-In 8086 microprocessor whenever the pop D instruction is executed two data bytes of the top of the stack are transfer to PC. two data bytes at the top of the stack are transferred to the HL pair. two data bytes from HL registers that were previously stored on the stack are transferred back to the HL pair.

-In 8086 microprocessor whenever the pop D instruction is executed two data bytes of the top of the stack are transfer to PC. two data bytes at the top of the stack are transferred to the HL pair. two data bytes from HL registers that were previously stored on the stack are transferred back to the HL pair.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

02 (a) How many bits do the registers of the 8086 processor have and which registers can be split into halves and accessed separately? (b) Explain the purpose of segmenting memory" How is 20-bit memory address accessed by the processor? For a logical address (c) of OFS7:0552H. calculate the physical address and show the steps.
7. Draw a logic diagram for a 5-bit ring counter has an initial state 01011 and determine the waveform for each Q output during 5 clock pulses.
Briefly answer the following questions: a) List at least 5 SFRs in PIC18F87J11. b) Given an instruction example for each addressing mode in PIC18F87J11. c) Describe and draw the memory architecture for PIC18F87J11
i need the answer quickly
What is the function of the one-bit half adder? Exactly how many inputs and outputs are there overall? What logic gates were used in the creation of it?
State the difference between type BIT and type STD_LOGIC. Why does STD_LOGIC have so many values?
1- Identify the addressing mode for: MOV Cx, [SI] 2- The instruction that adds immediate datalcontents of memory location specified in an instruction/register to the contents of another register/memory location is a. SUB b. ADD c. MUL Share Content Participants