform and explain why it is important for the rating of…

A:

Q: Given a series circuit comprised of the following element: 68.13-ohm resistor, practical inductor…

A:

Q: solar cells short circuit current, Isc-5A and open circuit voltage, vo.c.-D0.6. * The power…

A: power of solar cell= P= Voc * Isc P= 0.6 * 5 P= 3 watt

Q: ............................................................is a circuit which carries power from…

A: Feeder to consumer

Q: 1)an instrument that graphically displays measurements of Voltage value, frequency and phase…

A: According to our guidelines, we can answer only one question at a time. Kindly, respost the question…

Q: Q22. Define the crest factor of a current waveform and explain why it is important for the rating of…

A: Crest factor is a parameter of a wave or AC current is the ratio of peak values to the effective…

Q: Plot x[J and xBn-3]

A:

Q: QUESTION-4 aN-Pleas Please answer the following: a)awiwn) What are the causes of impulse voltages?…

A:

Q: Discuss the significance  current limiting reactor in power system

A: A current limiting reactor consists of a large inductance compared to its ohmic resistance

Q: Q8) Consider a source with three symbols of probabilities 0.5, 0.4 and 0.1. Obtain the Fano code and…

A: We need to find code words and efficiency for given probability .

Q: A transistor is used as a switch and the waveforms are shown below. The parameters are given as…

A: Given  Transistor as switch and waveforms as shown  Vcc=200 vVCE(sat)=1 vICS=100 AICEO=1 mArise time…

Q: Identify the right statement relating to Zener impedance a. O b. O c. O d. the ratio of change of…

A:

Q: Determine the factors to be taken into consideration in designing current sources.

A:

Q: Draw a circuit which exhibits terminal characteristics as shown in picture .

A: The given V-I characteristics can be obtained from following circuits, where a resistor (R) is…

Q: Give examples of power ratings for home appliances and electronics.

A: Power Ratings:- The power rating of equipment in mechanical and electrical engineering refers to…

Q: use the above transistor characteristic for the following circuit to a. Draw the load line b.…

A: The required parameters can be calculated by using the DC analysis of the fixed biased amplifier…

Q: What is the radius of a copper cable having resistance of 10 ohm and length of 10 km. Assume the…

A: Given data, R=10 ΩL=10 kmρ=1.7×10-8 Ωm

Q: Mention Factors determining the size and the direction of the generated emf

A: Factors determining the size and the direction of the generated emf are follows-

Q: four parts are selected randomly and without replacement, what is the probability they are all from…

A: Here it is asked to find the probability with the informations given. Here properties of probability…

Q: What is the effective value of 200 volts peak-to-peak? A. 70.7 V. B. 141.4 V. C. 14.14 V. D. 707.0…

A: In this question we need to find the effective value of 200 V peak to peak

Q: The baud rate of 2ASK is ____________________ than baud rate of 4ASK. Select one: a. less b. high…

A: Baud Rate = Bit Rate / n    RS = RB / n  n = Log2( N )     Given  N1= 2 N2 =4

Q: Can you throw the emergency solution? I would appreciate it if you write legibly.

A:

Q: do number 13.5

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.