Immediately outside a conducting sphere of unknown charge Q and radius R the electric potential is 220 V, and 10.0 cm further from the sphere, the potential is 110 V. (a) Determine the radius R of the sphere (in cm). cm (b) Determine the charge Q on the sphere (in nC). nC (c) The electric potential immediately outside another charged conducting sphere is 230 V, and 10.0 cm farther from the center the magnitude of the electric field is 440 V/m. Determine the radius (in cm) of any sphere for which this is possible. (Enter your answers from smallest to largest. If only one value exists, enter "NONE" in the second answer blank.) R, = cm R, = cm (d) Deternmine the charge on the sphere (in nC) for each value of R. (If only one value exists, enter "NONE" in the second answer blank.) 91 = nC 92 = nc

Immediately outside a conducting sphere of unknown charge Q and radius R the electric potential is 220 V, and 10.0 cm further from the sphere, the potential is 110 V. (a) Determine the radius R of the sphere (in cm). cm (b) Determine the charge Q on the sphere (in nC). nC (c) The electric potential immediately outside another charged conducting sphere is 230 V, and 10.0 cm farther from the center the magnitude of the electric field is 440 V/m. Determine the radius (in cm) of any sphere for which this is possible. (Enter your answers from smallest to largest. If only one value exists, enter "NONE" in the second answer blank.) R, = cm R, = cm (d) Deternmine the charge on the sphere (in nC) for each value of R. (If only one value exists, enter "NONE" in the second answer blank.) 91 = nC 92 = nc

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

3- A positive charge q is uniformly distributed over the area of a disk, of radius R, placed horizontally on the x-y plane as shown in the figure. a) Find an expression for the charge density o. b) Find an expression for the electric potential at a point P on the axis passing through the center of the disk and at a distance z from its center. c) Check that your formula is consistent with what you would expect for the case when z →± ∞ R dr 10 r √² + z² Hint: Divide the disk into ring shaped elements, each of area da = 2ër dr, then integrate over r (from r=0 till r=R).
What is the magnitude of the electric field at the point (4.00 î - 9.00 ĵ + 3.90 k̂) m if the electric potential is given by V = 3.20xyz2, where V is in volts and x, y, and z are in meters?
A solid metal sphere has a charge of -80μC and radius of 0.75 m. What is the electric field and absolute electric potential at different distances, r, from the center of the sphere? The + direction is away from the sphere. Include a sketch of the electric force vectors you use to set up your equations
The electric potential on the surface of a charged conducting sphere is 210 V, and 10.0 cm farther from the center of the sphere the potential is 140 V. (a) Determine the radius of the sphere. HINT: Use a ratio of the two given potentials to solve for the radius. 20 cm (b) Determine the charge on the sphere. 4.67 nC The electric potential on the surface of another charged conducting sphere is 240 V, and 10.0 cm farther from the center the magnitude of the electric field is 410 V/m. (c) Determine all possible values for the radius of the sphere. (Enter your answers from smallest to largest. If only one value exists, enter "NONE" in the second answer blank.) HINT: Use the ratio of the potential at the surface to the E field at the surface plus 10.0 cm to solve for the radii. cm r2 = cm (d) Determine the charge on the sphere for each value of r. (If only one value exists, enter "NONE" in the second answer blank.) 91 = nC 92 =
The electric field due to a very long straight and uniformly charged wire is given by the following expression: E = , where E is in N/C and r is the radial distance 2.0 from the wire (in meters). The radius of the wire is R = 0.005 m. a. Determine the magnitude (absolute value) of the electric potential difference between two points at the radial distances from the wire: r, = 0.20 m and r, = 0.40 m.
The electric potential of a dipole is E= KQd/((d/2)2+a2))3/2 Find the electric potential V by integrating the elctric field
The figure shows two points A and B in a uniform electric field of magnitude 1200 N/C. A• 7.0 cm (a) The electric potential at A is –12 V. Find the electric potential at B. -6 g from point A at 13 m/s. The particle passes through point B (b) You launch a charged particle of mass 1.5 × 10 3.7 ms later. Find the particle's charge. 3.0cm
x = 12.0 cm y = 4.00 cm 1. To calculate the potential energy of the system of the three point-charge system, the appropriate equation to use is 2. Calculate the potential energy of the system of the three point-charge system. 3. To calculate the electric potential at the upper right corner of the rectangle in the Figure, the appropriate equation to use is 4. Calculate the electric potential at the upper right corner of the rectangle (the corner without a charge
In the image given there are 3 charges along the y axis. it is your job to find an expression for electric potential at point P when : d <
The electrical potential values determined at points A, B, C and D in the figure are 5.53 V, 5.55 V, 5.56 V and 5.60 V, respectively. Points A, B, C and D are at the corners of a square with a side length of 0.002 m. a)Calculate the vector of electric field at point A . b)Calculate the vector of electric field at point B. c)Calculate the vector of electric field at points A and B.
1.25 points An electric field in a region of space is parallel to the x- axis. The electric potential varies with position as shown in the figure. Find the magnitude of the electric field (in kV/m) at x-2.5 cm. 50 40 30 20 10 x (cm) -10 -20 -30 -40 -50 ३ दि २०१३३३६
Problem I: Two positive charges of the same magnitude +q are placed on the x-axis at x = -1.00 m and x = +1.00 m. %3D a) Draw a sketch of the svstem showing the electric field lines and the points in space where the electric field is zero. b) Sketch a graph for the total electric potential versus x for -2.00m < x < 2.00m. v (V) 200 100 x (m) -1 -100 -200